Super Circuits Micro-d Manuel utilisateur

MICRO-D Full Manual V.1.2

H.264 DVR

MICRO-D

Installation &

User’s Manual

※

The contents of the manual can be modified without prior notice to customers

MICRO-D Full Manual V.1.2

GENERAL SAFETY AND PRECAUTIONS

The MICRO-D is manufactured to meet international safety standards. Read the following safety

precautions to avoid injury and prevent damage to the MICRO-D or any products connected to it.

1. Use a correct power source. Do not connect this product to a power source that supplies more

than the specified voltage (DC12V), as this will cause damage to the unit.

2. Never insert anything metallic into the MICRO-D as this can cause electric shock.

3. Do not operate in wet & dusty conditions. Keep product surfaces clean and dry. Avoid placing the

MICRO-D in areas like a damp basement or a dusty hallway.

4. Do not expose this product to rain or use near water. If the product gets wet, unplug it and

contact an authorized dealer immediately.

5. To clean the outside case of the MICRO-D, use a lightly dampened cloth (no solvents).

6. Do not operate if you suspected to unit is faulty. If there are any unusual sounds or smells

coming from the MICRO-D, immediately unplug it and contact an authorized dealer or service

centre.

7. Do not attempt to remove the top cover.

8. Warning: Removing the MICRO-D’s cover can cause an electrical shock.

9. Handle MICRO-D carefully to avoid damaging the product. Dropping your MICRO-D on any hard

surface may cause the unit to malfunction. If the MICRO-D does not work properly due to

physical damage, contact an authorized dealer for repair or exchange.

10.The unit has a lithium battery preinstalled.

The standard lithium cell 3V battery located on the motherboard should be replaced if the time

clock does not hold its time after the power is turned off.

Warning:

Unplug the MICRO-D before replacing battery or you may be subjected to severe electrical shock.

Properly dispose of old batteries.

Caution:

Risk of explosion if battery is replaced by an incorrect type. Do not discard lithium batteries into the

trash can or into fire. Dispose in accordance with local waste regulations.

Information to user

The user’s manual or instruction manual for an intentional or unintentional radiator shall caution the

user that changes or modifications not expressly approved by the party responsible for compliance

could void the user’s authority to operate the equipment.

MICRO-D Full Manual V.1.2

TABLE OF CONTENTS

Chapter 1: Packing Contents

CONTENTS IN THE PACKAGE 5

Chapter 2: Getting To Know Your MICRO-D

MICRO-D 6

Chapter 3: Remote control

REMOTE CONTROL PANEL 8

Chapter 4: Getting Started

OVERVIEW OF SET UP PROCEDURES 10

Chapter 5: Hardware Installation

SD MEMORY INSTALLATION 11

CONNECTING MICRO-D TO YOUR TV SET OR MONITOR 11

ALARM INSTALLATION 13

Chapter 6: OSD MODE

1. ACCESS TO OSD MENU 14

2. MAIN MENU 14

3. SYSTEM SETUP

3.1 TIME & DATE OVERLAY

3.2 TIME SET > DAY LIGHT SAVING

3.3 LANGUAGE SETUP

3.4 VIDEO OUTPUT

3.5 BRIGHTNESS:

4. VIDEO SETUP

4.1 RESOLUTION

4.2 VIDEO QUALITY

4.3 FRAME RATE

4.4 PRE RECORDING TIME

4.5 POST RECORDING TIME

4.6 AUDIO RECORDING

4.7 AUTO RECORDING

4.8 DISK OVERWRITE

MICRO-D Full Manual V.1.2

5. EVENT SETUP

5.1 ALARM SETUP

5.1.1 ALARM INPUT

5.1.2 INPUT TYPE

5.1.3 ALARM OUTPUT

5.1.4 ALARM CONTINUE

5.2 MOTION DETECTION

5.2.1 SENSITIVITY

5.3 SCHEDULE SETUP

5.3.1 TIME

5.3.2 TIME AND EVENT

6. SUB MENU

6.1 PASSWORD CHANGE

6.2 FILE INDEX RENEW

Chapter 7: SCREEN MODE

1. LIVE SCREEN MODE

1.1 SCREEN MESSAGE

1.2 SCREEN ICON

2. SEARCH MODE

2.1 SEARCH LIST

2.2 SEARCH FACTOR

2.2.1 SEARCH FACTOR – TIME

2.2.2 SEARCH FACTOR – EVENT

2.2.3 SEARCH FACTOR – BOTH

2.2.4 SEARCH FACTOR – NONE

2.3 PLAYBACK SCREEN VIEW

Appendix:

