Triax TECW 211 Manuel utilisateur

User manual

TRIAX TECW 211

Article Article no.

TRIAX

211

Ethernet over coaxial cable adapter & WIFI access

Ethernet over coaxial cable adapter & WIFI access Ethernet over coaxial cable adapter & WIFI access

Ethernet over coaxial cable adapter & WIFI access point

pointpoint

point

310411

Version A Date 12/2016 EN

User manual

EN 2

Attention! / Achtung! / Consignes de sécurité!

Failure to compl

Failure to complFailure to compl

Failure to compl

with the specifie

d precautionar measures ma cause serious injur to persons or damage to

propert . The installation and commissioning ma onl be performed b suitabl qualified persons, technicians or

installers in compliance with safet regulations.

Damage due to improper installation and commissioning, defective connectors on cables or an other incorrect

handling will void the warrant .

CAUTION: The safet requirements are according to EN 60728-11 and must be observed.

• Disconnect mains power before working on electrical s stems.

• An additional electrical wiring requirements should alwa s be installed b a suitabl qualified person(s).

Installation or service work should NEVER be undertaken during electrical / thunderstorms.

Subject to change without prior notice !

Gewährleistung

Gewährleistung Gewährleistung

Gewährleistung

Die gesetzliche Gewährleistung nach Paragraph 437 BGB beträgt 24 Monate.

Bei unsachgemäßer Installation und Handhabung erlischt jeglicher Garantieanspruch.

Bestimmungsgemäße

Und sachwidrige Verwendung

Die Montage und Inbetriebnahme darf nur von eingewiesenen Personen, Technikern

oder Installateuren unter Beachtung der Sicherheitsbestimmungen durchgeführt werden.

Schaden durch falsche Montage und Inbetriebnahme sowie durch unsachgemaβe Handhabung fuhren zum Erlöschen

des Garantieanspruchs.

Veillez à bien respecter

Veillez à bien respecterVeillez à bien respecter

Veillez à bien respecter

les consignes de sécurité ci

dessous. Leur non

respect peut provoquer des dommages

matériels ou corporels.

L’installation et la mise en route ne peuvent être effectués que par des techniciens ou des installateurs qualifiés en

respectant les consignes de sécurité.

La garantie ne sera pas appliquée lors de dégâts causés par une erreur de montage, de mise en route ou par un

mauvais raccordement ou toute autre manipulation incorrecte.

PRUDENCE : avant toute intervention, votre installation doit être conforme aux exigences définies par les dispositions

Européennes EN 50083 (conformité des installations collectives) et EN 60065 (normes en vigueur pour la protection

électrique).

• Débranchez l’appareil avant toute intervention, car certains composants sous tension sont dangereux

(risque d’électrocution).

Toute intervention sur l’installation ou travaux de maintenance sont à proscrire en cas d’orage.

Table of contents / Inhaltsverzeichnis / ommaire

Attention! / Achtung! / Consignes de sécurité! ................................................................................ 2

1. ntroduction ...................................................................................................................... 4

1.1 Packing List ...................................................................................................................... 5

1.2 Connectors and LED’s ....................................................................................................... 6

2. First time configuration..................................................................................................... 7

3.1 Login Password .............................................................................................................. 11

3.2 Alternative way to find the device.................................................................................... 11

User manual

3 EN

4. Quick settings by using the Wizard ................................................................................. 12

5. Status – device status .................................................................................................... 14

5.1 tatus – Network tatus ................................................................................................. 15

5.2 tatus – MoCa Rates ...................................................................................................... 15

6. Network .......................................................................................................................... 16

7. WLAN .............................................................................................................................. 17

7.1 WIFI 5GHz Basic .............................................................................................................. 18

7.2 WIFI 5GHz Advanced ....................................................................................................... 19

7.3 WiFi 5GHz ecurity .......................................................................................................... 20

7.4 WiFi 5GHz Access Control............................................................................................... 21

7.5 WiFi 5GHz WP ............................................................................................................... 22

7.6 WiFi 5GHz tatus ............................................................................................................ 23

7.7 WIFI 2.4GHz Basic ........................................................................................................... 23

7.8 WIFI 2.4GHz Advanced .................................................................................................... 25

7.9 WiFi 2.4GHz ecurity ....................................................................................................... 26

7.10 WiFi 2.4GHz Access Control............................................................................................ 27

7.11 WiFi 2.4GHz WP ............................................................................................................ 28

