Transtector ALPU-EXLT Manuel utilisateur

Thank you for your recent purchase of our surge protection solution.

Your satisfaction with our product and service is important to us.

If you have any questions, comments or concerns, please contact us

at 800.882.9110 or visit our website at www.ProtectionGroup.com.

We look forward to continuing to serve your protection needs.

800.882.9110 | 208.772.8515 | www.ProtectionGroup.com

1. IMPORTANT SAFETY AND INSTRUCTIONS

2. Read and understand all instructions before installing this product.

Save these instructions for future reference.

3. This suppressor is intended to provide lightning protection for vari-

ous congurations of Exalt r-series radios.

ALPU-EXLT

Installation Instructions

800.882.9110 | 208.772.8515 | www.ProtectionGroup.com

1. This product is intended for use only on data and DC power circuits with

operating voltages not to exceed 55VDC and operating currents not to exceed

1A.

2. Mounting the ALPU-EXLT (See Diagram): Mount the device as close to the

equipment to be protected as possible using the provided hardware and the

concealed mounting holes. Mount the unit in the orientation shown, with the

marking “UP” facing upward and the strain reliefs facing the ground.

3. Wiring the ALPU-EXLT

3.1 Removing the Cover: Loosen the 4 captive cover screws using a Phil

lips screwdriver and lift off the cover.

3.2 Wiring the Suppressor: Thread a multiconductor cable from the data

source through the strain relief adjacent to the marking on the PCB la

beled Input. Strip back the cable jacket as needed, then install the conduc

tors into the IDC connectors labeled Input using the following technique:

Lay the wires into the grooves in the connector, leaving approximately

1/8” of wire overhanging, and press down rmly with the punch-down tool

provided in the packaging supplies until the wires rmly engage into the

fork terminals. Use the wiring tables in this document as well as the call

outs on the PCB as a guide. Repeat this procedure for the outgoing `

multiconductor cable, using the connectors labeled Output. Tighten the

strain reliefs to secure the cables (DO NOT OVER TORQUE!!). Reinstall

the cover.

3.3 The ALPU-EXLT is compatible with Exalt r-series radios, as well as any

other radio systems with the electrical service characteristics given in note

3.4 Grounding: Connect the external ground lug on the enclosure to a solid

Earth ground. The unit must be grounded for the suppressor to operate

properly!

ALPU-EXLT

1200-333 REV B

Table des matières

Autres manuels Transtector Parafoudre

Transtector

Transtector ALPU Fit Manuel utilisateur

Transtector

Transtector ALPU Lite Manuel utilisateur

Transtector

Transtector CPX Series Manuel utilisateur

Transtector

Transtector I2R SPV1000 3-40 Manuel utilisateur

Transtector

Transtector APEX Series Manuel utilisateur

Transtector

Transtector I2R 75K Series Manuel utilisateur

Transtector

Transtector TSJ X6 Series Manuel utilisateur

Transtector

Transtector ALPU-ALVR Manuel utilisateur

Transtector

Transtector ALPU HT Manuel utilisateur

Transtector

Transtector CB Series Manuel utilisateur

Transtector

Transtector ALPU Series Manuel utilisateur

Transtector

Transtector CPX Manuel utilisateur

Manuels Parafoudre populaires d'autres marques

ELAC

ELAC ProteK PR91-W Manuel utilisateur

Tsubaki

Tsubaki TSM4000M1 Manuel utilisateur

QVS

QVS PP134C Manuel utilisateur

CyberPower

CyberPower CSP604T Manuel utilisateur

Davis Instruments

Davis Instruments Radio Surge Protector Manuel utilisateur

M-system

M-system MGA-100 Manuel utilisateur

CyberPower

CyberPower CSP706T Manuel utilisateur

CyberPower

CyberPower B300WRC1 Manuel utilisateur

M-system

M-system MGD-24 Manuel utilisateur

Leviton

Leviton 51120-3R Manuel utilisateur

Panamax

Panamax MAX 5400-EX Manuel utilisateur

CyberPower

CyberPower B1006T Manuel utilisateur

OBO Bettermann

OBO Bettermann ÜSM-20-230I1PE65 Manuel utilisateur

Minuteman

Minuteman MMS7120RCT Manuel utilisateur

Leviton

Leviton 52412-DS3 Manuel utilisateur

Savio

Savio LZ-07 Manuel utilisateur

Siemens

Siemens HNM3M120 Manuel utilisateur

Mitsubishi Electric

Mitsubishi Electric LITOL LTM-125RF Manuel utilisateur