Tramigo T22 Manuel utilisateur

You should ﬁrst charge your unit for 3 hours using the wall charger.

Make sure the battery is installed and use the USB cable to connect

the unit to the charger then press the power button for 2 seconds.

When charging the power light will remain on solid until ﬁnished.

Tip: The battery cover will not close if the battery clip is not

fastened properly.

Inserting the SIM card

After charging the unit you need a SIM card so you can com-

municate with your T22. Before inserting or removing the card,

remember to power off the T22 by pressing the power button for

2 seconds.

Ensure that the SIM card is not protected by a PIN number

– this can be done by inserting the SIM into a suitable mobile

telephone and then following your mobile telephone instruction

booklet to remove the PIN lock. Your SIM account must be setup to

allow SMS (text) messaging.

Remove the battery cover and remove the SIM holder as shown in

the photograph. You can use a pen to push the yellow button then

pull out the SIM holder. Place your SIM in the holder and push back

into the unit.

After the SIM is installed then make sure the battery is installed and

turn on the power to the unit. The Power light should ﬂash every

5 seconds. The GSM light will be red for a minute and will turn off

when connected to the GSM network. If the light remains red then

check the troubleshooting section.

Mounting T22

You have 3 main options for installation, portable install using the

built-in battery, quick install using the cigarette lighter adapter or

full install that connects to vehicle power and ignition.

Portable Install

Step 1. Install

T22 Cigarette Lighter Adapter and USB cable.

Removing the SIM holder.

Quick Start Guide

Turn the power on – check that the power light is ﬂashing every 5 seconds. If the power light is off the unit may

be sleeping to conserve the battery – just tap the unit to wake it up. Ensure the unit is placed facing the sky fol-

lowing the guidelines in the quick install. Check that the GPS light goes off when outside. For backpacks or bags

try to place the unit at the top of the pack facing up. For vehicles the unit can be placed in a tissue box, glove

box or in a pillow in the back window. For motorcycles or scooters place in a storage compartment – the unit can

also be placed in a sock to prevent damage.

The battery should last several days depending on usage, so turn on Power reporting (send P to unit) to notify you

when the battery needs charging.

Quick Install

Turn the power on – check that the power light is ﬂashing every 5 seconds.

Plug the power cable into a cigarette

lighter plug, preferably one that is also powered when the ignition is turned

off.

Your T22 must be placed with the Tramigo Logo on top facing to the sky. This is to allow your T22 to determine its

location from the signal made by GPS satellites orbiting the earth. Materials such as metal, metallic window tint-

ing, and rear window defoggers must be avoided because they can block these signals. If you are parked inside

a building or under any structure you will not get a location until you have a clear view of the sky. T22 is designed

to be used outdoors only, since GPS signals inside a building are weak. In case of no GPS signal Tramigo T22 re-

ports the last position. The message will indicate it as “old position”. Please check User Manual for more details.

In general, you can expect that a mounting situation on or near the dashboard of your vehicle will be satisfactory.

You can use the Velcro fasteners to secure your T22 to the dashboard. In many vehicles your T22 will work in the

glove box, center console or even under the passenger seat.

When you have selected a location leave the T22 there for a minute and check the red GPS light – it will turn off

when your T22 knows its location. If the light remains red then check the troubleshooting section. You can also

use the optional external GPS antenna to reach a good location inside your vehicle.

Tip: Several types of tinting are available from companies such as 3M ﬁlm, Madico CharcOOl, Huper Optik

Ceramic (Stark), and FormulaOne Pinnacle (ceramic ﬁlm) that allow electronic signals through.

Full Installation

If you decide to mount the T22 covertly e.g. under the dashboard, have an auto mechanic follow the Installation

Guide located on the Tramigo CD or ask your dealer for instructions.

After T22 has been installed into the vehicle you are ready to become the ‘Owner’ of your T22. Owner has full

access to all the features of your Tramigo.

1) Send a SMS with the message OWNER to your T22. If the T22 does not answer go to the troubleshooting

section.

