1. Before assembling the mounting hardware as shown on above, decide where and
which set up you will want the guide post placed on your trailer.
(Use the diagrams on back to determine guide post placement.)
2. Using 4 - 3/8"x 5" hex head bolts, 8 flat washers and 4 nyloc nuts, for each, attach
the guide support mounts onto your trailer frame, as shown in figure 1. Use the
holes that will keep the bolts closest to the frame tube. Finger tighten at this time.
Repeat for other side.
3. Slide the guide support tube into the channel bracket as shown in figure 1.
4. Adjust the guide tubes for proper distance on each side. Tighten support mounts
bolts at this time.
5. Side the PVC tubes over the side guide tubes.
Front
Out
Figure 1
Heavy Duty PVC Guide On’s
Assembly/Installation Instructions
A1406;051216
Instruction Sheet #08158 Page 1 of 2
5
1
8
7
3
4
2
7
6
# Qty. Qty. Part # Description
1 2 --- 48116 Side Guide Tube
48” w/Oragne Cap
1 --- 2 48117 Side Guide Tube
60” w/Oragne Cap
2 2 2 48066 Support Tube
3 2 2 48011 Mounting Plate
4 2 2 48012 Channel Bracket
5 8 8 10924 3/8"x 5" Hex Head Bolt
6 8 8 10627 3/8" Hex Nyloc Nut
7 16 16 10841 3/8” Washer
8 2 2 17266 LED Light Kit
# Qty. Qty. Part # Description
1 2 --- 48074 Side Guide Tube
48” w/Orange Cap
1 --- 2 85001-1 Side Guide Tube
60” w/Oragne Cap
2 2 2 48066 Support Tube
3 2 2 48011 Mounting Plate
4 2 2 48012 Channel Bracket
5 8 8 10924 3/8"x 5" Hex Head Bolt
6 8 8 10627 3/8" Hex Nyloc Nut
7 16 6 10841 3/8” Washer
Part #’s: 86441 & 86440 - Kits with LED Lights
Part #’s: 86103 & 86119
