System Sensor DH100 Series Manuel utilisateur

Replacement Detector Boards

Ionization Detector Board: part number A5052

Photoelectric 2-Wire Detector Board: part number A5180

Photoelectric 4-Wire Detector Board: part number A5190

NOTE: PHOTOELECTRIC DETECTOR BOARDS CAN ONLY

BE INSTALLED IN PHOTOELECTRIC DUCT SMOKE

DETECTOR MODELS; IONIZATION DETECTOR BOARDS

CAN ONLY BE INSTALLED IN IONIZATION DUCT SMOKE

DETECTOR MODELS.

IMPROPER INSTALLATION WILL VOID ALL AGENCY APPROVALS.

Detector Board Replacement Instructions

1. Notify the proper authorities that the smoke detector system is undergoing

maintenance and that the detector will temporarily be out of service.

2. Turn off power to the duct smoke detector.

3. Remove the two detector board mounting screws.

Retain screws for installation of new board.

4. Pull gently on the board to remove it from the detector housing.

5. Align the board mounting features, holes, and interconnect terminals

with the features on the duct smoke detector housing.

6. Push the board into place.

7. Secure the board with the two board mounting screws.

8. Perform the detector checks as outlined in sections 6.2.1 and 6.2.2.1 of the Installation and Maintenance

Instructions to ensure proper detector operation. The tests performed must include:

A. Visually check to see the green power LED blinks once every ten seconds, indicating power to the duct

smoke detector. If the green LED does not flash, the detector lacks power (check wiring, panel or power

supply), the detector board is missing (install), or the unit is defective (return for replacement).

B. Perform the magnet test to initiate an alarm condition. Reset the detector using the local reset button,

remote accessory or system control panel.

Return all ionization boards to System Sensor for proper disposal: System Sensor

3825 Ohio Avenue

St. Charles, IL 60174

For additional assistance in this process or questions, please contact System Sensor Technical Service at

800-SENSOR2 (800-736-7672).

D100-71-00 1 I56-1359-01

DH100 Series Duct Smoke Detector

Replacement Detector Board

INSTALLATION AND MAINTENANCE INSTRUCTIONS

A Division of Pittway

3825 Ohio Avenue, St. Charles, Illinois 60174

1-800-SENSOR2, FAX: 630-377-6495

A5180/A5190: Photoelectric

Detector Board

A5052: Ionization

Detector Board

Replacement Power Boards

Two-Wire Power Board: part number A5061

Four-Wire Power Board: part number A5064

NOTE: TWO-WIRE POWER BOARDS CAN ONLY BE

INSTALLED IN TWO-WIRE DUCT SMOKE DETECTOR

MODELS; 4-WIRE POWER BOARDS CAN ONLY BE

INSTALLED IN 4-WIRE DUCT SMOKE DETECTOR MODELS.

IMPROPER INSTALLATION WILL VOID ALL AGENCY APPROVALS.

Replacement Power Board Installation Instructions

1. Notify the proper authorities that the smoke detector system is undergoing

maintenance and that the detector will temporarily be out of service.

2. Turn off power to the duct smoke detector.

3. Mark the location of all wires to the terminal block.

4. Disconnect all wiring from the terminal block.

5. Remove the two power board mounting screws. Retain screws for installation of new board.

6. Pull gently on the board to remove it from the detector housing.

7. Align the board mounting features, holes, and interconnect terminals with the features on the duct smoke

detector housing.

8. Push the board into place.

9. Secure the board with the two board mounting screws.

10. Reconnect all wiring to the terminal block.

11. Apply power to the duct smoke detector.

12. Perform the detector checks as outlined in sections 6.2.1 and 6.2.2.1 of the Installation and Maintenance

Instructions to ensure proper detector operation. The tests performed must include:

A. Visually check to see the green power LED blinks once every ten seconds, indicating power to the duct

smoke detector.

B. Perform the magnet test to initiate an alarm condition. Reset the detector using the local reset button,

remote accessory, removing power or system control panel.

For additional assistance in this process or questions, please contact System Sensor Technical Service at

800-SENSOR2 (800-736-7672).

D100-71-00 2 I56-1359-01

DH100 Series Duct Smoke Detector

Replacement Power Board

INSTALLATION AND MAINTENANCE INSTRUCTIONS

A Division of Pittway

3825 Ohio Avenue, St. Charles, Illinois 60174

1-800-SENSOR2, FAX: 630-377-6495

A5064: 4-Wire Power Board

A5061: 2-Wire Power Board

Table des matières

Autres manuels System Sensor Détecteur de fumée

System Sensor

System Sensor Innovair flex D4120A Manuel utilisateur

System Sensor

System Sensor 2251EIS Manuel utilisateur

System Sensor

System Sensor BEAM1224 Manuel utilisateur

System Sensor

System Sensor i3 Series Manuel utilisateur

System Sensor

System Sensor 2151 Manuel utilisateur

System Sensor

System Sensor B402B Manuel utilisateur

System Sensor

System Sensor InnovairFlex D4240 Manuel utilisateur

System Sensor

System Sensor 2351E Manuel utilisateur

System Sensor

System Sensor Innovair 200 Series Manuel utilisateur

System Sensor

System Sensor innovair flex D4120W Manuel utilisateur

System Sensor

System Sensor Innovair DH100LP Manuel utilisateur

System Sensor

System Sensor 2012H Manuel utilisateur

System Sensor

System Sensor Innovair SSK451 Manuel utilisateur

System Sensor

System Sensor 2112 Manuel utilisateur

System Sensor

System Sensor Inovair Flex D4240 Manuel utilisateur

System Sensor

System Sensor 2251-COPTIR Manuel utilisateur

System Sensor

System Sensor 2451, 2451TH Manuel utilisateur

System Sensor

System Sensor DH100ACDCLP Manuel utilisateur

System Sensor

System Sensor DH400ACDCP Manuel utilisateur

System Sensor

System Sensor A05-1003-002 Guide de l'utilisateur

System Sensor

System Sensor DH400ACDCIHT Manuel utilisateur

System Sensor

System Sensor 2412 Manuel utilisateur

System Sensor

System Sensor FAAST 7100X Manuel utilisateur

System Sensor

System Sensor BEAM200S Manuel utilisateur

Manuels Détecteur de fumée populaires d'autres marques

x-sense

x-sense SD19-W Manuel utilisateur

BRK electronic

BRK electronic First Alert P1010 Manuel utilisateur

FireAngel

FireAngel Thermoptek ST-622 Manuel utilisateur

teko

teko Astra-42A Manuel utilisateur

Safetec

Safetec SDS-2/6 Manuel du propriétaire

Siemens

Siemens PE-11C Manuel utilisateur

Resolution Products

Resolution Products RE612 CryptiX Manuel utilisateur

First Alert

First Alert PC900V Manuel utilisateur

Eminent

Eminent EM6590 E-Domotica Manuel utilisateur

Ei Electronics

Ei Electronics Ei Ei168RC Manuel utilisateur

Carrier

Carrier Kidde Quell Q301 Manuel utilisateur

VESDA

VESDA VLF-500 Manuel utilisateur

ELRO

ELRO FS8110 Manuel utilisateur

Heiman

Heiman SMOKI NS-626PHS Manuel utilisateur

Regin

Regin SDD-S65 Manuel utilisateur

Family Gard

Family Gard FG225 Manuel utilisateur

Greystone

Greystone DSD120 Manuel utilisateur

Aparton

Aparton ASD-10 Manuel utilisateur