TimoLabs AMOY I Manuel utilisateur
Quick Start Guide
TimoLabs AMOY I,
Model# TM-SS2020BT
Soundbase/Sound Stand SYSTEM
with BLUETOOTH
GETTING STARTED
YourTimoLabs AMOY ITV sound system is designed
to t under televisions with screens up to 42”. It
delivers Bluetooth capability and superb acoustic
performances that will greatly enhance yourTV
viewing experience. Carefully unpack the carton and
conrm that you have all the parts shown here. If any
of these parts is missing or damaged please contact
TimoLabs directly.
Important
Carefully read the set-up instructions on page 4 and safety guidelines on page 11 before
you set-up and use your AMOY I soundbase/sound stand sound system.To download the
specications for your sound system please visit www.timolabs.com/support.html
SETUP SOUND STAND SYSTEM
The AMOY I soundbase/sound stand system is de-
signed for TVs or Monitors that weigh no more
than 40lb (18kg) and have bases no wider than 20”
(508mm) and no deeper than 10 1/4” (260mm). Most
42”TVs and smaller meet these requirements.
NOTE: Do NOT place a CRT typeTV on this system, it is not de-
signed for use with this type ofTV
Placement Guidelines
The base of yourTV should be centered on top of the
system and must not hang over the sides. Allowing
the base of yourTV to hang over any edge of this
speaker system increases the risk of tipping, which
may result in injury.
CAUTION:
If yourTV comes with an anti-tip device, install it according to the manufacturer’s
instructions and adjust the tether as instructed after placing theTV on top of the system.
Installing an anti-tip device is recommended when using aTV with this product. If your
TV did not come with an anti-tip device, you can get one from most retail suppliers.
SETUP SOUND STAND SYSTEM
If the TV base is too large
to t on top of the system, place the sound system
in another location such as an open shelf under the
TV, but keep it close to yourTV so the audio cable
will reach.You also could mount yourTV on the wall
above the system.
If placing the sound system backed up to a wall
make sure there is at least one-inch of space between
the wall and the rear of the system.
If placing the sound system in a cabinet
or on a shelf, position the front of the system as
close as possible to the front edge of the shelf for
optimum audio performance.
CAUTION:
With any placement of this product, make sure the ventilation openings on the rear
panel are not blocked.
SETUP SOUND STAND SYSTEM
Connect one of the audio cables to your TV
MostTVs today have three types of audio outputs
(shown on the following page). For the best audio
performance, always use the highest quality output
available; optical being the rst choice, coaxial sec-
ond and analog third.
NOTE:
If you are using an optical cable, be sure to remove the protective
plug cover. When inserting the plug into the connector, you may
sense a slight resistance and additional pressure may be needed
to get it to click securely in place.
Setup Bluetooth Connection
Switch on your AMOY I by pushing the Power button
on the remote.Then push the Bluetooth button on
the remote.The red LED display on the AMOY I will
display ‘BL’ indicating that the speaker is ready for
pairing. Choose “SS2020BT” in your mobile device
for connection. (If a password is required, please
enter 0000). Once connected, the red LED display will
blink and you can start using your AMOY I wirelessly.
SETUP SOUND STAND SYSTEM
SETUP SOUND STAND SYSTEM
Plug the other end of your selected audio ca-
ble into the corresponding audio input on your
sound system.
If you wish, you may slide the cable into the built in
cable clip.
SETUP SOUND STAND SYSTEM
Plug one end of the included power cord into the
DC input connector and the other end into a wall
outlet. A moment fter turning the system on, the
system emits two tones indicating that it is ready
to use.
TURN SYSTEM ON
1. Press the power button you your remote
2. Turn on your TV
3. Turn off your TV’s built-in speakers
To enjoy the full benet of hearingTV Audio through
your SS2020BT, the internal speakers on yourTV
should be turned off. NewerTV’s usually have a
set-up menu item for turning off speakers. OlderTVs
may have a speaker on/off switch on the read panel
near the audio output connectors.
If you have aTV with a set-up menu, use the remote
that came with your television to locate the menu
item and set theTV speakers to off. If yourTV does
not have a menu setting for turning off the internal
speakers, exit the audio menu and reduce theTV
volume to its lowest setting.
If the rear panel of yourTV has a speaker on/off
switch on the rear panel, set it to the off position
and adjust the volume to about 80% of the highest
volume.
NOTE:
To conrm yourTV speakers are off, press the Mute button on your SS2020BT and check
that no sound is coming from theTV.
CARE AND SAFETY
Important Safety Instructions
1. Read these instructions
2. Keep these instructions
3. Heed all warnings
4. Follow all instructions
5. Do not use this apparatus near water
6. Clean only with a dry cloth
7. Do not block any ventilation openings
8. Install in accordance with the manufacturer’s instructions
9. Do not install near any heat sources such as radiators, heat
registers, stoves or other apparatus (including ampliers) that
produce heat
10. Protect the power cord from being walked on or pinched
particularly at plugs, convenience receptacles and the point
where they exit from the apparatus
11. Only use attachments / accessories specied by the
manufacturer
12. Unplug this apparatus during lighting storms or when unused
for long periods of time.
13. Refer all servicing to qualied personnel. Servicing is required
when the apparatus has been damaged in a way, such as
power supply cord or plug is damaged, liquid has been spilled
or objects fallen into the apparatus, the apparatus has been
exposed to rain or moisture, does not operate normally, or has
been dropped.
Ce manuel convient aux modèles suivants
1
Table des matières
