Sunbeam 3040 Manuel utilisateur

When using your iron, basic safety precautions should

always be followed, including the following:

READ ALL INSTRUCTIONS BEFORE USE.

Use iron only for its intended use.

To protect against risk of electric shock, do not

immerse the iron in water or other liquids.

The iron should always be turned to “OFF”

before plugging or unplugging from outlet.

Never yank cord to disconnect from outlet;

instead, grasp plug and pull to disconnect.

Do not allow cord to touch hot surfaces.

Let iron cool completely before putting away.

Loop cord loosely around iron when storing.

Always disconnect iron from electrical outlet

when filling with water or emptying and when

not in use.

Do not operate iron with a damaged cord or if

the iron has been dropped or damaged. To avoid

the risk of electric shock, do not disassemble the

iron. Take it to an authorized service center for

examination and/or repair. Incorrect reassembly

can cause a risk of electric shock when the iron

is used.

Close supervision is necessary for any appliance

being used by or near children. Do not leave

iron unattended while connected or on an

ironing board.

Burns can occur from touching hot metal parts,

hot water or steam. Use caution when you turn

a steam iron upside down

there may be hot

water in the reservoir.

.If the iron is not operating normally, disconnect

from the power supply and have the iron

serviced by an authorized

serwce

center.

lYour SUNBEAMa iron is

deslgned

to rest on

the heel rest. Do not leave the iron unattended.

Do not set the iron on an unprotected surface,

even if it is on its heel rest.

SPECIAL INSTRUCTIONS

lThis is a 1200.Watt appliance.” To avoid a

circuit overload, do not operate another high

wattage appliance on the same circuit.

.If an extension cord is absolutely necessary, a

IO-ampere cord should be used. Cords rated

for less amperage may overheat. Care should be

taken to arrange the cord so that it cannot be

pulled or tripped

over.

For products purchased in the United States

and Canada only

To reduce the risk of electrical shock, this appliance

has a polarized plug (one

blade

is wider than the

other). This plug fits a polarized outlet only one

way; if the plug does not fit fully into the outlet,

reverse the plug. If it still does nor fit, contact a

qualified electrician. Do not attempt to defeat this

safety feature.

SAVE THESE

INSTRUCTIONS

Welcome......................................3

Learning About Your Iron.. . . . . . . . . . . . . . . . . . . . . . .

Filling the Water Reservoir . . . . . . . . . . . . . .

Extending the Power Cord . . . . . . . . . . . . .

Ironing . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .: . . . .

Dry Ironing . . . . . . . . . . . . . . . . . . . . . .7

Steam Ironing . . . . . . . . . . . . . . . . . . . . . . .7

Using the Iron’s Special Features.. . . . . . . . . . . . . . . . .

SPRAY MIST . . . . . . . . . . . . .

SHOT OF STEAM (Mode/ 3040 only). . . . . . . . . .8

Vertical Steam (Model3040 only) . . . . . . . . . . . . . . . .9

Patented MOTION

SMARrPM

Auto-Off. . . 10

Caring for Your Iron After Use.. . . . . . . . . . . . . . . . . . . 11

Turning Off Your Iron

. . . . . . . . . . . . . . . . 11

Storing Your Iron

. . . . . . . . . . . . . . . . . . . . . . . . . .

Maintaining Your Iron.. . . . . . . . . . . . . . . . . . . . . . . . . .12

Cleaning the Soleplate . . . . . . . . . . . . . . . .12

Using the Self-Cleaning Feature . . . . . . . . . . 12

Ironing Tips and Guide.. . . . . . . . . . . . . . . . . . . . . . . . .15

ironing lips . . . . . . . . . . . . . . . . . . . . .15

Ironing Guide.. . . . . . . . . . . . . . . . . . . . . . . . .16

One-Year limited Warranty.. . . . . . . . . . . . . . . . . . . . .17

How to Obtain Warranty Service . . . . . . . . . . 18

Welcome

Congratulations on your purchase of a SUNBEAM” Iron! Sunbeam

has designed your iron to provide the utmost in quality, ease of use

and convenience.

SUNBEAM” Simple

Pres9

irons offer the following features:

SPRAY MIST

Provides a fine mist of water to dampen fabrics

for creases or to remove wrinkles from heavy fabrics.

