User Friendly Anti-Tip Owners Manual OM_UFAT_0308RevA
USER-FRIENDLY ANTI-TIPS
8
10. IWARNING: Before sitting in the chair, make sure that the
anti-tips are operating properly. To do this, place the chair on a level
surface and engage the anti-tips. Tip the chair backward until the
weight of the chair is supported by the anti-tips and rear wheels.
Apply sufcient pressure to ensure that the anti-tips are operating
properly.
If you ignore this warning, you may fall, tip over or lose
control of the wheelchair and seriously injure yourself or others or
damage the wheelchair.
Mounting the User-Friendly Anti-Tip
(ZR)
IWARNING
Mounting the user-friendly anti-tip receiver must be performed by
an authorized TiLite dealer or qualied technician.
If you ignore this
warning, you may fall, tip over or lose control of the wheelchair and
seriously injure yourself or others or damage the wheelchair.
IWARNING
Do not disassemble the anti-tip mounting assembly (see Figure 8).
If you ignore this warning, you may fall, tip over or lose control of
the wheelchair and seriously injure yourself or others or damage the
wheelchair.
Tools Needed:
•5/32”AllenWrench
1. Remove the rear wheels and place the frame on a level surface.
2. Loosen the allen screws that secure the camber tube within the camber
clamp. See Figure 8.
3. Without disassembling the anti-tip mounting plate from the anti-tip
receiver, slide the camber tube through the large hole in both anti-tip
mounting plates.
4. IWARNING: Make sure that the TiLite logo is visible on the
rearward side of the user-friendly anti-tip receivers as shown in
Figure 8 and that the white arrows are all aligned on the opposite
(forward) side of the anti-tip components as shown in Figure 8.
If
you ignore this warning, you may fall, tip over or lose control of the
wheelchair and seriously injure yourself or others or damage the
wheelchair.
5. Reinstall the camber tube. See “Standard Camber Tube—Replacing
the Camber Tube (ZR)” on pages 56-57 of the TiLite Rigid Owners
Manual.
6. With the wheelchair standing upright on a level surface, engage the
anti-tip as described under “Engaging the Anti-Tip” above.
7. Align the holes on the forward end of the anti-tip mounting plate with
the threaded holes on CG bracket. Select two threaded holes on the CG
bracket that are not already in use to secure the camber clamp to the CG
bracket. Insert the two Allen Screws through the lock washers and anti-tip
mounting plate and into the two unused threaded holes in the CG bracket.
Figure 8
Mounting the Anti-Tip to the ZR
Anti-Tip
Mounting Plate
Anti-Tip
Receiver
Lock Washers
Allen Screws
Camber Tube
CG Bracket
Allen Screw
Camber Clamp