TECHNICAL SPECIFICATIONS 24

APPROXIMATE RECORDING TIME TABLE

MICRO-D Full Manual V.1.2

Chapter 1: Packing Contents

▶Contents in the package

MICRO-D Main Unit Remote Controller AV-IN / AV-OUT Connector

Terminal Block 12V Power Supply Installation CD

Quick Guide Max. 32GB SD card

Can be used(Option)

SD Reader (Option)

MICRO-D Full Manual V.1.2

Chapter 2: Getting To Know Your MICRO-D

▶MICRO-D

This chapter briefly describes the functions of each button on MICRO-D. The buttons are used to operate

the basic functions of MICRO-D, such as recording, playback, fast-forward, reverse play and etc. For more

details on the set-up and operation of MICRO-D, refer to Chapter 6, MICRO-D MENU.

①

②

③⑤

⑥

⑦

⑧⑨ ⑩

④

MICRO-D Full Manual V.1.2

1Sensor-in / Alarm-out

The sensor terminal block is used to connect a sensor such as PIR to the MICRO-D. If you add motion

sensor devices to your MICRO-D, the video recording can be triggered by event.

The alarm output terminal is used to install a single alarm device.

2SD Memory Slot

Insert SD Card into the slot for storing data.

3Recording LED

This light indicates while MICRO-D is on recording mode.

4Status LED

This light blinks when events occur or there is any error..

5Power LED

This light indicates the MICRO-D is powered up.

6Remote control Receiver

When controlling MICRO-D by remote control, be sure to point at the receiver.

7Reset

Press the reset button if you want to return setting values to the default.

8AV-IN

Connect AV-IN connector

9 AV-OUT

Connect AV-OUT connector

10 Power

Connect 12V power supply in the package.

MICRO-D Full Manual V.1.2

Chapter 3: Remote control

1 REC

Start MICRO-D recording or stops recording.

Turn the SD power off when pressing the REC button for 3 seconds.

(Recording can resume after 20 seconds)

2 MENU Enter OSD menu.

On OSD menu, go to the upper menu.

UP/

DOWN

On OSD menu, change values.

On search mode, play the previous or next recorded file.

LEFT/

RIGHT

REW: Fast Rewind (X2-X4-X8-X16)

FF: Fast Forward (X2-X4-X8-X16)

On OSD menu, chooses menu fields and change values.

5 REW REW: Fast Rewind (X2-X4-X8-X16)

6 FF FF: Fast Forward (X2-X4-X8-X16)

7 PLAY Playback at X1

8 STOP Stop playback. On playback mode, go back to the first frame.

9 PAUSE Pause playback or resume playback.

10 MUTE Remove Audio.

MICRO-D Full Manual V.1.2

ENT On playback mode, playback at X1.

On OSD menu, enter values.

12 SEARCH Enter Search menu.

On search menu, move to upper search menu.

13 MODE Switch between playback mode and live view mode.

Remote Controller Functions of LIVE MODE and PLAY Remote PLABACK MODE

Function LIVE PLAY BACK

Stand-by Recording Stand-by Play Menu Remark

RECORD O O X X X

O: Available

X: N/A

MENU OXO O O

SEARCH O X O O X

MODE O X O O O

UP X X O O O

DOWN X X O O O

REW(LEFT) X X X O O

FF(RIGHT) X X X O O

ENT X XO OO

REW X X X O O

FF X X X O O

PLAY X X O O O

STOP XXXOX

PAUSE XXXOX

MUTE XXXOX

MICRO-D Full Manual V.1.2

Chapter 4: Getting Started

OVERVIEW ON SET-UP PROCEDURES

Below is an overview of the MICRO-D installation procedures, (A detailed explanation is found in

Chapter 5 - Hardware Installation.)

(1) Insert a SD MEMORY.

(2) Connect MICRO-D to a TV set or MONITOR.

(3) Connect camera to MICRO-D

(4) Connect optional accessories (sensors or alarm).

(6) Connect the power.

(7) Turn the power on.

(8) Start TV Monitoring and recording.

GeneralOperatingAdvice:

●Make sure that a SD Memory is inserted and one camera is properly connected.

(See Chapter 5 -Hardware Installation)

●The SD Memory Format setting must be set (Refer to Chapter 5 – SD Memory Installation for more

information.) Otherwise, MICRO-D may not recognize the SD Memory.

