You will then return to the Set or Reset Output Signals Menu.
Please follow the same procedure for the rest of the Output Signals.
When you test the SOS Output (Press 3) the brake lights will flash the
SOS signal and pressing 4 will disable the SOS signal. Only for testing
purposes*. If you lock the car doors, the doors will open when you test
the Open Car Doors Output (Press 5). Pressing 6 will flash the GEO(PARK)
fencing LED if one is connected and pressing 7 will disable the GEO (PARK)
fencing LED. Only for testing purposes*.
Remember to reset all outputs when you are finished testing.
*The Outputs will only be disabled (reset) for testing purposes while the
unit is in Diagnostic mode, they will still work if they are connected when
the unit returns to normal operation.
Pressing Mat anytime will return you to the Diagnostic Main Menu:
Test 6 to test I-Button and Voice I/O
This test will allow you to test the I-Button and the Voice I/O.
I-Button AND VOICE I/O MENU :
Press 1 to READ I-Button
Press 2 to TEST Voice I/O
Press M to Return to MAIN MENU
Press 1 to Read I-Button
Press 2 to test Voice I/O
Test 7 direct connect to GSM modem
This test will allow you to test communication using AT commands between your computer
and the GSM modem.
The AT command ‘AT comstop’ <enter> or if no command has been send to the modem
for more then 60 seconds the direct modem connection test will end.
For GPRS we recommend you do manual test first to test if your GPRS setup is correct.
(See GPRS section for information about the GPRS Testing).
Press Q to exit!!
By pressing Q you will exit the Diagnostic Main Menu and return the unit to
normal operation. If you do not press Q or any other option within 10 minutes the
unit will return to normal operation.
The unit will display the GSM Modem information and IMEI number directly after you
Quit the Diagnostic Main Menu.
To return from normal operation to the Diagnostic Main Menu press X (or x).
Keep pressing X until the Diagnostic Main Menu appears. Please note that this
can take several seconds or more if the AVL is processing any alarm conditions
or messages!
Please always press “Q” after finish tests to exit diagnostic menu.
- 9 -