Non-Stick Surface

Prevents starch residue and fabrics from

sticking to the bottom, making the iron easier to clean.

ONE PASS” Steam

Provides just the right amount of steam

to remove wrinkles with one pass of the iron.

Self-Cleaning

Prevents mineral build up that can reduce the life

of your iron.

large Water Fill Hole

Allows you to fill the water reservoir faster

while reducing water spills and drips.

Accepts Tap Water

Eliminates the necessity of keeping distilled water

on band for ironing.

Comfortable Ergonomic Handle

Provides a more comfortable grip

and easy handling.

Patented MOTION SMART’” Auto-Off

Automatically turns the iron off

if it is not moved after

minutes in

the

upright position or after

30 seconds in the ironing position.

Power Indicator light

Lights steadily to let you know the iron is

plugged in; blinks to let you know that

the

patented MOTION SMART”

Auto-Off has activated; and is unlit when the iron is unplugged.

Vertical Steam (Model 3040 only)

Functions like a garment steamer

to remove wrinkles from bung garments or drapes.

SHOT OF STEAM” (Model 3040 only)

Offers a powerful burst of steam

for removing stubborn wrinkles.

Retractable Cord

For easy storage and convenience.

SPRAY MIST Release

2. Sliding Water Reservoir Cover

3. Water Fill Hole

4. SHOT OF STEAM Button (Model 3040

only)

5. SPRAY MIST Button

6. Steam Control

7. Power Indicator Light

8. Patented MOTION SMART Auto-Off Indicator Blinking Light

9. Comfortable, Ergonomic Grip

1OA.

Retractable Cord

10B. Winding Button

11. Heel Rest with Rubber Feet

12.

Cord Wrap

13.

Fabric Select Dial

14.

Non-Stick Soleplate

15. l0-ounce, See-Through Water Reservoir

Filling the Water Reservoir

You must fill the water reservoir with water to use

the SPRAY MIST8 and SHOT OF STEAM features

and to get steam out of your

iron

Tip: Sunbeam tests each iron at the factory to

ensure that they

function

correctly. The test may

leave a small, harmless amount of water within

the water reservoir.

Before you fill the water reservoir, please consider

the following:

lWhile this iron was designed for use with tap

water, very hard water will reduce the performance

of the iron. If your water is very hard, Sunbeam

recommends that you use tap water the first time,

then consider using demineralized or distilled water

for subsequent use. You should use tap water once

a month, however, to maintain the iron’s optimal

steam performance.

.Do not use water that has passed through a home

water softening system. This type of water contains

minerals that will decrease the performance and

shorten the life of your

uon.

Use demineralized or

distilled water, instead.

Important:

When

not

ironing always set the Steam

Control and the Fabric Select dial to OFF.

To fill the water reservoir:

Make sure the Iron is unplugged and that both

the Fabric Select dial and the Steam Control are

set to OFF.

Slide the water reservoir cover open and hold

the iron at an angle.

Fill the water reservoir with tap water until it

reaches the maximum fill level (10 ounces).

WARNING: To prevent the risk of burns, be careful

when filling a hot iron with water. Hot metal parts,

hot water and steam can cause injuries.

Close the water reservoir cover.

Extending the Power Cord:

Hold iron with one hand and grasp plug of

power cord with other hand.

Firmly pull power cord straight up to extend.

Do not allow children to use retractable cord

feature as the cord may cause injury.

Dry Ironing

Make sure that the Steam Control is set to OFF.

Plug the cord into a 102-Volt AC outlet.

The Power Indicator will light.

Turn the Fabric Select dial to the Dry ironing

fabric setting you desire (Silk or Synthetics)

and allow the iron to heat for 2 minutes.

While the Iron is heating, make sure it is sitting

on its

heel

rest on a stable, protected surface.

Tip: Refer to the Ironing Guide on Page 16

for

the recommended setting for your fabric.

Steam Ironing

Follow the instructions for “Filling the Water

Reservoir” on Page 5.

Plug the cord into a 120.Volt AC outlet.

The Power Indicator will light.

Turn the Fabric Select dial to the Steam ironing

fabric setting you desire

(Linen,

Cotton

Wool)

and allow the iron to heat for 2 minutes.

While the iron is heating, make sure It is sitting

on its heel rest on a stable, protected surface.

