TRYSIGHT Mercury 12 Manuel utilisateur
Congratulations on the purchase of your Mercury 12 unit. Please read the manual
fully before using. Mercury 12 is an advanced tablet based magnifier with highly
accurate reading capabilities, allowing you to listen to printed material in a clear
natural sounding voice. The latest version of this manual is available on our
website at www.trysight.com
Enclosed Parts:
1 Charger
1 User Manual
1 Mercury 12 tablet with stand
1 Bluetooth Keyboard
1 Bluetooth mouse
1 Micro-USB to USB LED Charging Cable
1 Carry Case
OPENING THE STAND
Mercury 12 incorporates a stand which holds the tablet. There is a handle on the
stand to carry the unit. To open the stand, pull the base plate and the top plate
apart on the side opposite the handle as shown below. This will unveil the tablet
screen. The tablet screen can then be angled at a comfortable angle.
POWER ON/OFF
The power button is located on the bottom right of the tablet and is smaller than
the volume button located right next to it.
Hold down the Power button for 3 seconds to start the unit. After about 30
seconds the unit should boot up. If the unit doesn't start, the likely cause is the
battery is not charged. To charge the battery, plug in the power adapter to an
electrical outlet and use the provided magnetic connector cable to connect the
device to the charger. The charging cable must be connected with the magnetic
connector port on the tablet (On the left side when the tablet is on the stand).
After charging for 30 minutes the unit should have sufficient power to start.
However, to fully charge the unit it will take 3-4 hours.
Ejecting from Stand
To eject the tablet from the stand slightly press down the bracket on the top right
plate of the stand and gently slide the tablet out of the stand. To insert the tablet
in the stand first slide down the bracket on the top right corner plate of the stand
and gently slide the tablet into the stand. The bracket helps to prevent tablet from
sliding out accidently. While inserting the tablet back onto the stand, ensure that
the power button is on the bottom right. If it’s on the top left it means the tablet
has been inserted upside down and the tablet camera will not line up with the
respective camera hole on the stand.
QUICK ON/OFF
To enable quick on/off functionality, the unit can go into "Sleep" mode. The unit
can wake up instantly from sleep mode in 2 seconds. However, Sleep mode uses a
small amount of battery as the unit is not completely turned off. After about 2
weeks in sleep mode, the battery will drain out and will need recharging even if
you don't use the unit. To put the unit to sleep, tap the Power button quickly
(Don't hold it down). To wake it up, tap the power button again.
USE AS A WINDOWS MACHINE
The unit is a full-fledged Windows machine and can be used as such. All Windows
applications will run normally and the machine can be used as your laptop. If you
remove the tablet from the stand, a hinge on the back of the tablet allows a plate
to come out of the body and hold the screen upright at an angle of your choice.
A wireless keyboard/mouse (included) is the preferred method of using the
Mercury 12 as a Windows machine. This allows use of the device as a laptop
without having to repeatedly remove it from the stand.
LED Light
The LED Flash light is built separately in to the stand to provide better image
quality. It is located behind the tablet. There is a switch on the right side of the
LED. It has 3 possible positions
1) On - LED Permanently On
2) Off - LED Permanently Off
3) Auto - LED automatically turns on when motion is detected. It turns off after
25 seconds of inactivity. The motion sensor may not work near sunlight. In
such cases, use the Permanent On option to turn the LED on.
To charge the LED, use the provided Micro-USB to USB cable. Connect one end to
the tablet and the other end to the charging port of the light present on the left
side of the stand as shown below:
Mouse and Keyboard
The keyboard and mouse are connected by Bluetooth. For personalization go to
settings and under Bluetooth devices, each can be removed and paired to the
tablet. The devices are paired at the factory and this step is only necessary should
the pairing be lost inadvertently. The keyboard and mouse have buttons on the
bottom to enable pairing. Turn on the keyboard using the On/Off switch at the
bottom, then tap on any of its keys to connect to the tablet. Subsequent
keystrokes will be sent to the tablet. Similarly, the mouse needs a click to connect
to the tablet.
MAGNIFICATION MODE
Pull the tablet forwards so the arms on the stand are at a 45 degree angle. Then
angle the tablet so you can comfortably see it as shown below.
Position your document on the base plate and start the magnifier application by
selecting the “ReadDesk TE” icon on the desktop.
Live Magnification
The software starts in Live Magnification mode. Clicking or tapping a small arrow
on the top allows the opening of a menu bar which has various magnification
options as shown in images below.
Autres manuels pour Mercury 12
1
Table des matières
Autres manuels TRYSIGHT Loupe
