Therm-ic Boot Integrated System Manuel utilisateur

BOOT INTEGRATED SYSTEM

Mono button

INSTRUCTIONS FOR USE 2

1.1

1.2

1.1

1.2

1.5

1.4

1.3 2.2

2.1

2.3

2.4

2.5

2.1

Optional

HEAT LEVELS

NIVEAUX DE CHAUFFE

WÄRMESTUFEN

MANUAL / MODE D’EMPLOI / ANFAHRT

www.therm-ic.com

LEVEL

STAYS

LEVEL

FLASHES

LEVEL

FLASH

STAND

BY LIGHT

FLASH

WAKE

BACK

TO THE

SELECTED

LEVEL

IF YOU DON’T TOUCH THE SWITCH

FOR 10 SECONDS

OFF

INSTRUCTIONS FOR USE 4

Contents:

Introduction 4

Contents of the packaging 4

Safety instructions 4

Description of the device 6

Technical speciﬁcations 7

Activating and charging the batteries 7

Instructions for use and description

of functions 8

Important usage advice 10

Heating settings 10

Maintaining, storing and looking

after the batteries 10

Drying and cleaning the boots 10

Disposal 11

Spare parts 11

INTRODUCTION

Congratulations on purchasing the Therm-ic

Boot Integrated System.

Please read these instructions carefully before

using the boots for the ﬁrst time. Keep these

instructions in a safe place and make sure other

users are familiar with them.

CONTENTS OF THE PACKAGING

• 1 pair of the Boot Integrated System

• 1 pair of «Dual» rechargeable lithium-ion

batteries

• 1 Therm-ic standard USB charger

• Optional: universal charger (with adaptors for

use in dierent countries)

SAFETY INSTRUCTIONS

• This device is not suitable for people

(including children) of reduced physical,

sensory or intellectual capacity or for use

by inexperienced and/or unknowledgeable

people unless they are supervised by a

person responsible for their safety or who has

provided them with clear usage instructions.

• Supervise children to ensure they do not play

with the device.

• If you are unable to feel hot or cold temperatures

accurately (diabetic or disabled users, etc.),

consult your doctor before using the device.

• Check regularly that no redness appears on

your ﬁngers. There is a risk of burns in the case

of exposure to excessive heat for a prolonged

period. Consequently, children must only

use this device under the supervision of a

responsible adult.

• This device must not be used to warm animals.

• The pockets protect the batteries from splashes.

Once attached to the boots, the batteries must

remain connected to the connection cords

whenever the boots are worn outside, ﬁrstly

to prevent moisture and dirt from entering the

connection point and power supply socket and

secondly to prevent the battery case from being

opened accidentally.

• Use only the Therm-ic USB charger supplied

to charge the batteries.

• Do not wear the boots while the batteries are

charging.

• Do not insert metal or other objects into the

connectors or the USB charger as this may

damage the device.

• If you discover that the connection cords,

batteries or other parts of the boot are

damaged, the heating function must not

be used. After removal of the batteries,

the boots can be used as an ordinary pair.

• Never attempt to remove the protective

INSTRUCTIONS FOR USE 6

ﬁlm enclosing the batteries! There is a risk

of explosion if the lithium-ion batteries are

handled inappropriately.

• Batteries which have damaged protective

ﬁlms must not be used and must be disposed

of as soon as possible.

• Do not modify this device and donly use it for

its intended purpose. The parts of the device and

its connection cords should be repaired by the

manufacturer only.

• If you have questions or if there are any

problems with the device, please contact your

retailer or the manufacturer.

• Dispose of used batteries in accordance with

the regulations in your area.

• Do not throw batteries into a ﬁre–risk of explosion!

• The boots must never be machine washed or

hand washed.

• The drying temperature must not exceed

40°C / 104°F. Never dry the Boot Integrated

System in a tumble dryer or on a radiator.

DESCRIPTION OF THE DEVICE

Boot Integrated System

• Heating level indicator light (1.1)

• Control zone with one button for the 3 heating

levels (1.2)

• Battery connection point (1.3)

• Boot Integrated System connector (1.4)

• Battery pockets (1.5)

USB charger

• Charge indicator light x 2 (2.1)

• Charger cord with plug (2.2)

• USB connector (2.3)

• Optional universal charger (with adaptors for

use in dierent countries)

TECHNICAL SPECIFICATIONS

USB charger (spare part available from Therm-ic)

USB charger* Input 5V / 2A Output 4,2V /

1A x 2

Optional universal

charger* (en

option) DC 5V /

2A (with adaptors

for use in dierent

countries)

Input 110V -

240V ~

(50 - 60 Hz) max.

300 mA.

Output 5V /

2000 mA.

"Dual" Lithium

batteries* 3,7V / 2600 mAh

* spare parts available from Therm-ic

ACTIVATING AND CHARGING THE BATTERIES

The batteries must be charged before ﬁrst use.

1. Plug in the USB cable. The charge indicator

light (2.1) will light up green. Next, plug

the two boot connectors in to the charger.

The Boot Integrated System can be in any

mode at the start of charging. Charging will

start automatically and the charge indicator

light (2.1) turns red and remains on during

charging.

2. When the batteries are fully charged,

charging will stop automatically and the

LEDs in the charge indicator light (1.2) will

turn green again.

3. Unplug the two Boot Integrated System

connectors from the USB charger.

