4 Zone RF Remote Control
for Single Colour, Tunable White, RGB, RGBW
and RGBCCTLED strip
www.teucerled.co.uk
V002-11-2019
Warranty
• Products must be installed and serviced by qualified
electrician.
• Please ensure the receiver is mounted in a water proof
enclosure if installed in an outdoor environment,
avoiding metallic enclosures.
• Always ensure products are mounted in areas with
adequate ventilation to avoid overheating.
• Please ensure outputs of any power suppliers used in
conjunction with this product comply with its working
voltage.
• Never install product whilst connected to power and
double check connections before switching on to
avoid short circuits.
Safety
Should this product fail during the 5 year warranty
period it will be replaced free of charge, subject to the
correct installation of the original product in accordance
with applicable and appropriate electrical codes and
instructions provided by Teucer, as well as subsequent
return of the faulty unit. Teucer does not accept
responsibility for any installation costs associated with
the replacement of this product and Teucer reserves
the right to alter specifications without prior notice. For
further information, please see our Terms and Conditions.
www.teucerled.co.uk/terms-and-conditions/
No. Name No. Name
1. RGB jump 6. RGB fade in and out
2. RGB smooth 7. RED fade in and out
3. 6 colour jump 8. GREEN fade in and out
4. 6 colour smooth 9. BLUE fade in and out
5. Color temperature smooth 10. WHITE fade in and out
Dynamic play mode presets
Troubleshoot
Problem Cause Corrective
No light • No power.
• Wrong connection or unsecure con-
nection.
• Check the power.
• Check the connection.
Wrong Colour • Wrong connection of RGBW wires. • Re trace and reconnect RGBW wires.
Uneven intensity
between front and
rear of the strip, with
voltage drop
• Output cable is too long.
• Cable diameter is too small.
• Overload beyond driver capability.
• Overload beyond receiver capability.
• Reduce cable or loop supply.
• Change to a thicker cable.
• Replace with a suitable higher power
driver.
• Add a power repeater.
No response
from the remote
• The battery has no power.
• Beyond controllable distance.
• The controller isn’t synchronised with
the remote.
• Replace battery.
• Reduce remote to receiver distance.
• Re-sync the remote.
Teucer (UK) Ltd
Bedford House, Fulham Green
69-79 Fulham High Street
London, SW6 3JW, UK
Tel: +44 (0)20 7350 4429
Fax: +44(0)20 7228 4647
www.teucerled.co.uk
sales@teucer.eu
Please note! RF technology allows for greater flexibility when it comes to controlling simple or complex lighting
installations without the need of additional cabling. There are some limitations where installations have the receivers
enclosed in electrical boxes or hidden away in a ceiling , reducing the RF signal strength and therefore the communication
range.
In order to overcome these RF Signal restrictions we suggest the following when synchronising our RF controllers and
receivers:
• Keep the distance within 10 meters from the controller to the receiver. The remote can operate up to 30 meters if
signal is uninterrupted by obstacles.
• When expanding your lighting, always try and use a signal repeater (PR-RGB(N)), where possible.