●The firmware used in MICRO-D is compatible with your computer’s operating system (i.e. Windows).

Therefore, you can take the SD memory card from this MICRO-D and install it in your computer to view

recorded video. (Refer to the PC Viewer manual.)

●MICRO-D offers you the flexibility to choose a recording frame rate (maximum rate: 30 frames per second).

A faster frame rate provides more natural video images in recorded video files. However, it requires more SD

Memory storage. You may reduce the frame rate (minimum rate: 1 frame per second) to fit longer recording

sessions in consideration of your SD card capacity.

●If a camera is normally connected to MICRO-D, it enters the default operational state: VIEW mode. In this

mode, MICRO-D does not record nor play the recorded stream. It just shows the current images from camera

connected to MICRO-D.

●The default values of MICRO-D for recording are set up at 30 frames per second with High video quality.

If you use 1GB SD Memory, MICRO-D can record approximately for 2 hours in a row.

●There is an exception to entering the VIEW mode at start up. If the power is abnormally turned off while

MICRO-D is performing emergency recording (i.e. a power failure), it will enter recording mode automatically

when you reboot MICRO-D.

Refer to Chapter 5 - Hardware Installation for more information on installation procedures.

Table des matières

Autres manuels Super Circuits DVR

Super Circuits

Super Circuits DMR81U Manuel utilisateur

Super Circuits

Super Circuits DVRM6 Manuel utilisateur

Super Circuits

Super Circuits MDVR-10 Manuel utilisateur

Super Circuits

Super Circuits DMR40DVD Manuel utilisateur

Super Circuits

Super Circuits DVQ-2 Manuel utilisateur

Super Circuits

Super Circuits MDVR81 Manuel utilisateur

Super Circuits

Super Circuits ATX-GSM Manuel utilisateur

Super Circuits

Super Circuits BLACK BLK-DH200400D Manuel utilisateur

Super Circuits

Super Circuits MDVR21SD Series Manuel utilisateur

Super Circuits

Super Circuits DMR4 Manuel utilisateur

Super Circuits

Super Circuits MDVR16 Manuel utilisateur

Super Circuits

Super Circuits MDVR14-3 Manuel utilisateur

Super Circuits

Super Circuits DMR7X Series Manuel utilisateur

Super Circuits

Super Circuits MDVR21P Manuel utilisateur

Super Circuits

Super Circuits DMR8CD-3 Manuel utilisateur

Super Circuits

Super Circuits MDVR-14 Manuel utilisateur

Super Circuits

Super Circuits mdvr50 Manuel utilisateur

Super Circuits

Super Circuits DMR27U Manuel utilisateur

Super Circuits

Super Circuits DVQ19 Manuel utilisateur

Super Circuits

Super Circuits MDVR-14 Manuel utilisateur

Super Circuits

Super Circuits DVQ-2 Manuel utilisateur

Super Circuits

Super Circuits DVR Guide de l'utilisateur

Super Circuits

Super Circuits DVRM6 Manuel utilisateur

Super Circuits

Super Circuits 4CH MJPEG DVR Manuel utilisateur

Manuels DVR populaires d'autres marques

FLIR

FLIR M3100E Series Manuel utilisateur

VTRACKPRO

VTRACKPRO FPRO300 Manuel utilisateur

Swann

Swann NVR-7085 models Manuel utilisateur

XtendLan

XtendLan DVR-1670C Manuel utilisateur

urmet domus

urmet domus 1093/004AHD Manuel utilisateur

Holux

Holux M1 Manuel utilisateur

CMOS DOTCOM

CMOS DOTCOM ANX-1670 Manuel utilisateur

Whistler

Whistler D16VRS Manuel utilisateur

Defender Security

Defender Security 82-20235 Manuel utilisateur

MISUMI

MISUMI MP-WF100M Manuel utilisateur

Speco

Speco D8HU Manuel utilisateur

UST

UST DDR-E04AA Instructions d'utilisation

Consolidated

Consolidated Digital Video Recorder Manuel utilisateur

Mace

Mace DVR0404RW Guide de démarrage rapide

RCA

RCA RTD315W Manuel utilisateur

FSM

FSM Colibri Grande PRO Manuel utilisateur

Hauppauge

Hauppauge HD PVR 2 Manuel utilisateur

Identivision

Identivision ICR-PH161i PIONEER Manuel utilisateur

Super Circuits micro-d Manuel utilisateur

Manuels DVR populaires d'autres marques