7.12 WiFi 2.4GHz tatus ......................................................................................................... 29

8. MoCA Settings ................................................................................................................ 30

8.1 MoCA ecurity ................................................................................................................ 31

9. Admin ............................................................................................................................. 32

9.1 Admin - Reset .................................................................................................................. 32

9.2 Admin - Password ........................................................................................................... 32

9.3 Admin – Upgrade Firmware............................................................................................. 33

9.4 Admin – Backup .............................................................................................................. 34

9.5 Admin – Time Zone ......................................................................................................... 34

10. Specifications ................................................................................................................. 35

User manual

EN 4

1. ntroduction

TECW 211 installation example (2 devices to create a network)

The TECW 211 is a multi-purpose Ethernet over coaxial cable bridge device. It can be used in a number of

different wa s to deliver Gigabit Ethernet connection via an existing coaxial (TV aerial or cable TV) connection. It

offers Wi-Fi dual band 2.4 and 5GHz in order to improve our local WLAN Wi-Fi coverage in our home

installation

It can be used as either a sender or receiver but it will need to be used with at least one other TRIAX Ethernet

over Coax compatible device. This can be either

• TEOC 211: Ethernet over Coax device (compatible with cable or terrestrial TV signals)

• TECW 211: Ethernet over Coax + Wi-Fi dual band device (compatible with cable or terrestrial TV

signals)

A Maximum of 16 TEOC 211 or TECW 211 devices can be used in an in home network

Each being able to send and receive Gigabit Ethernet via the existing TV aerial or cable TV cabling structure that

is alread installed in the home

The following pages show the most common configurations. For more detailed installation examples please visit

our web site www.triax.com

User manual

5 EN

1.1

Packing List

Before starting the installation of the device, please make sure the package contains the following

items:

1 x TECW 211

1 x Power Adapter

100-240 VAC / 50-

60Hz to 5V DC with

EU and UK plug

1 x RJ 45 cable, Cat

5e, 1.0m.

1 x white coaxial

cable, 1.0m, class

B 75 ohms with 1x

F male Connector

and 1 x IEC male

connector

1 x IEC male to F

male adapter

1 x IEC female to F

male adapter

User manual

EN 6

1.2

Connectors and LED’s

WPS button WPS push button

Power Solid Green

Off

Device is ON

Device is OFF

Link between

devices

olid Green

Off

Device is connected to another similar device

and a network is created

Device is NOT connected to another similar

device and a network is created

LAN 1

Solid Green

Blinking Green

Off

The Ethernet is plugged in and connected to

the network device

Receiving Ethernet traffic

The Ethernet is not plugged in

LAN 2

Solid Green

Blinking Green

Off

The Ethernet is plugged in and connected to

the network device

Receiving Ethernet traffic

The Ethernet is not plugged in

WIFI

Solid Green

Blinking Green

Off

FI is ON

WI-FI has activit

WI-FI is OFF

WPS

Solid Green

Blinking Green

Off

WPS process successful

WPS in progress

WPS not initialized

Front panel

User manual

7 EN

POWER

switch Turn device ON/OFF

12V/1.5A DC plug, plug in the supplied power suppl 12V

RESET Reset PIN hole, press 5 seconds to reset to factor default.

Switch Turn on/off the lamps in the front panel

LAN 2 10/100/1000 Mbps, RJ45

LAN 1 10/100/1000 Mbps, RJ45

TV+WWW

Offer TV + Ethernet signals to create the local

network. See

connection examples.

TV+WWW connectors from several TEOC 211/TECW 211 need to

be connected together to create the private network.

Offer TV signals to be connected to TV set (output) or to the

terrestrial / cable arrival signal (input). See connection examples.

2. First time configuration

•

Quick connection

In all cases (terrestrial or cable network), the first TEOC 211 adapter needs to be connected to our

house Internet access (Cable modem, ISP modem,…) via the supplied Ethernet patch cord, to get

an Ethernet signal into the s stem.

• Connexion to a terrestrial television distribution system

Make a connection from a free OUTPUT on the TV aerial distribution amplifier to the “TV+WWW” F

connector on the TEOC 211 adapter. It is essential that the first TEOC 211 adapter is onl

connected to an OUTPUT port of the amplifier, as the Ethernet over coax signal cannot pass

through an amplifier.

Rear panel

User manual

EN 8

At the second end where the Ethernet and Wi

Fi signals are wanted, ou need to use a TECW 211

(with build-in Wi-Fi extender). On this second device, connect the “TV+WWW” F connector to the

wall outlet (TV port).

