Teamline 5141 Installation Guide Page 8
Connecting Teamline 5141 to peripherals
Positioning the Teamline 5141 system
1. Choose an appropriate installation site:
lThe system must be accessible to ensure all cables are easily connected
lProvide ventilation for the system; leave a space of at least 10cm (4
inches) behind, in front, and to the left and right of the system
lUse a grounded AC power outlet for the system
2. Wall mount the system or place on a firm horizontal surface. For
information, refer to Mounting the Teamline 5141 system.
Connecting network cables
Using an Ethernet cable, connect the Network port on the rear of the system
to an Ethernet switch in your network. The Ethernet port is a 10/100/1000
Mbit/s auto-sensing port and is set to ‘auto’ by default.
Note: If your network doesn't support automatic detection, you can configure
the network speed manually. On the touchscreen controller that you have
connected to the system, go to settings > networking > network port speed
and select 100Mb/s (full).
Connecting the Teamline Touch
Using an Ethernet cable, connect the PoE Network port on the rear of the
touchscreen to an Ethernet switch in your network. The Ethernet port is a
10/100/1000 Mbit/s auto-sensing port and is set to ‘auto’ by default. The
touchscreen needs a switch/port that supplies PoE to function. For information
about configuring the Touch, see Configuring Teamline 5141.
Note: The speed and duplex settings at either end of the connection must be
identical. Using non-matching settings causes severe packet loss.
Connecting the camera and microphone
To connect the camera and microphone:
1. Connect the camera to either the USB 3.0 or USB 2.0 connector on the
Teamline system.
2. Connect one or two StarLeaf microphones to the USB connector(s).
For more information about microphones, see Microphone selection,
placement, and setup.
If you have a dual display system, it is recommended that the camera is
mounted on the display that contains the view of the main video. For more
information about cameras, see Using cameras with Teamline 5141.
