7/ 11
3. Operating Process
Start up: Clicking the button (switch) on the panel after connected to the power
and water supply correctly, the machine will on. During the whole operating
process, it will work automatically.(Note: Please turn off the power supply in case
of thunderstorm or long time not in use.)
Pre-cooling: After power on, the water inlet valve will turn on automatically, the
evaporator pre-cools for 30 seconds before the water pump starts up, meanwhile the
compressor starts, the water pump stops running, the water inlet valve continues to
take in water till the specified level (that is to say water floating ball switch stops
water inlet).
Ice making: After pre-cooling for 30 seconds, the water pump starts up, continuous
water flows smoothly and ice comes into being gradually in ice try of the
evaporator.
Ice falling: After reaching the stipulated ice making time, the water pump shuts
down, the defrost valve powers on and open, and hot air enters into the evaporator,
at the same time the drain valve closes after 30 seconds. The water inlet valve open,
the whole sheet of ice will slide from the evaporator into the storage refrigerator
after defrosting for 1～2minutes. During the process of ice falling, hands should
be away from the storage refrigerator to avoid being hit by it !
Shutdown: When the machine runs, clicking the button(switch) on the panel and
the machine stops working.
Automatic Stop When Ice is Full: In the running, with the accumulation of ice in
the ice bin, it will reach to a certain height and block other ice fall down .Eventually
the full of ice result in sliding board cannot be rebounded and reset. After machine
detected it for a few time (30 seconds or so) and confirmed ice bin is full of ice , the
machine will stop working automatically. Until removed full of ice ,the sliding
board will be rebounded and reset again ,then machine will work automatically
again.
Ice thickness adjustment: There are two methods to adjust the ice thickness.
Please choose one according to the machine.
Method I, In the process of ice making,
the adjusting screw on the ice thickness
detector can be rotated left or right according to
the actual condition and the attached adjustment
instruction labeling if the ice thickness isn't
satisfactory, and tightens the screw after the
adjustment is completed.
Note: The adjustment shall be limited to
a circle each time.
Ice Machine Installation and Maintenance Instructions
Ice Thickness Adjusting Screw