Tip: Refer to the Ironing Guide on Page

for the recommended setting for your fabric.

After the iron has heated (2 minutes),

turn the Steam Control to ON.

Jsivthees

SPRAY

MIST@

The SPRAY MIST” feature dampens the fabric to aid

in removing wrinkles from heavy fabrics and for

setting creases.

To use the SPRAY MIST feature:

Press the SPRAY MIST’ button firmly,

SHOT OF STEAM” (Model

3040

only)

The SHOT OF STEAM” feature provides an extra

burst of steam for deep penetration of stubborn

wrinkles. You can use this feature while Dry or

Steam ironing, but the water reservoir must be

at least l/4 full of water.

To Use the SHOT OF STEAM” Feature:

Press the SHOT OF STEAM” button several

times to prime the pump.

Place the iron on top of the wrinkle and press

the SHOT OF

STEAMO

button each time

you would like an extra burst of steam.

The SHOT OF

STEAMO

feature may

be used continuously with just a

short pause between shots.

Ce manuel convient aux modèles suivants

Table des matières

Langues :

Autres manuels Sunbeam Fer

Sunbeam

Sunbeam 3891 Manuel utilisateur

Sunbeam

Sunbeam GCSBCL-202-033 Manuel utilisateur

Sunbeam

Sunbeam SR3100 Pro Steam II Manuel utilisateur

Sunbeam

Sunbeam TURBO Steam Master GCSBCS-112 Manuel utilisateur

Sunbeam

Sunbeam 4237 Manuel utilisateur

Sunbeam

Sunbeam Ultura SR5555 Manuel utilisateur

Sunbeam

Sunbeam Steam Master 4211 Manuel utilisateur

Sunbeam

Sunbeam Steam Master GCSBCL-212-033 Manuel utilisateur

Sunbeam

Sunbeam Steam Master 4211-099 Manuel utilisateur

Sunbeam

Sunbeam HOT-2-TROT TRAVEL IRON Manuel utilisateur

Sunbeam

Sunbeam Steam Pro Compact SR8200 Manuel utilisateur

Sunbeam

Sunbeam 183606 Manuel utilisateur

Sunbeam

Sunbeam Steam Master 4055 Manuel utilisateur

Sunbeam

Sunbeam Series 6 Manuel utilisateur

Sunbeam

Sunbeam Steam Master 4230 Manuel utilisateur

Sunbeam

Sunbeam 3985 Manuel utilisateur

Sunbeam

Sunbeam 3932 Manuel utilisateur

Sunbeam

Sunbeam GCSBCS-105-000 Manuel utilisateur

Sunbeam

Sunbeam 139548 Manuel utilisateur

Sunbeam

Sunbeam SR2600 Manuel utilisateur

Sunbeam

Sunbeam Steam Pro Non-Stop SR8600 Manuel utilisateur

Sunbeam

Sunbeam TURBO Steam Master PROFESSIONAL Manuel utilisateur

Sunbeam

Sunbeam Steam Pro Non-Stop SR8500 Manuel utilisateur

Sunbeam

Sunbeam GCSBBV-100 Manuel utilisateur

Manuels Fer populaires d'autres marques

Clatronic

Clatronic DB 3703 Manuel utilisateur

TEFAL

TEFAL FV4093Z0 Manuel utilisateur

Gorenje

Gorenje SIH 2200 BS Manuel utilisateur

Philips

Philips GC6012 Manuel utilisateur

Bosch

Bosch 2 Series Manuel utilisateur

Riffel

Riffel Catena KB-819 Manuel utilisateur

Texi

Texi Hestia Manuel utilisateur

Maxwell

Maxwell MW-3010 Manuel utilisateur

TREVIDEA

TREVIDEA Girmi ST60 Manuel utilisateur

Philips

Philips HI5914/30 Manuel utilisateur

Primula

Primula Vapormat Manuel utilisateur

Magio

Magio MG-541 Manuel utilisateur

Scarlett

Scarlett SC-1334S Manuel utilisateur

Bosch

Bosch Sensixx B22L Manuel utilisateur

Philips

Philips GC651 Manuel utilisateur

Vitek

Vitek VT-1247 VT Manuel utilisateur

Cleanmaxx

Cleanmaxx 3397 Manuel utilisateur

Philips

Philips GC800 Manuel utilisateur