Wireless Sideline Handswitch - Manual Page 9
Segment Timer
By putting the Wireless Sideline Handswitch into “Segment Timer” mode, the user is able to run
a segment timer on a scoreboard without the use of an MP-70 controller. (The MP-70 must be turned
off and all other information on the scoreboard cannot be displayed.) When the segment timer is turned
on, it will start in segment one. The next timer is for break one. Then it will go to the second segment
and so on through 99 segments and breaks. The time can be displayed on the game clock of a
scoreboard or a two digit timer. When displayed on a scoreboard, the period will display “5” when in a
segment, and will display an “8” when in a break. When the time is being displayed on a timer, the time
will be steady during a segment time and will blink when in a break time. The horn can be configured to
be off, sound for a segment, or sound for a segment and a break. Also, an advanced warning horn can be
set to sound at the user’s defined time before the end of the segment or break. For example, the user
can configure the horn to sound 10 seconds before the end of the segment as a warning.
Set to “Segment Timer” mode:
To set the Wireless Sideline Handswitch to the “Segment Timer” mode, with the unit off,
press and hold the “Segment” button (approximately 5 seconds) until only the LED below the
“Segment” button lights up.
Functions:
Start the segment /break– press the “Start” button. The Wireless Sideline Handswitch
will vibrate once indicating a button was pressed. This will start the segment and
continue through each segment and break until the “Stop” button is pressed.
Stop the segment/break – press the “Stop” button. The Wireless Sideline Handswitch
will vibrate once indicating a button was pressed. This will stop the time for the segment
or break that is running.
Reset the segment /break – press the “1” button. The Wireless Sideline Handswitch will
vibrate once indicating a button was pressed. This will reset the time for the segment or
break that the user is in.
Increment to the next segment /break – press the “NEXT SEG.” button. (On the two
digit timer, the break times are indicated by the blinking time.)
Decrement to the previous segment/break – press the “SPLIT TIME” button.
Set the segment/break time – move to the segment or break that needs the time set
and press and hold the “1” button until the clock on the scoreboard flashes once. Then
press the “START” button to increase the minutes, or the “STOP” button to decrease the
