Touch T526S Manuel utilisateur

OWNER’S MANUAL

CARAFE READY T526S

IMPORTANT SAFEGUARDS

for Safe Operation & Use

When using electrical appliances, basic safety precautions should be followed, including the following:

1. Read and follow all of the instructions in this manual before using the brewer to avoid injury.

2. The brewer pumps extremely hot water! DO NOT touch hot surfaces.

3. Install the brewer in proper location as instructed in this manual.

4. Do not use accessory parts not recommended by Touch Coffee & Beverages, LLC. Using unauthorized accessory parts may result in fire, electrical

shock or injury to persons.

5. Do not place on or near a hot gas or electric burner, or in a heated oven.

6. The brewer is designed for indoor use only! Do not use the brewer outdoors or near damp areas.

7. Do not immerse the electrical cord or the brewer in water or any other liquid, as this may result in fire, electric shock and injury to person.

8. Do not overfill the Water Tank with water.

9. Only use water to fill the Water Tank. Do not put any other liquids or foods in the Water Tank unless instructed otherwise to clean the brewer in this manual.

10. Unplug the brewer from the outlet when not in use and before cleaning it. Allow the brewer to cool before putting on or taking off parts.

11. Plug the electrical cord into its own dedicated electrical outlet with ground to reduce the risk of an electrical shock and to prevent the fuse and circuit

breaker from tripping.

12. The electrical cord comes with a grounding wire with a grounding plug to reduce the risk of electrical shock. The electrical cord must be plugged into

a 3-prong properly grounded outlet.

13. If your outlet is a 2-prong wall outlet, then it is your personal responsibility and obligation to have it replaced with a properly grounded 3-prong wall outlet.

14. Consult a qualified electrician to replace a 2-prong wall outlet with a 3-prong grounded wall outlet. If the grounding instructions in this manual are not

lear, then consult a qualified electrician.

15. Do NOT cut or remove the third (ground) prong from the power cord.

16. Do not run the electrical cord through high traffic area or near hot surfaces.

17. Adult supervision is necessary when the brewer is used by or near children.

18. Do not open the brewer cover when the brewer is brewing a beverage.

19. Keep the lid closed on the Water Tank unless the Water Tank is being refilled with water.

20. Do not use the brewer for other than its intended use.

21. Do not modify or alter the brewer in any way.

22. Do not place smashed or damaged Pods in the brewer.

23. Do not use modified pods in brewer. (ex. Pods that have been reused with tapes and adhesives)

24. Do not operate the brewer unattended.

25. Do not let the electrical cord hang over an edge of table or counter, or touch hot surfaces.

26. Extreme caution must be used when moving the brewer containing hot liquids.

27. To unplug the brewer, turn OFF the brewer first, then unplug the electrical cord from the outlet.

SAVE THESE INSTRUCTIONS

Warning to users and parents

1. Brewer injects EXTREMELY HOT WATER! DO NOT let children use the brewer without adult supervision.

2. After brewing cocoa or soluble, IMMEDIATELY RUN an 8 oz. brew cycle without the Pod in the brewer to rinse the brewer. This will avoid clogging up

the two Needles in the Red Cup Holder.

3. Disconnect electrical cord immediately if brewer begins to malfunction.

4. Do not place fingers directly under the spout while brewer is operating - This may result in burning your fingers and scalding.

WARNING

CAUTION: There is one (1) sharp Needle underneath the Cover, and two (2) sharp Needles inside the Red Cup Holder. Do not put your fingers in the Red Cup Holder.

CAUTION: EXTREMELY HOT WATER is injected into the Red Cup Holder during the brewing process. DO NOT lift the Cover during the brewing process.

CAUTION: Keep the brewer in its upright position and place the brewer on a dry surface.

CAUTION: 120V 60Hz / 12.5A / 1500W

EXTENSION CORD INSTRUCTIONS: In the event that a longer extension cord is necessary: make sure (1) the marked electrical rating of the extension

cord exceeds or meets the electrical rating of the brewer; (2) arrange the cord so that it does not drape over the countertop and it cannot be pulled on by

children or tripped over unintentionally; and (3) the extension cord has a 3-prong grounding plug.

THIS PRODUCT IS FOR HOUSEHOLD USE ONLY.

WARNING

THIS PRODUCT CONTAINS CHEMICALS, INCLUDING LEAD, WHICH IS KNOWN TO THE STATE OF CALIFORNIA TO CAUSE CANCER, BIRTH

DEFECTS OR OTHER REPRODUCTIVE HARM.

