Trimline ObsidianInstallation instructions
1 GENERAL INSTRUCTIONS
NOTE
The installation may only be carried out by an authorised
person.
•The appliance must be installed, connected, inspected
according to local standards and regulations.
•
roof face must also meet the requirements outlined in
•The temperature of the walls near the side and back of
of 80 °C.
•The appliance has been approved in combination with
with European CE standards for gas appliances, and may
therefore only be applied with this system.
•
gas distribution (gas type and gas pressure) as indicated
•The instructions are only applicable if the relevant country
code is stated on the appliance.
•
used. The gas supply pipes therefore need to be vented
•Ignite the appliance according to the user manual and check
must be removed from the glass panel using a glass cleaner
Distance to ammable materials
Maintain the following minimum distances from combustible
materials: front 500mm, side 500mm, top 1,200mm to
curtains, fabrics and/or combustible material. The appliance
Distance to non-ammable materials
materials.
WARNING
•
appliance, the glass panel surface is considered to be an
active zone. The glass panel surface can become very hot.
•
children and those requiring help away from the immediate
2 PLACING THE APPLIANCE
NOTE
Before installing the appliance, please read Chapter
8Concentric ue system.
Option
First read Chapter 11 Fitting the led glow bed module
(option) or Chapter 12 Install rear wall (option) if you want
2.1 Preparation and installation
•Check the packaging for damage. Remove the packaging
and check the contents are intact and complete. Report
damage and defects to the supplier immediately.
•The packaging contains the following components:
- Appliance
- Remote control
- Ceramic wood set
- Dispersion medium
(glass granules and
coal embers)
- Restrictor(s)
-
-
- Suction cup
- Installation instruction
- User Manual
- Plinth
- Wide trims packed
separately
3/8” connection point