2) After about 5-10 seconds the T22 unit will respond with a text message: “Tramigo: Owner, please reply

“Owner,YES” to register as owner”

3) Reply with a SMS with the message OWNER,YES to your T22

4) After about 5-10 seconds the T22 unit will respond with a text message: “Tramigo: Owner, +5551234578

registered”

This means that you are now the registered Owner of your T22 and it will accept any commands that you send to it

from your phone.

5) Tramigo M1 software provides a simple to use menu interface that makes your T22 even easier to use. This

software will work with any Nokia S60 phone. M1 is included in your Tramigo CD and requires a Nokia Series 60

model phone. The M1 User Manual provides complete installation instructions. Also included is a PC version that

allows you to use a PC USB port for charging the unit and update the software with new versions from our web site.

Step 2. Setup

Quick Start Guide

Now your T22 is ready to use. From your mobile phone try sending the FIND command to your unit – just send

a SMS with the text F in the message – upper or lower case. To allow other users to ﬁnd you add their phone

numbers using the ADDUSER command. Note that you should only give other users FRIEND or GUEST authority to

prevent them from changing your T22 settings.

Try some of the commands in the summary below and connect with your car.

T22 Commands

This is a list of the most common commands that you will use. For a full list see the T22 User Manual located on

your Tramigo CD. Each user must set their own reporting options so you give them access by using the ADDUSER

(AU) command listed below.

Upper or lower case can be used in the commands. Most commands also have a short form to save typing. Com-

mands with an ON or OFF parameter can also omit the parameter to change the report setting, example T will turn

trip reporting on or off.

FIND – Shows the location of your car. You can also send a blank

SMS message

FIND,NEAR shows the 3 nearest locations

FIND,time turns on periodic reporting. You will receive a FIND

report every x minutes speciﬁed between 1 and 1440 minutes or

daily or weekly

FIND,off turns off periodic reporting.

F,DAILY will send a FIND report once per day

Tramigo: parked, 0.58 km E of Makati Sport Club/Salcedo Village,

Makati, NCR, RP, old position, 20:38 Nov 5

Unit will show as parked until a trip has started.

The text old position means that the unit has not had an updated

position in over 5 minutes

TRIP,ON – Sends a trip report when your car starts a trip and after

the car has been stopped for 15 minutes.

TRIP,OFF – Turns off trip reporting

SET,P_TRIP_START_REPORT,0 turns off the trip start reporting

T,ON (you can also just send T)

T,OFF Turns trip reporting off

Tramigo: trip report, start 0.19 km S of Pasong Tamo-Dela Rosa Street, end 0.02 km N of Tramigo Ofﬁce, trip time 0:27,

distance 1.61 km, max speed 33 km/h, avg speed 3.5 km/h, idle time 0:07, 11:44 Nov 6

ZONE,distance/on/off,placeName – Will send a report when

the car entering or leaving an area deﬁned by a circle with a radius

deﬁned by the distance from the place name. Distance can be 0.1

km to 999. You can use partial place names and the system will

select the closest one that matches

ZONE,OFF - Turns off reporting

Z,1

Z,3,Home

T22: zone crossing detected, moving 0.17 km NW from

Caltex, San Lorenzo, Makati City, PH, E with speed 34 km/h,

19:21 Jan 27

LOCATION REPORTING

SMS Command Example Command/Report (Short form use if available)

Step 3. Connect

ALARM,ON – Reports when there is movement of the unit or the

vehicle moves 100m. You must turn on the monitor again after

each alarm.

ALARM,OFF – Turns off the monitor.

Note to shut off the motion detector see the User’s Manual

A,ON

Tramigo: motion alarm detected, parked at Glorietta Mall,

Makati City, PH, 17:07 Sep 15

SAFETY AND SECURITY REPORTING

Quick Start Guide

Autres manuels pour T22

Table des matières

Autres manuels Tramigo GPS

Tramigo

Tramigo T23 Magnum Manuel utilisateur

Tramigo

Tramigo IQL 4G VEHICLE TRACKERA Manuel utilisateur