WARNING

RISK OF FIRE OR ELECTRIC SHOCK, DO NOT OPEN.

TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK, DO NOT REMOVE THE BOTTOM COVER. NO USER

SERVICEABLE PARTS ARE INSIDE. REPAIR SHOULD BE DONE BY AUTHORIZED SERVICE PERSONNEL ONLY.

TABLE OF CONTENTS

Using Touch’s T526S Brewing System

PART 1. SET-UP

Helpful Hints .............................................................................................................................................................

Unpacking Instructions .............................................................................................................................................

Product Features .....................................................................................................................................................

PART 2. BREWING A CUP

Setting Up Your Brewer ............................................................................................................................................

Ready to Brew Your First Cup ..................................................................................................................................

Stopping the Brew Process ......................................................................................................................................

Brewing Iced Beverages ..........................................................................................................................................

Purging the Brewer ..................................................................................................................................................

Adding Water ............................................................................................................................................................

PART 3. BREWING A CARAFE

Brew Your Family Size Coffee ..................................................................................................................................

PART 4. MAINTENANCE

Cleaning External Parts ...........................................................................................................................................

Cleaning the top needle ...........................................................................................................................................

Cleaning the Red Cup Holder ..................................................................................................................................

Cleaning the two bottom needles .............................................................................................................................

Cleaning the Water Tank & Water Tank Lid ..............................................................................................................

De-scaling Your Brewer ...........................................................................................................................................

PART 5. TROUBLESHOOTING .........................................................................................................................................

PART 6. WARRANTY .........................................................................................................................................................

PART 1. SET-UP

Helpful Hints

1. Plug the brewer’s electrical cord into its own grounded outlet. If the same outlet is used with another electrical appliance, then the electrical circuit may

be overloaded causing the fuse or the circuit breaker to trip.

2. Filtered or bottled water is recommended for best tasting coffee, tea or hot cocoa.

3. Use K-Cup® pack to brew 8-10 oz cup of coffee; use our XBold cup (packed with more coffee) to brew 10 -14 oz cup of coffee; and use our XLarge

cup to brew strong 12 -18 oz cup of coffee; and use our Refill Jumbo Cup to brew strong 26 oz of coffee into the Carafe.

4. T526S model offers seven cup sizes (6 oz, 8 oz, 10 oz, 12oz, 14 oz, 16 oz, 18 oz), and one (CARAFE for 26 oz) family size for use with the Reill Jumbo

Cup and Carafe.

5. Remove the Pod from the Red Cup Holder after each use.

CAUTION: POD IS HOT!

6. De-scale the brewer regularly. Please see pages 18 and 19 for instructions.

Unpacking Instructions

1. Place the brewer box on a large steady surface (such as a table or countertop) or on the floor. Open the box.

2. Remove the enclosed literature. Turn the box on its side with front of the box face down.

3. Reach into the box and grasp the plastic bag that contains the brewer.

4. Carefully pull the plastic bag (and packaging materials) toward you and out of the box. The brewer will still be encased in the styrofoam and be on its side.

5. Remove the top styrofoam packaging material.

6. Carefully lift the brewer off of the bottom styrofoam and place it upright on a flat, steady surface.

7. Lift plastic bag off of the brewer.

8. Record the serial number for this brewer. The serial number can be found on the bottom of the brewer.

9. Place the brewer upright on a flat, steady surface.

We recommend you save all packing materials in case future shipping of the product is necessary.

WARNING: Keep all plastic bags away from children.

Touch Coffee & Beverages is NOT affiliated with Keurig, Inc. Keurig® and K-Cup® are register trademarks of Keurig, Inc.

PART 1. SET-UP

Product Features

T526S Brewer parts

Cover

Cover Handle

Red Cup Holder

Deep Well

Housing

Power Cord

Drip Tray Slots

Drip Plate

Drip Tray

Water Tank

Water Tank Lid

Refill Jumbo Cup

Carafe

Controls and Indicators

Power Button

Low Water Indicator

Brewing Indicating Light

6 oz Button

8 oz Button

10 oz Button

12 oz Button

14 oz Button

16 oz Button

18 oz Button

Carafe Button

Latch

MAX & MIN Fill Line

QQ RSTU

V W

PART 2. BREWING A CUP

Setting Up Your Brewer

IMPORTANT: DO NOT use the brewer until it has been set-up for its first use.