To remake the connection to the TV or a DVB-T set top box, so that the signal is passing through

the TECW 211, use the supplied coaxial fl lead between the TECW 211 “TV” port and our TV or

STB.

Connect an Ethernet devices – Smart TV, Game console, Blu-ra pla er, IP Set top Box etc. using

the supplied Ethernet patch cord. Connect our wireless devices b reading the instructions

detailed later in this user manual concerning the Wi-Fi settings.

Power up the 2 devices (TEOC 211 and TECW 211), the link between the devices is established

automaticall , this is confirmed when the LED is ON. (It ma take a few minutes to link.). The

terrestrial or cable TV signal can be passed through the device.

•

Connexion to a cable television distribution system

Make a connection from a free OUTPUT on the CATV distribution amplifier to the “TV+WWW” F

connector on the TEOC 211 adapter. It is essential that the first TEOC 211 adapter is onl

connected to an OUTPUT port of the amplifier, as the Ethernet over coax signal cannot pass

through an amplifier.

User manual

9 EN

At the second end where the Ethernet and Wi

Fi signals are wanted, ou need to use a

TECW 211

(with build-in Wi-Fi extender). On this second device, connect the “TV+WWW” F connector to the

wall outlet (TV port).

To remake the connection to the TV or a DVB-C set top box, so that the signal is passing through

the TECW 211, use the supplied coaxial fl lead between the TECW 211 “TV” port and our TV or

STB.

Connect an Ethernet devices – Smart TV, Game console, Blu-ra pla er, IP Set top Box etc. using

the supplied Ethernet patch cord. Connect our wireless devices b reading the instructions

detailed later in this user manual concerning the Wi-Fi settings.

Power up the 2 devices (TEOC 211 and TECW 211), the link between the devices is established

automaticall , this is confirmed when the LED is ON. (It ma take a few minutes to link.). The

terrestrial or cable TV signal can be passed through the device.

If ou have more devices to connect onto our network, repeat the second device operation.

The schematics below illustrate how to create our fist network. More schematics examples are

available on www.triax.com

Before using the device, we recommend ou to directl connect our PC to the LAN of the device

using an Ethernet cable. Usuall our computer is setup to obtain an IP address automaticall and

ou don’t need to change it.

User manual

EN 10

3. Detailed settings

In order to setup the TECW 211 device, ou need to know its IP address. Connected to our local

network (WLAN), the TECW 211 will get automaticall its IP address from our WLAN thanks to

the DHCP function.

The “UdpDiscover ” PC Tool program supports Windows 7/8/10.

To find the TECW 211 IP address, ou can:

• run the TRIAX “UdpDiscover ” PC Tool from the TRIAX web site, install it on our PC to

find and configure the TECW 211.

• Use the Windows UPnP to find the device.

Double-click the device to open the web page of the device. Click “Refresh” to renew the window.

Table des matières

Langues :

Autres manuels Triax Point d'accès sans fil

Triax

Triax 492090 Manuel utilisateur

Manuels Point d'accès sans fil populaires d'autres marques

D-Link

D-Link DWL-2100AP - AirPlus Xtreme G Manuel utilisateur

Ubiquiti

Ubiquiti NanoStation NSM2 Manuel utilisateur

Cisco

Cisco Aironet 1550 Series Manuel utilisateur

Aruba

Aruba IAP-335 Manuel utilisateur

Advantek Networks

Advantek Networks AWN-AP-54MR Manuel utilisateur

IP-COM

IP-COM AP355 Manuel utilisateur

Buffalo

Buffalo AirStation WLA-L11G Manuel utilisateur

EnGenius

EnGenius EnStationACv2 Manuel utilisateur

D-Link

D-Link DAP-3662 Manuel utilisateur

xG Technology

xG Technology xMax CN1300 Manuel utilisateur

Widelink

Widelink ezWave WAP-1100 Series Manuel utilisateur

Edimax

Edimax CAP1200 Manuel utilisateur

Ubiquiti

Ubiquiti LBE-5AC-Gen2 Manuel utilisateur

Aruba

Aruba AP-203R Manuel utilisateur

LuXout Shades

LuXout Shades LUXSHADE MOTION Manuel utilisateur

CreatComm

CreatComm TB5F Manuel utilisateur

SineDigital

SineDigital MW-1500AP(H) Manuel utilisateur

TP-Link

TP-Link AP9650 V1 Manuel utilisateur