Sunbeam 9362 Manuel utilisateur
DANGER
Owner’s Manual
Model # 9362
Item # 952096
SKU # 50425000
Steel Linear
Fire Table
DANGER
If you smell gas:
1. Shut off gas to the appliance.
3. If odor continues, keep
away from the appliance and
immediately call your gas
WARNING
Do not store or use gasoline
liquids in the vicinity of this or
any other appliance.
An LP-cylinder not connected
for use shall not be stored in
the vicinity of this or any other
appliance.
WARNING
For outdoor use only.
WARNING
Improper installation, adjustment, alteration, service or maintenance can cause injury or
property damage. Read the owner’s manual thoroughly before installing or servicing this
result causing property damage, personal injury or loss of life.
CARBON MONOXIDE HAZARD
This appliance can produce carbon monoxide
which has no odor.
Using it in an enclosed space can kill you.
Never use this appliance in an enclosed space
such as a camper, tent, car or home.
CAUTION
Firebowl Pan and Flame Glass are wet!
explosion, injury or death.
WARNING
• The installation of this unit must adhere to local codes or either the National Fuel Gas Code, ANSI Z223.1/NFPA54, OR
CAN/CGA-B149.1, National Gas and Propane Installation Code.
• THIS UNIT IS INTENDED FOR OUTDOOR USE ONLY! This product shall be used outdoors, in a ventilated space and
shall not be used in any enclosed area.
• Do not use any solid fuel or charcoal for this unit.
• LP GAS WARNING: Do not use any more than 1/4 in. depth Flame Glass above the burner holes. Doing so will
• If the propane gas tank is leaking gas, you may hear, see, or smell a hiss. Do the following:
department for help.
• Applying too much propane may result in gas pooling and will not burn. Allow fresh air into the unit so that the
remaining gas may escape.
• The maximum gas supply 6791.3 in. w.c. (1725 kPa), Manifold pressure 11 in. w.c. (2.74kPa).
• Use LP propane tanks with the following dimensions: diameter 12 in., height 18 in. - capacity 20 lbs.
• You must use a propane tank that has a collar to protect the gas valve.
• The tank system must be set up for vapor withdrawal.
• Discontinue use if any part of the propane tank is damaged. Rust and dents may be hazardous and should be
inspected by a gas supplier.
• Always ensure that Flame Glass is completely dry before use. Failure to do so may cause them to crack or break.
• Do not operate unit until all parts are fully assembled.
• Do not paint or color any part of this heating unit.
• Unit may be hot while in use, do not attempt to move it while in use.
• Never leave this heating unit unattended while in use.
• This unit is not intended for cooking.
• Keep a safe distance to avoid burning skin or clothing.
• Do not sit or rest hands or feet on this heating unit.
• Keep all electrical cords and fuel supply hose away from heated surfaces.
• Combustible material should not be within 64 in. from sides and top of the unit.
• Do not add water into the unit.
appliance and replace any part of the control system and any gas control that has been under water.
• Do not disconnect any part while unit is in use.
• Do not store a spare propane tank on or near this unit.
• If the heating unit is indoors, detach the propane tank and leave outdoors.
• Always remove protective cover before operating (if applicable).
• Do not set the protective cover over the unit until it is turned off and completely cooled down.
• Check for leaks after not using the unit for long periods of time.
• Children should never operate this unit. Children must be supervised while near this unit.
• Keep gas tank at least 5 feet away from unit when lit. (if external tank)
• The maximum gas supply pressure is 250 PSI.
Safety Information
Page 2
CAUTION
Firebowl Pan and Flame Glass are wet!
Min. Clearance
64 in. (162.56 cm)
Min. Clearance
64 in. (162.56 cm)
Min. Clearance
64 in. (162.56 cm)
Min. Clearance
64 in. (162.56 cm)
cleaned regularly.
• Inspect all elements of this heating unit before each use. If there is damage, the burner must be replaced.
• Keep the hose out from any pathways to eliminate any accidental damage. (if external tank)
• Be aware of the hazards of high temperatures and stay away from the unit to avoid any burns or injury.
