Techone EPP-P51D Manuel utilisateur

Before operating this unit, please read these instructions completely.

Features:

1.Epp-P51D is epp fun fighter for outdoor flying.

2.made of High quality EPP material, it is very strong

, durable, easy to fly .

3.very easy to build , because most of the parts pre-

assembled in our factory already . You will see it

from the attached files.

Product Specifications

Fuselage length: 680mm (26.8in.)

Wingspan: 840mm (33.0in.)

Flying Weight:320-350g (with battery)

Motor: T2208 or T2212

ESC: 15-20Amp

Propeller: GWS 8040

Servo: 8g micro servo * 3pcs

Radio: 4/more channels

Battery: 11.1V 600-1000mAh Li-po 20C

Do not fly under the conditions as below

Wind strong enough to make the trees rustle

A street with many trees or street lamps

Close to high voltage electrical wires

High Population density areas

Cautions for flying

Large gyms, front lawns and parks make excellent

flying areas. Make sure you have permission to fly

and follow safety guidelines set by local authorities.

The calmer the wind, the better!

Note for Storage

Please disconnect the lipo packs when finished

flying

Do not press or crush the airplane when storing

The best way to store is to hang the airplane to keep

the control surface rigid

Recommended Flying Setup

Max servo travel of aileron:15degrees up and 15degrees

down（8mm）

Max servotravel ofelevator:15 degreesup and15 degrees

down(10mm)

Max servo travel of rudder:20degrees left and 20 degrees

right（15mm)

CG Position:

45-53mm from the leading edge of the wing,.

45－53mm

Body parts included in the packing

1 Fuselage 1pcs

2 Wing (right and left) 1pcs

3 Elevator (stabilizer) 1pcs

4 Rudder(vertical tail) 1pcs

parts included in the packing

1 Z bend 1.2mm*120mm 4pcs

2 Horn 4pcs

3 Pushrod connector 4pcs

4 Servo Mount 2pcs

5 Extention servo arm 1pcs

The items below are required for assembly

1.Use the reamer to expand the hole of the extention

servoarm,inordertoinstallthepushrodconnector.

2.Install the pushrod connector.

3.Put the servo into the servo hole of middle of the

wing, and then install the pushrod connector onto

the servo , fix it by using screws.

－1－

4.If the pushrod connector gear do not match

with the servo gear , pls use the above methods

to adjust so as to make it suitable.

5.Glue the servo into the servo hole by using CA.

6.Useaknifetocutahornslotsoastoinstalltheservo.

7.Firstly install the z-bend into the horn ,and then

glue the horn into the pre-cut slot.

8.Useascrewdrivertotightenthescrewofthe pushrod

connector.

80mm

－2－

ＡＢ

10.Glue the wing and the fuselage joined , each conjunction

should be glued together. Pls make sure A=B.

ＡＢ

11.Gluethehorizontalstabilizer,plsmakesureA=B.

12.Glue the vertical stabilizer into the fuselage.

9.Use same method to install the horn and pushrod

of the left and right aileron

－3－

14.Install the pushrod connector into the servo

arm , and then put the horn onto the servo.

15.Glue the servo mount into the servo hole of

the fuselage by using CA.

16.Use a knife to cut a elevator servo slot

17.Install the elevator horn and pushrod , the method

issameasinstallingaileronhornandpushrod.

18.Usethescrewdrivertotightenthepushrodscrew.

19.Install the servo into the servo mount by using

the servo screw which included into the servo

bag.

13.Install the servo arm.

－4－

20.Install the rudder servo,horn and pushrod,the

method issame as installing elevator servo, horn

and pushrod .

21.Connect the motor and ESC , Pls make sure the

motor running direction is correct , if not , pls

discretionarily exchange any two wires of the three

Wires .

22.Tighten the motor by using the screws which

includedintothemotorbag.

23.Install the ESC into the pre-cut slot of the

fuselage, install the battery pack into the next slot

of the ESC by using the velcro.

24.Install the ESC plug and servo wire plug into the

receiverslot ,andthen debug.

－5－

27.Use a O-ring to fix the propeller .

A perfect EPP-P51D is done after your careful

assembly. While assembly, the flying weight is

really critical to the flight performance and will be

affected by adding weight, so you should reduce

any unnecessary weight while assembly. Then

you’ll get the best flying performance.

25.Pls use the servo extention wire if the servo wire

isnotlongenough.

26.On the side of the fuselage , pls cut a suitable slot

by using knife , and then put the servo wire into the

slot,andtheninstallthereceiverintothepre-cutslot.

－6－

Autres manuels Techone Jouet

Techone

Techone Yak55 3D EPP Manuel utilisateur

Techone

Techone Yak55 3D EPP Manuel utilisateur

Techone

Techone 1300 Popwing Manuel utilisateur

Techone

Techone Yak54 EPP Manuel utilisateur

Techone

Techone Park-1100 EPP Manuel utilisateur

Techone

Techone Sukhoi EPP Manuel utilisateur

Techone

Techone Malibu III Manuel utilisateur

Techone

Techone Yak54-F3P Manuel utilisateur

Techone

Techone Arrow 3d Manuel utilisateur

Techone

Techone pulama 3D-EPP Manuel utilisateur

Techone

Techone P51 3D-EPP Manuel utilisateur

Techone

Techone P51 3D-EPP Manuel utilisateur

Techone

Techone Mini Popwing Manuel utilisateur

Techone

Techone Malibu III Manuel utilisateur

Techone

Techone rainbow-epp Manuel utilisateur

Techone

Techone MXS-HCF Manuel utilisateur

Techone

Techone Yak54 F3P Manuel utilisateur

Techone

Techone F-18 Manuel utilisateur

Techone

Techone BLUEFOX 2012 3D-HCF Manuel utilisateur

Techone

Techone leader 3D EPP Manuel utilisateur

Techone

Techone MANTH Manuel utilisateur

Techone

Techone AEROLUS F3P Manuel utilisateur

Techone

Techone Malibu2 F3P Manuel utilisateur

Techone

Techone Paiget II Manuel utilisateur

Manuels Jouet populaires d'autres marques

marklin

marklin 37321 Manuel utilisateur

Canon

Canon PAPER CRAFT Manuel utilisateur

GREAT PLANES

GREAT PLANES Pitts M-12S Manuel utilisateur

NOCH

NOCH 14261 Manuel utilisateur

Hausler

Hausler 450 SE V2 Manuel utilisateur

Dynaflite

Dynaflite Daydream Manuel utilisateur

MiniacRC

MiniacRC MIGHTY MINI P40 WARHAWK Manuel

Kenner

Kenner Batman 63651 Manuel utilisateur

LEGO

LEGO 8527 Manuel utilisateur

iKarus

iKarus ECO 8 Manuel utilisateur

Multiplex

Multiplex EasyStar II Mode d’emploi

Walkera

Walkera 38 Mode d’emploi

Hasbro

Hasbro TRANSFORMERS BUMBLEBEE Manuel utilisateur

MD MXION SWD Manuel utilisateur

Mattel

Mattel Disney Pixar Cars Cozy Cone Spiral Rampway Manuel utilisateur

marklin

marklin 39671 Manuel utilisateur

Meccano

Meccano 15103 Manuel utilisateur

LEGO

LEGO TECHNIC 8735 Manuel utilisateur