
7
SYMBOL DESIGNATION OPERATION
Power ON/OFF Press to power on or off the heat pump
Up/ Down Press to set desired water temperature
Heat/Cool/Auto Press to shift among cooling, heating and auto
Fan Press to select Silence mode ON/OFF
Note:
You may set the desired water temperature from 12 to 40℃.
The on the right shows the inlet water temperature. The on the left shows the outlet
water temperature.
After you turn on the heat pump, the fan will start to run in 3 minutes. In another 30 seconds,
the compressor will start to run.
2.2.1 Status on the display
Auto Mode Defrost Mode Heating Mode Cooling Mode
Timer ON/OFF
2.2.2. Time setting
Press for 5 seconds to enter time setting. 88:88 is flashing on the display
Press and to adjust the time (fast adjusting by continuous pressing). Then, press
to confirm and exit.
In the time setting mode, if no operation for 30 seconds, the previous pressing will be lost and
exit automatically.
2.2.3. Timer on and off
Press the for 10 seconds to enter the timer setting. The “ON” will be flashing to enter the
Timer ON setting. Press the and to adjust Timer ON time. You can choose Timer on
( Display: ON ), or Repeat Timer ON ( display: 1 ON ) by pressing . Then press to confirm
When the “ON” stops flashing, and “OFF” is flashing, you enter the Timer OFF mode. Press the
and to adjust Timer OFF time. You can choose Timer OFF (Display: OFF ), or Repeat
Timer OFF ( display: 2 OFF ) by pressing . Then press to confirm