10
Connecting and Binding
(With the remote and the board power-off) Press the “Power” button of the board for 5
seconds, the Red light of it starts to flash rapidly to indicate that the board enters the
binding mode; then press the “Button A” on the remote for 5 seconds, the Signal light on
it starts to flash Red rapidly to indicate that the remote enters the binding mode, and
the remote vibrates two short vibrations and one long vibration to indicate that the
biding succeeds. The signal light on the remote and the Red LED on the board turn on
when the binding succeeds.
Note: When using a new remote and a new board, there is no need to press either the
Power button on the board or the Button A on the remote, they enter into the binding
mode when they are turned on.
Battery Indicator
Remote Power indicator (a single light)
When the remote is turned on, if it detects the power is less then 25%, which can barely
support a one-hour operation, the Remote power light turns Red; if the power is more
than 25%, which can support operation of at least one hour, the Remote Power light will
be green.
If there is only 5 of power, which can only support a 15-minute operation, the remote
will vibrate a double, long vibration (vibrate for 0,5 seconds, pause for 0,5 seconds and
then vibrate again for 0,5 seconds) and starts to flash Red slowly (once a second); if
there is only 2,5% of power left, the remote will vibrate a double, long-vibration again as
the same as previous and starts to flash Red light slowly; and if the power is below the
regulated value (3,4 V) for safe use and use and the boards stops. The remote will
vibrate a short vibration and turn off automatically.
Board power indicator (4 lights in a row)
One light turns on to indicate that 25% of power is left, one light flashes to indicate that
12.5% of power is left. For example, if the power is from 62.5% to 75%, the lights will be “
”if the power is from 50%-62.5%, the lights will be “ ”; if the power is
below 25%, the remote will vibrate a double, long vibration and the lights will be in “
”; if the power is below 12.5%, the remote will vibrate a double, long vibration
and the lights will be “ ”; and if the voltage goes below the safety value, the
power output will be stopped. For this situation, you have to stop using as soon as
possible.
Notes: the remote will display the power of the remote and the board for 2 seconds and
then stop when it's powered on and connected to the board. Press the Button A at any
time can re-trigger the display of the power of the remote and the board. the remote
only displays the power of the remote when the board is not connected (to the remote).
Attention: “ ” means “solid”; “ ” means “flash”; “ ” means “die out”.
