Trimline 64 Front/Panoramic/Corner DBInstallation instructions 4
•
1 2 3
•
•
below the ceiling. If the space between the grille and the top
of the ceiling in the chimney is very high, it is recommended
that a false ceiling made of refractory material be installed
in the chimney.
2.2 Connection to the gas supply pipes
•Remove the protective bracket under the appliance
complete with gas valve (remove the tie straps) and secure
found inside.
•Take account of the power supply: batteries or
•You can determine where the gas supply pipes will be
placed, dependent on the layout. Ensure control equipment
tension. Accessibility of various connection points in relation
to components needs to be maintained. After installation,
a connector. Also ensure the gas supply pipe is free from dirt
or sand. To prevent damage to the gas control equipment,
•
Check all the gas connections for leaks again. You can then
switch the appliance off and put the ceramic wood set in
place (see Chapter 3 Installation of the ceramic wood set
and dispersion medium).
NOTE
•
do not look good, repeat the previous steps again while
checking and correcting if necessary.
•
13 Cleaning and maintenance).
2.3 Installation methods
Depending on the desired set-up, you can decide to work with
the glass panes of the appliance.
Applying the wide trims 1
•The standing trims have an adjustable magnet attachment
at the bottom. Pull the wide trim forward at the bottom and
unhook it at the top.
•Push the lower trim forward and then remove it.
•The unit can be built in, taking into account the correct
dimensions of the conversion in such a way that the wide
problems.
•
If the installation is too tight, less than 4mm clearance,
•
wallpaper) of the surround, the trims can be put back again.
Work with the Plateau directly on glass panes 2 3 4
•
pane, see the orange dotted line.1)
•Plateau materials must always be non-combustible.
The glazing bars with leaf springs must remain removable
at all times.
•
which can serve as a boundary for the plateau material.
3 4.
thickness.
NOTE
•The platform material must not rest on the adjusting
•
strips, the glass panel must remain removable.
