QUICK INSTALLATION GUIDE
Analog Operation
If an analog monitor (eg. IBM V A or NEC MulitSync monitor) is
connected to the Qtec V A1024 board through 15 analog connector.
Please do the followings:
a. Set all 4 switches of the dip-switch to OFF position (OFF OFF
OFF OFF). This should have been pre-set from the factory.
b. Set Jumper 1 (JP1) to connect the two lower pins and Jumper 2
(JP2) to connect the top 2 pins. This should have been
pre-set from the factory.
c. Switch off your PC and plug the Qtec V A1024 board into any of
your 8-bit or 16-bit slot.
This is all you need to do to run any V A software.
Digital Operation
When only the digital monitor is used with the Qtec V A1024 board
(the 15-pin analog connector is not connected), please consult
dip-switch and jumper settings section of this manual.
Remark:
1. Analog sensing
When your PC power is turned-on, your Qtec V A1024 board will
sense if its 15-pin analog connector is active (connected).
If yes, the Qtec V A1024’ board will set itself to V A mode
regardless of its dip-switch setting.
To run 800x600 and 1024x768, please make sure that all 4
switches of the dip-switch is set to OFF position.
2. Software Mode Switching
For software mode switching, please use DMODE utility program
to switch modes (V A, E A, C A, MDA or Hercules). Please note
that the adapter's current mode will not be re-set by
warm-booting (Ctrl-Alt-Del) the PC. This is a planned
function for users' convenience. To switch modes, please use
DMODE utility or turn-off the PC.
-1-
