“123456” is the default password; “A” is preset phone number location. The tracker has 3
locations “A”，“B” and “C”; if the delete operation is successful, the tracker will send back the
information ”DELETEPHONE OK”, if the operation fails, the tracker will send back information
“DELETEPHONE FAIL”.
Check the preset phone number(s) by SMS:
Send SMS “CHECKPHONE*123456” to tracker, “CHECKPHONE” is a command; “123456” is
the default password; if the operation is successful, the tracker will send back the information
“CHECKPHONE A: 07818021052 B：01775640737 C：01332299223” etc.
Set Power Saving Mode:
Send SMS “SETPOWER*123456*10” to the tracker, “SETPOWER” is a command; “123456” is
the default password; “10” is the interval time, this means that every 10 minutes the GPS will turn
on and receive the location information. The time interval must be a double digit number, from 00
to 99, Units are minutes, if the time period is longer then power saving is improved, 00 means
GPS normally ON, and 99 means GPS normally OFF. (The default is 99, GPS normally OFF and
a location trigger turns the GPS on. If the real-time tracking mode is set, the GPS will normally be
ON).
Locate Immediately:
Use the preset phone to call the tracker. After 3 rings, the tracker will automatically hang up, after
approx 30-60 seconds, the tracker will send it’s location information (latitude longitude, speed,
battery, time, etc) to the caller by SMS/text message. If the tracker has no preset number(s),
any phone call can trigger it. If the tracker has a preset number(s), then only the preset
phone(s) can trigger it.
Basic Location information includes Latitude, Longitude, Speed, Direction, Date / Time & Battery
Life. The following is an example location SMS message:
Latitude: 22.680206N
Longitude: 1 14.146998E
Speed (km/h): 45.0
Direction (Degrees): 303.30
GMT: 2009/04/25 08:29:06.000
Battery: 91%
Set Geo-Fence Alarm:
Send SMS “SETAREA*123456*A22.670000N114.140000E*B22.680000N114.140000E” to the
tracker, “SETAREA” is a command, “123456” is the default password,
“A22.670000N114.140000E” is the longitude and latitude of the first point (Point A) location,
“B22.680000N114.140000E” is the longitude and latitude of the second point (Point B) location.
Please Note: the Geo-Fence Alarm requires 2 points (locations, that create an imaginary
‘square/rectangle’ between the 2 points), A and B, Point A must be a location that is to the left
and underneath of point B. The format of latitude and longitude of each point is as follows:
Latitude format is YY.YYYYYYN, it has 8 digits, the last digit is N or S, which means a north
latitude or a south latitude, if there are less than 8 digits please add zero(s) in front of the digits.
Longitude format is XXX.XXXXXXE; it has 9 digits, the last is E or W, means a east longitude or
a west longitude, if there are less than 9 digits please add zero(s) in front of the digits. If the
command and password are correct, the tracker will send back the message “AREASET OK” or
