
2
SVR Tracking Installation Guide
Tools Required:
Screwdriver, wire-stripper, cuer,
crimping tool, voltmeter
Quick Installation Guide
SVR Tracking FJ110 Series
Includes:
• GPS Device, Power harness
• Second ESN/ IMEI Label
1. Connect power harness to device
- Refer to the image on the right.
Connect the wire to the pins on the
side of the device.
2. Find a source of CONSTANT +12V
Power near the dashboard of the
car - wiring details for your vehicle can
be found on www.the12volt.com if
needed.
3. Test the source of power with
voltmeter - make sure that the mul-
meter shows ~12V between your
source and chassis ground.
Note: Ignion switch posion, open/ closed doors,
on or o lights or accessories should not be taken
into account
4. Connect the RED power wire to the
power source with your
preferred
connector type/solder. Make sure
not to permanently disconnect the
12V source to other circuits in the
vehicle.
Power Wire
Ground
Wire
Connect to device
Device pins
5. Connect the BLACK ground wire to a
source of chassis ground. This can be
another grounded wire/clean metal
connection to the chassis of the
vehicle. Make sure that the ground
connection is not connected to any
other circuit in the vehicle.
Installaon Instrucons
(Addional: Connectors, tape, zip-es)