Installing a Barcode Reader | 3
8. Install the trim panel by snapping it into position in front of the barcode reader.
9. Connect the autoloader AC line cord to the AC source outlet.
10. Power up your autoloader by pressing the POWER button.
NOTE: Your autoloader will automatically sense the barcode reader when power is
applied.
Configuring the Barcode Reader
Your autoloader automatically senses the presence of the barcode reader at power-up
and enables the barcode read function. The application software can start scanning
barcode labels as soon as the autoloader is powered-up. When the barcode reader is
installed, a new BARCODE function appears under the StorEdge DIAGNOSTIC
MENU.
The dIAG MENU is accessed by pressing and holding the NEXT button and then the
MODE button for approximately 5 seconds. dIAG MENU will appear on the LCD. The
autoloader will automatically exit the dIAG MENU and return to LdR REAdY if the
keypad is idle for 30 seconds.
Enabling/Disabling the Barcode Reader
The bARCOdE function, available under the dIAG MENU whenever the barcode
reader is installed, is used to enable/disable the barcode. If disabled, the barcode
reader is not available to the application software.
NOTE: The bARCOdE function default setting is bCOdE ON.
