topled QL-DIM-K Manuel utilisateur
Part No.: QL-DIM-K
Brief introduction
I:Technical Parameters(remote control):
1: Power supply: AAA battery * 3pcs
2:Cover Material:ABS
3: Fabrication processing: multicolour printing & UV varnish
Ⅱ: Technical Parameters(controller)
1. Working voltage:DC12V/24V
2. Output control: 2 circuits
3. Control current：6A/circuit
4. Connecting mathod: common anode
5：Wireless frequency：433.92MHz
6. Receiving range:20meters
Ⅲ: Functions of Keys
1. Key 1: on
2. Key 2: off
3. Key 3:highest brightness
4. Key 4: medium brightness
5. Key 5: lowest brightness
This is a multi-function Touching LED Controller. It adopts the most advanced PWM reomte control
technology ,can control all the full color LED lighting with three lines two circuits(common anode),
with 50 grades of brightness adjusting. it is widely applied to LED strip light and dimmable LED
lighting,etc
Single Color Touching Dimmer
Ⅳ. How to use
2. Resume fuction. The previous settings will be resumed while power on again.
Ⅵ: Connecting Chart
IIV. Dimensions
Please don’t touch or press the color ring while loading the battaries to protect the sensitiveness.
Please use the remote controller 3 seconds after the battaries are loaded.Please reload the
battaries when you find the color ring is not sensitive.
1. Use your finger to touch the color ring ,you can change the brightness from the highest to the
lowest (100%-1%,50 grades to adjust).
3. Matching code
Press Key 3once within 3 seconds when power on again,the light will blink 3 times if matching is
successful.
Clearing Code,Press Key 3 five times within 3 seconds when power on again,the light will blink 6
times if clearing is successful.
Ⅴ: Caution:
POWER1
AC
DC12V/24V
AC TO DC
+
-POWER2
ANT
Safe instruction
Please follow the instructions to use safely.
Attention! Operate Carefully! Please read the following tips carefully.
1、Donot install the product in areas with thundering,strong magnetic and high pressures.
2、Make sure the connection is right and firmed in case of fire accident caused by short circuit.
3、Please install the controller with ventilation to make sure the temperature is appropriate.
5、Please donnot connect the power before connection.
6、The Instruction is for this Item Only,no notification if any amendments.
4、Please check whether the input voltage,power supply(constant pressure)
Table des matières
Autres manuels topled Télécommande
Manuels Télécommande populaires d'autres marques
Panasonic
Panasonic EUR7622KB0 Manuel utilisateur
Bang & Olufsen
Bang & Olufsen Beo4 Manuel utilisateur
Sunwave Tech.
Sunwave Tech. RemoteComm SRC-7000 Manuel utilisateur
Multiplex
Multiplex PROFI TX 9 Manuel utilisateur
One Remote
One Remote RMB4 Manuel utilisateur
FUTABA
FUTABA 9ZAP - PART2 Manuel utilisateur
