Sun Microsystems Sun Fire V20z Manuel utilisateur

817-5258-11 1

Replacing the Sun Fire v20z or Sun Fire V40z Cable Kit

This document contains:

■“Replacing a Cable Kit in a Sun Fire V20z Server” on page 1

■“Replacing a Cable Kit in a Sun Fire V40z Server” on page 3

Replacing a Cable Kit in a Sun Fire V20z Server

Follow these steps to remove and replace the following cables (refer to FIGURE 2):

■Five-pin cable connecting the SCSI backplane to the motherboard (1).

■68-pin ribbon cable connecting the SCSI backplane to the motherboard (2).

■Flat cable connecting the SCSI backplane to the motherboard (3).

■Flat cable connecting the CD-ROM/DVD to the motherboard (5).

■Flat cable connecting the Diskette Drive to the motherboard (6).

■Flat cable connecting the operator panel board to the motherboard (7).

1. Turn off the system, including any attached peripherals.

Refer to the Sun Fire V20z and Sun Fire V40z Servers User Guide for full instructions

on powering off the server.

2. While pressing the cover latch release button with your right thumb (A), slide the

cover towards the rear of the chassis until it contacts the stop (B).

3. Lift the cover up and remove it.

FIGURE 1 Removing the Sun Fire V20z Cover

2Replacing the Sun Fire V20z or Sun Fire V40z System Cables

4. Identify the cable to be replaced.

FIGURE 2 Sun Fire V20z System Cables

The two halves of the 5-pin SCSI backplane power cable connector (1) are secured

with a hook.

The 68-pin SCSI ribbon cable (2) has no locking mechanism.

The small flat cables (3-7) are attached using two different types of zero insertion

force (ZIF) cable connectors. Because of their small size, it may be difficult to

distinguish one connector type from the other.

Refer to FIGURE 3 for the methods used to release cables from the various types of

connectors.

Caution – Use caution when removing cables as they are fragile—the small flat

flexible cables and cable connectors are extremely sensitive.

FIGURE 3 Cable Connectors

5. Check the routing of all cables for obstructions before reinstalling the cover.

1 32

4 5 6 7

817-5258-11 3

Replacing a Cable Kit in a Sun Fire V40z Server

The following procedure describes how to remove and replace the following cables:

■PCI slot mechanical retention latch (MRL) board cable

■Operator panel board cable

■SCSI signal cable

■SCSI backplane power cable

■CD-ROM/DVD-ROM diskette drive assembly cable

■Internal USB cable

1. Turn off the system, including any attached peripherals.

Refer to the Sun Fire V20z and Sun Fire V40z Servers User Guide for full instructions

on powering off the server.

2. Loosen the captive screw on the cover latch, then rotate the latch toward the

system rear to push back the cover.

3. Lift the cover up and remove it.

FIGURE 4 Removing the Sun Fire V40z Cover

4. Identify the cable to be replaced (see FIGURE 5 for the location).

Captive

screw

4Replacing the Sun Fire V20z or Sun Fire V40z System Cables

FIGURE 5 Sun Fire V40z System Cables

Refer to FIGURE 3 for the methods used to release cables from the various types of

connectors.

Caution – Use caution when removing cables because connectors and pins are very

fragile and can be damaged.

5. Check the routing of all cables for obstructions and then reinstall the cover.

Part Number: 817-5258-11

May, 2004, Revision A

licensed from Sun suppliers. Portions may be derived from Berkeley BSD systems, licensed from U. of CA. Sun, Sun Microsystems, the Sun logo, and Solaris are

trademarks or registered trademarks of Sun Microsystems, Inc. in the U.S. and in other countries. All SPARC trademarks are used under license and are

trademarks or registered trademarks of SPARC International, Inc. in the U.S. and in other countries. U.S. Government Rights—Commercial use. Government users

are subject to the Sun Microsystems, Inc. standard license agreement and applicable provisions of the FAR and its supplements.

comprend la technologie relative aux polices de caractères, est protégé par un copyright et licencié par des fournisseurs de Sun. Des parties de ce produit

pourront être dérivées des systèmes Berkeley BSD licenciés par l’Université de Californie. Sun, Sun Microsystems, le logo Sun, et Solaris sont des marques de

fabrique ou des marques déposées de Sun Microsystems, Inc. aux Etats-Unis et dans d’autres pays. Toutes les marques SPARC sont utilisées sous licence et sont

des marques de fabrique ou des marques déposées de SPARC International, Inc. aux Etats-Unis et dans d’autres pays.

