SunStar SC18M Manuel utilisateur

Form #43127350

-1- July 09

INSTALLER: Leave this manual with the appliance.

CONSUMER: Retain this manual for future reference.

OPTIONAL MANUAL BLOWER ASSEMBLY

No. SC18M

INSTALLATION INSTRUCTIONS

(for Heater Models SC18T-1, SC18M-1)

GENERAL INFORMATION

This series is design certified by the CSA Laboratories as an Unvented Heater, and must

be installed according to these instructions.

ANY ALTERATION TO THE ORIGINAL DESIGN, INSTALLED OTHER THAN AS

SHOWN IN THESE INSTRUCTIONS, OR USED WITH A TYPE OF GAS NOT SHOWN

ON THE RATING PLATE IS PROHIBITED AND VOIDS THE WARRANTY.

Theinstallationmustconform tolocal codes. Inthe absenceof localcodes,theinstallation

must conform to the National Fuel Gas Code, also known as NFPA 54 and ANSI Z223.1-

latest edition.

This is a heating appliance. Any safety screen or guard removed for servicing the

appliance must be replaced prior to operating the appliance.

These instructions cover the installation of an accessory blower into a new heater prior to

installation. If the Heater is already installed then thefollowinginstructions shallbereferred

to for the removal and re-installation of the heater.

Form Number Heater Model

#43126220 SUNSTAR SC18T-1

#43126210 SUNSTAR SC18M-1

Before continuing to remove the heater, seek a qualified service person to disconnect the

gas.

READ ALL THE INSTRUCTIONS THOROUGHLY BEFOREINSTALLING THE BLOWER.

Form #43127350

-2- July 09

INSTALLING OPTIONAL BLOWER

1. Check contents of the carton before proceeding with the installation.

KIT NO. 43740580 – for Heaters SC18T-1, SC18M-1

ITEM

NO. PART NO. DESCRIPTION QTY ITEM

NO. PART NO. DESCRIPTION QTY

1) 43555130 Blower/Motor Sub-assembly 1 7) 30512020 Open/Closed Bushing 1

2) 30516010 Slide Terminal Receptacle 2 8) 30513010 Cord Retainer 1

3) 30517010 Snap Plug Receptacle 1 9) 43556010 Mounting Bracket, L-shaped 1

4) 02315010 Sheet Metal Screw, 3/8” long 9 10) 43563010 Cord Set Sub-assembly 1

5) 02261030 Grounding Screw, Green 1 11) 41161010 Wire, Violet 15” 2

6) 30381000 Fan Control Switch - Manual 1

2. Lay the heater on a flat surface and remove the 2 screws from each side and lift cover

off.

Step 1. remove both screws

Phillips Head Screw

Step 2.

Lift Cover up

Step 3.

Lift Cover off

Form #43127350

-3- July 09

3. Push out plug and replace with the fan control switch.

4. Turn the heater over, assemble the cord retainer and insert through the back of the

heater.

Fan control switch

(manual on off)

Form #43127350

-4- July 09

5. Turnthe heaterover again,insertthe plasticbushingintothe“L”Bracket andattachit to

the heater.

6. Lay down the blower beside the heater and pass the 3 wires through the plastic

bushing.

Blower

Form #43127350

-5- July 09

9. Make electrical connections shown in the diagram below.

If any original wire, as supplied with this appliance, has to be replaced, it must be replaced

with #18 gauge, 125ºC, 2/64 insulation or its equivalent.

Caution: Label all wires prior to disconnection when servicing controls. Wiring errors can

cause improper and dangerous operation.

Verify proper operation after servicing.

120V

Violet

Fan Control

Switch

White Black

Blower

Motor

WIRING SCHEMATIC DIAGRAM

OPTIONAL BLOWER

Form #43127350

-6- July 09

10. Carefully insert the blower assembly under the lip of the heat shield and rotate into

place.

Heat shield

Blower case

Blower assembly

11. Lower the blower into the heater and secure both ends with sheet metal screws.

Form #43127350

-7- July 09

12. Replace the heater cover.

STEP 1. Insert tabs along the top edge of the cover into the slots.

STEP 2. Rotate the cover down.

STEP 3. Insert the tabs on both sides of the heater into the lower slots.

STEP 4. Attach the cover with the original screws.

FAN CONTROL – Manual (on/off)

To operate the fan, plug the power cord into a 120-Volt outlet and turn the switch to the

“On” position. See diagram of operating sequence below.

LIGHTING INSTRUCTIONS

1. Stop! Read the safety information above.

2. Set the thermostat (gas control knob)

clockwise to OFF position.

3. Turn off all electric power to the appliance.

4. Wait ten (10) minutes to clear out any gas.

Then smell for gas near the heater and at

the floor beneath the heater. If you smell

gas STOP! Follow B in the safety

information above. If you do not smell

gas, go to the next step.

5. Turn knob on gas control counterclockwise

to P PILOT. Push in control knob

to stop and hold.

6. Repeatedly push the piezo ignitor button

until the pilot is lit (a match can also be

used to light pilot buner). Continue to hold

the control knob in for about 10 to 15

seconds after the pilot is lit. Release

knob and it should pop back up. Pilot burner

should remain lit. If it goes out repeat

procedure 6.

If knob does NOT pop up when released

STOP! turn off gas supply and immediately

call your service technician or gas supplier.

If the pilot will not stay lit after several tries,

turn the gas control clockwise

to OFF and call your service technician

or gas supplier.