Department of Transportation or the National Standard of Canada CAN/CSA-B339, LP gas tanks, spheres and tubes for
Transportation of Dangerous Goods; and Commission.
connection.
• Children and adults should be alerted to the hazards of high surface temperatures and should stay away to avoid burns
or clothing ignition.
• Young children should be carefully supervised when they are in the area of the appliance.
• Any guard or other protective device removed for servicing the appliance shall be replaced prior to operating the
appliance.
the control compartment, burners and circulating airways of the appliance are kept clean.
IF APPLICABLE:
• Allow heating item to cool completely before placing on lid.
• DO NOT use heating item while lid is installed. Always remove the lid while heating item is in use. Only use the
regulator and hose assembly provided with this unit. Replacement parts must be supplied directly by Jay Trends.
Inspect the burner before use of this unit. If the burner shows any kind of damage, do not operate the appliance.
For assistance with repair or replacement of the burner or any other parts, call Jay Trends at 1-877-387-3639.
NOTE: You must follow all steps to properly assemble this heating item. Make sure the gas valve is turned “OFF” before
assembling. Do NOT attempt to assemble without proper tools.
Safety Information
Combustible materials should not be within 64 in. from sides and
top of the unit.
1-877-387-3639 | Page 3
Package Contents
Before beginning assembly of product, make sure all parts are present. Compare parts with package contents list.
If any parts are missing or damaged, do not attempt to assemble the product.
Page 4
PART DESCRIPTION QUANTITY
A Table Top with Burner 1
Back Panel 1
B
Left Side Panel 1
C
Cross Bar 1
D
Protective Cover 1
E
Bottom Plate 1
F
Adjustable Feet 4
G
Door Knob 1
H
Door Panel 1
I
Right Side Panel 1
J
Flame Glass (14.3 lbs.) 1
K
LLid 1
B
I
G
C
D
A
E
F
J
K
L
H
Hardware Contents
PART DESCRIPTION QUANTITY
12345
67 8 9 10
14 1511 12 13
1-877-387-3639 | Page 5
1 Burner 1
2 Firebowl Pan 1
3 Ignition Pin 1
4 Thermocouple 1
5 Bellows 1
61
7Gas Valve 1
8 Control Knob 1
9 Pulse Ignition 1
10 Regulator 1
11 Ignition Screen 1
12 1
13 NG Air Hole Cover 1
14 Heat Resistant Screen 1
15 AA Battery 1
SAFETY INFORMATION
Please read and understand this entire manual before attempting to assemble, operate or install this appliance. If you
have any questions regarding the product, please call customer service 1-877-387-3639, 8 a.m. – 4 p.m., EST, Monday –
Friday. This appliance has been tested to and complies with the ANSI Z21.97-2017/CSA 2.41-2017, Outdoor Decorative
Gas Appliances CGA CR 97-003 Outdoor Gas Fireplaces. The installation must conform to local codes or in the absence
of local codes, to the National Fuel Gas Code. ANSI Z223.1. This manual contains important information about the
is also located throughout this manual. Keep this manual for future reference and to educate new users of this appliance.
This manual should be read in conjunction with the labeling on the appliance. Safety precautions are essential when
any mechanical or propane fueled equipment is involved. These precautions are necessary when using, storing, and
servicing. Using this appliance with the respect and caution demanded will reduce the possibilities of personal injury or
property damage. The following symbols shown below are used extensively throughout this manual. Always heed these
precautions, as they are essential when using any mechanical or propane fueled equipment.
DANGER:
DANGER indicates an imminently hazardous
situation which, if not avoided, will result in death
or serious injury.
DANGER:
Failure tocomply with the precautions and
in death, serious bodily injury and property loss
asphyxiation, and/or carbon monoxide poisoning.
Only persons who can understand and follow the
DANGER:
FOR YOUR SAFETY:
If you smell gas:
1. Shut ogas to the appliance.
3. If odor continues, keep away from the appliance
department.
Solid fuels shall not be burned with this appliance.