MRL board

cable

Operator panel

board cable

SCSI signal cable SCSI backplane

power cable

CD/DVD/diskette

assembly cable

Internal

USB cable

Autres manuels pour Sun Fire V20z

Ce manuel convient aux modèles suivants

Table des matières

Autres manuels Sun Microsystems Serveur

Sun Microsystems

Sun Microsystems Sun Fire 15K Guide rapide

Sun Microsystems

Sun Microsystems Sun Fire V20z Manuel de programmation

Sun Microsystems

Sun Microsystems SPARC T5120 Manuel utilisateur

Sun Microsystems

Sun Microsystems Enterprise 6 00 Series Manuel utilisateur

Sun Microsystems

Sun Microsystems Enterprise 250 Manuel de service

Sun Microsystems

Sun Microsystems Netra 150 Guide de démarrage rapide

Sun Microsystems

Sun Microsystems Blade X6275 M2 Manuel utilisateur

Sun Microsystems

Sun Microsystems Sun Fire E2900 Mode d’emploi

Sun Microsystems

Sun Microsystems Sun SPARC Enterprise M3000 Mode d’emploi

Sun Microsystems

Sun Microsystems Fire V440 2-Post Manuel utilisateur

Sun Microsystems

Sun Microsystems Sun SPARC Enterprise M3000 Manuel utilisateur

Sun Microsystems

Sun Microsystems Netra ct Series Mode d’emploi

Sun Microsystems

Sun Microsystems SunLink SNA 9.1 PU2.1 Manuel utilisateur

Sun Microsystems

Sun Microsystems V250 Mode d’emploi

Sun Microsystems

Sun Microsystems StorEdge 6320 System 1.0 Manuel utilisateur

Sun Microsystems

Sun Microsystems Sun GlassFish Enterprise Server 2.1 Mode d’emploi

Sun Microsystems

Sun Microsystems Enterprise 4000 Manuel d'instructions d'installation

Sun Microsystems

Sun Microsystems Sun Fire V1280 Manuel utilisateur

Sun Microsystems

Sun Microsystems Fire 880 Mode d’emploi

Sun Microsystems

Sun Microsystems Enterprise Expansion Cabinet Optional Power... Manuel utilisateur

Sun Microsystems

Sun Microsystems Sun Enterprise 220R Manuel

Sun Microsystems

Sun Microsystems Blade X6275M2-BB Manuel utilisateur

Sun Microsystems

Sun Microsystems SUN FIRE X4500 Manuel utilisateur

Sun Microsystems

Sun Microsystems Sun Fire V890 Manuel utilisateur

Manuels Serveur populaires d'autres marques

HP AlphaServer ES47 Manuel utilisateur

Dell

Dell PowerEdge R410 Manuel utilisateur

PowerNAS

PowerNAS CMA Manuel utilisateur

Supero

Supero FatTwin F617R3-FT Manuel utilisateur

MSI

MSI P1-109N-L70 Manuel utilisateur

Dell

Dell PowerEdge XE9640 Manuel

Dell

Dell PS4100 Instructions de montage

EtroVISION

EtroVISION EV3151 Manuel utilisateur

NEC

NEC Express5800/T110j Manuel utilisateur

HP ProLiant Gen9 Manuel utilisateur

Compaq

Compaq ProLiant 3000 Manuel

Dell

Dell PowerEdge 3YPMN Manuel utilisateur

iRobo

iRobo IPC2U Manuel utilisateur

Nortel

Nortel 1000 Con?guration guide Manuel utilisateur

Asus

Asus AP7500 Manuel d'utilisation et d'entretien

Avid Technology

Avid Technology AirSpeed 5000 Manuel utilisateur

HP Integrity rx2600 Guide d'installation

Milestone

Milestone Husky IVO 350T Manuel utilisateur