7. When the pilot burner remains lit turn the

gas control knob counterclockwise

to HI (high) position.

8. Turn on all electric power to the appliance.

9. Thermostat (gas control knob) can be set to

desired setting from HI to LO.

10.ATTENTION: Gas control has an interlock

latching device. When the pilot burner

remains lit a safety magnet is energized and

the interlock latching device becomes

operative. If the gas control is turned to the

OFF position or gas flow to the appliance

is shut off DO NOT RELIGHT THE PILOT

BURNER until the safety magnet is de-

energized (approximately 60 seconds).

There will be an audible click when the

safety magnet in the control is de-energized.

Pilot burner can now be relit by repeating

steps 3 thru 6 above.

OFF

Ignitor

Piezo

Electrode

Pilot

Burner

Thermocouple

Pilot is located

in the center

below the

glass front

OFF

Ignitor

Piezo

TO TURN OFF GAS TO

APPLIANCE

Turn the thermostat (gas control knob)

clockwise to the OFF position.

Do not use excessive force when turning

knob.

Turn off all electric power to the appliance.

Step 1 Step 3 Step 4 Step 2

T0 T1 T2 T3 T4 T5

Ignition

Gas valve

Manual Ignition

Heater thermostat ON

Gas Valve OPEN

Manual Switch ON

Blower ON

Pilot Flame

Thermostat (heater)

Manual Switch (fan)

Blower

Heater Thermostat OFF

Gas Valve CLOSE

Manual Switch OFF

Blower OFF

Legend: Function ON: Function OFF:

Form #43127350

-8- July 09

CLEANING

The blower wheel will collect lint and could require cleaning once a year. If the air output

decreases, or the noise level increases, it indicates a dirty wheel. Clean the blower wheel

with a vacuum cleaner or apply high-pressure air to the blower wheel.

NOTE !

Unplugging of blower accessory will not stop the heater from cycling. To shut the

heater off, turn the control knob to "OFF".

WIRING

WARNING

Electrical Grounding Instructions

This appliance is equipped with a three-prong (grounding) plug for your protection against

shock hazard and should be plugged directly into a properly grounded three-prong

receptacle.

The appliance, when installed, must be electrically grounded in accordance with local

codes,or inthe absenceof localcodes, withthe NationalElectrical CodeANSI/NFPA#70-

latest edition.

DO NOT cut or remove the grounding prong from this plug. For an ungrounded

receptacle,an adapter(which hastwo prongsandawireforgrounding)canbe purchased,

plugged into theungrounded receptacle and itswire connected tothereceptacle mounting

screws. With this wire completing the ground, the appliance cord can be plugged into the

adapter and be electrically grounded.

SUNSTAR HEATING PRODUCTS, INC.

Post Office Box 36271 (28236) 306 West Tremont Avenue (28203)Charlotte, North Carolina

Phone (704) 372-3486 Fax (704) 332-5843 Toll Free (888) 778-6782

www.sunstarheaters.com email: [email protected]

Ce manuel convient aux modèles suivants

Table des matières

Autres manuels SunStar Chauffage

SunStar

SunStar ECLIPSE SIR25 Manuel utilisateur

SunStar

SunStar SGM3 Manuel utilisateur

SunStar

SunStar SPS SERIES Manuel utilisateur

SunStar

SunStar SC18T-1-NG/LP Mode d’emploi

SunStar

SunStar SGM3 Manuel utilisateur

SunStar

SunStar STARGLO Series Manuel utilisateur

SunStar

SunStar SC18T Manuel utilisateur

SunStar

SunStar ECLIPSE Manuel du propriétaire

SunStar

SunStar SPS 40-N5 Manuel utilisateur

SunStar

SunStar SGM3 Manuel utilisateur

SunStar

SunStar STARGLO SG3-N5B Manuel utilisateur

SunStar

SunStar SC30T Manuel utilisateur

SunStar

SunStar SPS Series Manuel du propriétaire

SunStar

SunStar SC10T-1-NG Mode d’emploi

SunStar

SunStar RCH100 Manuel utilisateur

SunStar

SunStar CK18M-4-NG/LP Mode d’emploi

SunStar

SunStar SGL35-N7 Manuel du propriétaire

Manuels Chauffage populaires d'autres marques

oventrop

oventrop Regucor Series Manuel utilisateur

Blaze King

Blaze King CLARITY CL2118.IPI.1 Manuel utilisateur

ELMEKO

ELMEKO ML 150 Manuel utilisateur

BN Thermic

BN Thermic 830T Manuel utilisateur

KING

KING K Series Mode d’emploi

Empire Comfort Systems

Empire Comfort Systems RH-50-5 Guide de démarrage rapide

Well Straler

Well Straler RC-16B Manuel utilisateur

EUROM

EUROM 333299 Manuel utilisateur

Heylo

Heylo K 170 Manuel utilisateur

Eterna

Eterna TR70W Manuel utilisateur

Clarke

Clarke GRH15 Mode d’emploi

IRSAP

IRSAP The Radiator Company Ovali Manuel utilisateur

Empire Heating Systems

Empire Heating Systems WCC65 Manuel utilisateur

Wetekom

Wetekom 92 86 43 Manuel utilisateur

Desa

Desa SPC170-F Manuel utilisateur

Watlow

Watlow Watrod Electric Tubular Heaters Manuel utilisateur

Haverland

Haverland ECO-DRY GPS Series Manuel de la liste des pièces

Stelpro

Stelpro ASILVC2060 Series Manuel utilisateur