Hardware Contents
CAUTION
Pan and Flame Glass are wet!
EE
-
+
Battery
Qty. 1
Page 6
AA
M6x10 Bolt
Qty. 19
BB
M6x25 Bolt
Qty. 5
CC
M6 Washer
Qty. 24
DD
Wrench
Qty. 1
Preparation: Before beginning assembly of product, make sure all parts are present. Compare parts with package
contents list and hardware contents above. If any part is missing or damaged, do not attempt to assemble the product.
Contact customer service for replacement parts.
Tools Required for Assembly(not included):
Phillips screwdriver with medium blade
Assembly
1-877-387-3639 | Page 7
1
3
2
4
1. Attach Door Knob (H) to Door Panel (I).
3. Attach Right Side Panel (J) and Left Side Panel (C) to the Back Panel (B)
and to the Door Panel (I).
DO NOT OVERTIGHTEN as you will need to adjust the holes to ensure proper
alignment.
AA M6x10 Bolt x8 CC M6 Washer x8
4. Open the door, attach control box to Left Side Panel (C).
AA M6x10 Bolt x1 CC M6 Washer x1
2. Place Table Top with Burner (A) upside down on a flat, protected surface.
Attach the Back Panel (B) and Door Panel (I) to the Table Top with Burner (A).
DO NOT OVERTIGHTEN as you will need to adjust to ensure proper alignment.
AA M6x10 Bolt x8 CC M6 Washer x8
BB M6x25 Bolt x1 CC M6 Washer x1
AA
I
B
CC
A
AA CC
C
AA
C
J
I
B
CC
BB
H
CC
Assembly
Page 8
To continue assembly refer to page 12.
Natural Gas Conversion
Natural gas conversion must be performed only by a natural
gas provider or service company.
Refer to pages 9 - 11 for more information.
High Altitude Conversion
For installations above 2,000 feet, contact your local dealer or gas supplier
before installing as input ratings will be reduced approximately 4% for each
1,000 feet above sea level. Refer to the National Fuel Gas Code.
*High Altitude Conversion Kit
Contact your distributor to obtain a High Altitude Conversion Kit.
conversion label.
Refer to pages 9 - 11 for more information.
5. Attach the Bottom Plate (F) to Left Side Panel (C), and Right Side Panel (J).
DO NOT OVERTIGHTEN as you will need to adjust the holesto ensure proper
alignment.
BB M6x25 Bolt x4 CC M6 Washer x4
6. Attach the Cross Bar (D) to Bottom Plate (F) and Back Panel (B)
AA M6x10 Bolt x2 CC M6 Washer x2
5 6
BB CC
C
J
F
AA
AA
CC
CC
F
B
propane
bellows
2
1
CAUTION
Natural gas conversion must be performed only by a
natural gas provider or service company.
propane hose
gas valve
propane
bellows
Natural Gas
Conversion
1-877-387-3639 | Page 9
1. Unscrew and disconnect propane regulator from
gas valve counterclockwise using the torque wrench.
2. Unscrew and disconnect the bellows from propane
orifice counterclockwise using the wrench, then
disconnect the propane orifice from the inlet tube.
Propane orifice is identified with a red mark.
Hardware Used
Torque Wrench
Hardware Used
Wrench
Natural Gas
Conversion
supply piping system. natural gas supply
piping system
natural gas hose
gas valve
3
4
5
inlet tube
NG air hole cover
bellows
Page 10
Hardware Used
Wrench
Hardware Used
Torque Wrench
4. Connect the natural gas hose with gas valve by
3. Connect the bellows with natural gas orifice by
screwing clockwise tightly using the wrench.
Then connect and tighten the natural gas orifice
with inlet tube using the wrench.
Natural gas orifice is painted with a black mark.
screwing clockwise tightly using the torque wrench.
Requires a CSA Certified NG Conversion
kit 50 000 BTUs and 3/8” NG Hose.
Ce manuel convient aux modèles suivants
2
Table des matières
Autres manuels Sunbeam Cheminée intérieure
