Installation & Setup:
1.
Position the camera securely in place, it is best to have the monitor located near the
camera temporarily so you can see the exact position of the camera.
2.
Once you have camera in the correct position, mark the location of the screw holes.
3.
An extra hole may need to be placed for the power cable to run depending on your
installation.
4.
Fix the included screws and anchors to attach the camera to the wall or ceiling.
5.
Attach the wireless antenna to the rear antenna socket and screw in tightly.
6.
Connect the 9VDC, 600mA mains power adaptor to a 240VAC standard power
outlet, and the DC plug in to the power socket of the camera.
7.
Once the camera and monitor are powered on, the unit now should be displaying
thecamerafootage.
Please Note: Please install the camera in an undercover area if place outside as the unit
isweatherproofonly.
Operation:
Camera Setup:
This allows you to pair existing or additional cameras, turn the cameras on or off and adjust
the resolution as shown below:
Pairing:
Your camera is already pre-paired to the monitor on channel 1. When you add a new camera
to your system, you have to “pair” the camera and monitor to each other so they can
communicate. You can also use pairing to change one camera to a different channel if
required.
Please Note: If the camera is already assigned to the selected channel, pairing on the same