NOTE: If the brewer has been exposed to temperatures below freezing, allow the brewer at least two hours to reach room temperature before using it. A frozen

or extremely cold brewer may not operate properly.

1. Unwrap the electrical cord and remove all pieces of adhesive tapes.

2. Remove the Water Tank from the brewer (Fig. 1) by Tilting and Lifting away from the brewer. (it may be tight)

3. Rinse the Water Tank with fresh water. Fill the Water Tank with bottled or filtered water but NOT beyond the MAX Fill Line. (Fig. 2)

4. Return the Water Tank back into the rear side of the brewer and be sure the Water Tank sits properly on the rear base of the brewer.

5. Place a large mug or cup (12 oz minimum) on the Drip Tray. (Fig. 3)

6. Plug the brewer into a 3 prong-grounded outlet. (Fig. 3)

7. Press the Power Button on top of the brewer. The blue Power Light will illuminate. (Fig. 3)

NOTE: DO NOT insert a Pod into the Red Cup Holder at this time.

Fig. 1 Fig. 2 Fig. 3

PART 2. BREWING A CUP

Setting Up Your Brewer (Continued)

CAUTION: DO NOT pull the Latch to open the Cover during the brewing period. (Fig. 4)

CAUTION: Extremely Hot Water! (Fig. 5)

8. With the cover closed, press the 10 oz Button to start the brewing cycle. (Fig. 5) The brewing indicating light on the upper right corner will stay ON while

the brewer is warming up. Note that the brewer will pump the water to the Water Tank while warming up. This is normal and it may take up to 30 seconds

to warm up from a cold start. The brewing indicating light will start to blink when the brewing cycle starts.

CAUTION: DO NOT remove the mug until the brewing indicating light stops blinking.

9. Once the brewing is done, remove the mug and pour the hot water into the sink. Discard the hot water and repeat cleansing by repeating the brewing

cycle at least two (2) more times. (Fig. 6)

10. The one-time set-up process is now complete and the brewer is now ready.

Fig. 4 Fig. 5 Fig. 6

PART 2. BREWING A CUP

Ready to Brew Your First Cup

1. Make sure the brewer is powered ON. Place a cup or mug on the Drip Tray.

2. Pull on the Latch to open the Cover. (Fig. 7) Insert a desired Pod into the Red Cup Holder. (Fig. 8)

NOTE: DO NOT remove the foil lid or puncture the Pod. (Fig. 8) When using a smaller cup, the Drip Tray may be inserted into the Upper Slot to minimize

splattering of coffee. (Fig. 7)

CAUTION: There are three sharp Needles that puncture the Pod: a top Needle underneath the Cover and two bottom Needles in the Red Cup Holder. To

avoid risk of injury, do not put your fingers in the Red Cup Holder. (Fig. 8)

3. Close the Cover by pressing down on the Cover Handle. (Fig. 9)

4. Press on the desired cup button (6, 8 10, 12, 14, 16, or 18). (Fig. 9) Recommendation: Use 6-10 cup size with regular K-Cup® portion pack; use 10-14

cup size for our XBold cups; use 14-18 cup size for our XLarge cups; and use Carafe button with our Refill Jumbo Cup and Carafe.

Touch Coffee & Beverages is NOT affiliated with Keurig, Inc. Keurig® and K-Cup® are register trademarks of Keurig, Inc.

Fig. 7 Fig. 8 Fig. 9

PART 2. BREWING A CUP

Ready to Brew Your First Cup (Continued)

NOTE: If you do not push a cup size button to start brewing within 60 seconds, the brewer will be disabled to prevent accidental activation. Re-activate the

Brewer by pulling on the Latch and Closing the Cover again.

5. The upper right brewing indicating light will stay ON during warm up, and the light will BLINK during the brewing cycle. (Fig. 10)

CAUTION: The brewer will heat the water EXTREMLY HOT during the brewing process. To avoid risk of injury, do not pull on the Latch or open the Cover

while brewing. Contents will be EXTREMELY HOT! (Fig. 10)

6. If the brewer has been OFF for some time before turning ON the brewer, there may be a short pause up to 30 seconds before the brewing process starts.

At the end of the brewing process, the brewer will pump water to the Water Tank and a burst of air to purge the Pod of remaining liquid.

7. Enjoy your cup of coffee, tea or hot cocoa! (Fig. 11)

8. Pull the Latch and dispose of the used Pod. (Fig. 12)

CAUTION: Pod will be HOT! (Fig. 12)

Fig. 10 Fig. 11 Fig. 12