4. Connector trap on the Boot Integrated

System.

During and after charging, the Boot Integrated

System remains in the mode in which it was set

before charging.

It is recommended that you switch OFF

the Boot Integrated System during and

INSTRUCTIONS FOR USE 8

after after charging to keep it at full charge

when it is not in use.

Charging time is approximately 4-6hours.

Important advice:

• Recharge the batteries after each use to keep

them in good condition and to ensure the

Therm-ic Boot Integrated System is always

ready for use.

• Each battery is made up of lithium-ion cells.

It can be recharged in any state of charge.

Therefore, it is not necessary to discharge the

batteries completely before recharging.

Important:

Never try to open a battery pack!

There is a risk of explosion if the lithium-ion

batteries are handled inappropriately.

There is also a risk of damaging the electronic

components of the Boot Integrated System.

INSTRUCTIONS FOR USE AND DESCRIPTION

OF FUNCTIONS

The Therm-ic Boot Integrated System has

four modes: OFF and LEVELS 1, 2 and 3.

These modes are indicated by a heating

speed indicator light (1.1). The number of LED

ﬂashes displayed indicates the heating level

selected.

The heating setting of the Therm-ic Boot

Integrated System can be set to 3 dierent

levels (level1, level2 and level3) using the

control zone, which consists of a single

button (1.2). The Therm-ic Boot Integrated

System is o when the LED heating level

indicator light is not lit.

Switching ON:

Press and hold down the function button (for

approx. 3 seconds) to set the Therm-ic Boot

Integrated System to the lowest heating level. If

the button is pressed for more than 6 seconds,

the boots will go into safety mode and switch o.

Adjustment:

Pressing the function button once (for approx.

1 second) will increase the heating setting

(level1, level2 or level3).

> Level 1: 1 ﬂash, low heating setting.

> Level 2: 2 ﬂashes, medium heating setting.

> Level 3: constant light, high heating setting. If

standby mode has been activated, you will ﬁrst

need to wake up the system.

STANDBY mode:

If the button is not pressed for 10seconds, it will

go into standby mode. Pressing the function

button (for approx. 1second) will wake up the

device, returning it to the last heating level set.

OFF:

To switch o the Therm-ic Boot Integrated

System, press and hold the function button (for

3 seconds, until the heating level indicator light

switches o).

IMPORTANT USAGE ADVICE

• Charge the batteries before each use.

• Then, re-connect the battery to the boot (by

clipping on the plug). When switching on

the Therm-ic Boot Integrated System, do not

leave them set to level 3 for more than a few

minutes; continuous use at this setting risks

raising the temperature excessively and may

cause burns.

• Always set the Therm-ic Boot Integrated

INSTRUCTIONS FOR USE 10

System to the level 1 or level 2 setting to

keep your feet at a comfortable temperature

(the warming eect should be practically

imperceptible).

• The optimum heating temperature is reached

when the boots are dry.

HEATING SETTINGS

Level Heating duration per charge

1 17-19 hours

2 8-9 hours

3 4-5 hours

Measurements were made under laboratory

conditions directly on the heating element. The

heating duration per charge depends on the

heating level selected, the ambient temperature,

the age of the batteries and their charge level.

Therefore, the indicated heating durations

are provided only as a guideline and are not

contractual.

MAINTAINING, STORING AND LOOKING

AFTER THE BATTERIES

To prolong the life of the batteries, we

recommend you charge them to half capacity

and then store them in a cool place (at 5 °C

/ 41°F to 20°C / 68°F). During storage, the

batteries must not be connected to either the

boot or the USB charger.

Avoid prolonged periods when the batteries

are not in use. If storing the batteries for long

periods, discharge them and then recharge

them fully every 6months (for approx. 3hours).

Storing the battery packs correctly will maintain

their power level and life for longer.

Table des matières

Autres manuels therm-ic Chauffage

therm-ic

therm-ic TrimFit Manuel utilisateur

Manuels Chauffage populaires d'autres marques

oventrop

oventrop Regucor Series Manuel utilisateur

Blaze King

Blaze King CLARITY CL2118.IPI.1 Manuel utilisateur

ELMEKO

ELMEKO ML 150 Manuel utilisateur

BN Thermic

BN Thermic 830T Manuel utilisateur

KING

KING K Series Mode d’emploi

Empire Comfort Systems

Empire Comfort Systems RH-50-5 Guide de démarrage rapide

Well Straler

Well Straler RC-16B Manuel utilisateur

EUROM

EUROM 333299 Manuel utilisateur

Heylo

Heylo K 170 Manuel utilisateur

Eterna

Eterna TR70W Manuel utilisateur

Clarke

Clarke GRH15 Mode d’emploi

IRSAP

IRSAP The Radiator Company Ovali Manuel utilisateur

Empire Heating Systems

Empire Heating Systems WCC65 Manuel utilisateur

Wetekom

Wetekom 92 86 43 Manuel utilisateur

Desa

Desa SPC170-F Manuel utilisateur

Watlow

Watlow Watrod Electric Tubular Heaters Manuel utilisateur

Haverland

Haverland ECO-DRY GPS Series Manuel de la liste des pièces

Stelpro

Stelpro ASILVC2060 Series Manuel utilisateur

therm-ic Boot Integrated System Manuel utilisateur

Manuels Chauffage populaires d'autres marques