SunSetter 900XT Manuel utilisateur

Operation Instructions

Top Front

Setup

Place the loop of cord (attached to the grommet on the back of the panel) over the rail hook you installed on the

awning rail.

The installation holes for the weatherbreaker side are already in place in the roller bar on your awning. On the roller bar,

locate the round cream-colored sticker near the two ends of the fabric that cover the installation holes and remove

them. (the roller bar contains the installation holes for every accessory that we offer, only remove the stickers for the

accessory that you are using). Insert the spring clip by first squeezing the center. This will allow you to insert the two

hooks into the hole in the roller bar.

Tighten the panel by holding the sides of the cord-lock and

pulling the cord as shown. (See Figure 6)

Removal

Slide the wheel on the turnbuckle back to loosen the cord.

Remove the spring clip from the roller bar by squeezing

the center.

Remove the cord loop from the rail hook on the house.

Adjustment

To adjust how far away from the house the weather breaker mounts, a second knot can be tied in the cord that is

attached to the rail hook, to shorten the distance between the panel and the house.

Cord-lock Cord-lock

Loop End

Spring Clip Spring Clip

Grommet

Pull Tight

Rev 12/05/05

Figure 4 Figure 5

WARNING - When leaving the awning open unattended, even with the Weather Breaker installed, you must lower one arm

or both to create enough drop (front to back) to prevent rain from accumulating on the fabric. If the awning is used with

both arms in the vertical position, you must bring at least one arm back to the wall bracket, and then lower it.

©SunSetter Products, a Massachusetts Limited Partnership, 184 Charles Street, Malden MA 02148

8. Slide the loop end of the cord through the round hole in the spring clip and then through the top front grommet as shown in

figure 4. (Outside of arc to inside of arc).

9. Slide the knotted end of the cord, the cord-lock and spring clip, through the loop of cord on the other side of the grommet as

shown in figure 5. Pull the rope tight.

Top Front

Pull cord

while holding

cord-lock

to tighten

Squeeze

Spring Clip

together

Figure 6

Cord-lock

Awning

Autres manuels pour 900XT

Ce manuel convient aux modèles suivants

Table des matières

Autres manuels SunSetter Accessoires

SunSetter

SunSetter Oasis Manuel d'utilisation et d'entretien

SunSetter

SunSetter Motorized PRO Mode d’emploi

SunSetter

SunSetter 900XT Manuel utilisateur

SunSetter

SunSetter Oasis Mode d’emploi

SunSetter

SunSetter EASYSHADE Mode d’emploi

SunSetter

SunSetter Motorized Series Instructions originales

SunSetter

SunSetter Wireless Wind Sensor Manuel utilisateur

SunSetter

SunSetter VISTA Guide de démarrage rapide

SunSetter

SunSetter Oasis Mode d’emploi

SunSetter

SunSetter 900XT Manuel utilisateur

SunSetter

SunSetter OASIS Series Manuel utilisateur

SunSetter

SunSetter Oasis Mode d’emploi

SunSetter

SunSetter Gaviota Guide de démarrage rapide

SunSetter

SunSetter Platinum Plus Series Instructions originales

SunSetter

SunSetter VISTA Instructions originales

SunSetter

SunSetter EASYSHADE Instructions originales

SunSetter

SunSetter Oasis Mode d’emploi

SunSetter

SunSetter PRO Instructions d'utilisation et de sécurité

SunSetter

SunSetter EASYSHADE Manuel d'utilisation et d'entretien

SunSetter

SunSetter Platinum Plus Mode d’emploi

SunSetter

SunSetter 900XT Manuel d'utilisation et d'entretien

SunSetter

SunSetter Oasis Mode d’emploi

SunSetter

SunSetter EASYSHADE Manuel d'utilisation et d'entretien

SunSetter

SunSetter 900XT Guide d'installation

Manuels Accessoires populaires d'autres marques

Hillco

Hillco 2810 Manuel utilisateur

Siemens

Siemens QSA2700D Manuel de l'opérateur

Contours

Contours ZY024 Manuel utilisateur

Saivod

Saivod VS621 Manuel utilisateur

Virtuox

Virtuox VirtuCLEAN 2.0 Manuel utilisateur

SCE

SCE ENVIRO-THERM SCE-TE170B24VSS Manuel utilisateur

Z-Wave

Z-Wave HSD-200Z Manuel utilisateur

turck

turck FMX-IM-2UPLI63FX Manuel utilisateur

Decagon Devices

Decagon Devices 10HS Manuel utilisateur

UPPAbaby

UPPAbaby Cup Holder Manuel utilisateur

Elko

Elko SmartSensor Leakage Wireless Manuel utilisateur

Grizzly

Grizzly H8371 Manuel utilisateur

Panasonic

Panasonic HG-T Series Manuel utilisateur

IFM Electronic

IFM Electronic Efector 250 Series Guide de référence

DigiDesign

DigiDesign 888/24 I/O Manuel utilisateur

PROZIS

PROZIS QUAY Manuel utilisateur

patagonia

patagonia PSI Vest Manuel utilisateur

SFC Energy

SFC Energy EFOY GO! Manuel utilisateur