Sub-Zero IC-30RID-RH Manuel utilisateur
DESIGNER REFRIGERATION
USE AND CARE GUIDE
CLEANING, MAINTENANCE, AND MORE
2 | Sub-Zero Customer Care 800.222.7820
DESIGNER REFRIGERATION
Contents
4Designer Features
6Interactive Controls
7Storage
12 Operation
16 Care Recommendations
17 Technical Data
18 Troubleshooting
22 Sub-Zero Warranties
subzero.com | 3
Customer Care
The model and serial number are printed on the enclosed
product registration card. Both numbers are also listed on
the product rating plate. Refer to page 5 for rating plate
location. For warranty purposes, you will also need the date
of installation and name of your authorized Sub-Zero dealer.
Record this information below for future reference.
SERVICE INFORMATION
Model Number
Serial Number
Date of Installation
Certied Service Name
Certied Service Number
Authorized Dealer
Dealer Number
If your product ever needs attention, be sure to use a
Sub-Zero Factory Certied Service provider recommended
by our Customer Care Center, or select one from our list of
providers available at subzero.com/locator. All Factory Certi-
ed Service providers are carefully selected and thoroughly
trained by us.
Important Note
To ensure this product is installed and operated as safely
and efciently as possible, take note of the following types
of highlighted information throughout this guide:
IMPORTANT NOTE highlights information that is especially
important.
CAUTION indicates a situation where minor injury or product
damage may occur if instructions are not followed.
WARNING states a hazard that may cause serious injury or
death if precautions are not followed.
IMPORTANT NOTE: Throughout this guide, dimensions in
parentheses are millimeters unless otherwise specied.
WARNING
PROPOSITION 65 FOR CALIFORNIA RESIDENTS
Cancer and Reproductive Harm—
www.P65Warnings.ca.gov
DESIGNER REFRIGERATION
4 | Sub-Zero Customer Care 800.222.7820
Designer Features
FEATURES
1Product Rating Plate
2Interactive Control Panel
3Freshness Cards
4Door Shelves
5Dairy Compartment
6Glass Shelves
7Refrigerator Drawer
8Freezer Basket
9Ice Container
10 Storage Drawers
11 Air Purication System
12 Water Filtration System
13 Automatic Ice Maker (ice maker models)
14 Water Dispenser (dispenser models)
15 Condenser (behind grille)
DESIGNER FEATURES
subzero.com | 5
Column all refrigerator
6
3
14
7
11
Tall combination
2
1
5
4
Drawer all refrigerator
15
12
6
3
1
11
2
10
5
4
15
12
9
13
7
15
10
1
14
11
2
Designer Features
Column combination
6
3
14
7
11
2
1
5
4
15
12
DESIGNER FEATURES
9
13
8
6 | Sub-Zero Customer Care 800.222.7820
Interactive Control Panel
For initial start up, touch and hold “power” on the control
panel for 2 seconds.
Temperatures can be adjusted in one-degree increments on
the home screen. Combination units have separate tem-
perature controls for refrigerator and freezer. Temperatures
are preset at 38°F (3°C) and 0°F (-18°C).
To adjust temperature:
1Touch the temperature to be adjusted.
2Touch +or –until the desired temperature is displayed.
Refer to the illustration below.
Once the temperature has been adjusted, additional
features can be activated or deactivated from the options
screen. Touch to view the options screen. Refer to the
illustration below.
INTERACTIVE CONTROLS
Home screen
Options screen
OPTIONS SCREEN
Touch to activate or deactivate the ice maker system and
max ice feature.
Touch to activate or deactivate the door/drawer alarm.
Touch to activate or deactivate the water dispenser.
Touch to activate or deactivate the air purication system.
Touch to view the settings screen.
SETTINGS SCREEN
Touch to view model information.
Touch to select temperature unit, Fahrenheit or Celsius.
Touch to adjust control panel brightness and contrast.
Touch to adjust door/drawer alarm volume and pitch.
Touch to adjust door/drawer alarm duration.
Touch to enter Sabbath mode.
Touch to view troubleshooting and service information.
Touch to set the clock.
Touch to enable or disable connect.
Touch to select language options.
Touch to adjust soft on lighting.
subzero.com | 7
Refrigerator Storage
DOOR SHELVES
To reposition a door shelf or dairy compartment:
1To remove, lift the shelf from the bottom and slide out.
Refer to the illustration below.
2To reinstall, place in the desired position and slide the
shelf down onto the guides.
IMPORTANT NOTE: If the door opening is limited to 90°,
door shelves may need to be removed before removing a
storage drawer or glass shelf.
STORAGE
Door shelf removal
Keeping Food At Its Best
DUAL REFRIGERATION®
This Sub-Zero features a unique Dual Refrigeration®system
to keep food fresher longer.
With the Sub-Zero Dual Refrigeration®system, individual
refrigerator and freezer systems have been designed to
maintain accurate, consistent temperatures and proper
humidity levels for longer food life expectancy. Dual Refrig-
eration®eliminates transfer of fresh food odors to frozen
food and ice and does not freeze the moisture out of the air
in the fresh food section.
For handy tips and information on how to maximize food
freshness, refer to the freshness cards stored in the
refrigerator.
8 | Sub-Zero Customer Care 800.222.7820
Refrigerator Storage
GLASS SHELVES
To reposition a glass shelf:
1To remove, tilt the shelf up, then lift up and out. Refer to
the illustration below.
2To reinstall, insert the shelf in the tracks along the back
wall, then lower the front until it locks into position.
The stationary glass shelf at the bottom of the compartment
should be placed with the beveled edge facing front. Rear
support legs space the shelf away from the back wall to
ensure proper air ow through the unit.
IMPORTANT NOTE: Use care when handling glass shelves to
prevent breakage or scratching the interior.
CAUTION
Glass shelves should warm to room temperature before
immersing in warm water.
REFRIGERATOR DRAWERS
To remove/reinstall a refrigerator drawer:
1To remove, pull the drawer open until it stops. Lift the
front of the drawer slightly and pull straight out. Refer to
the illustration below.
2To reinstall, pull the drawer carrier out and align the
bottom of the drawer with the carrier. Slide the drawer
back into position.
To reposition a refrigerator drawer divider:
1To remove, pull the divider straight up.
2To reinstall, align tabs on the divider with notches in the
drawer and push down.
STORAGE
Refrigerator drawer removal
Refrigerator drawer removal
Glass shelf removal
subzero.com | 9
DRAWER REMOVAL
To remove/reinstall a storage drawer:
1To remove, pull the drawer open until it stops. Raise the
front of the drawer slightly and pull straight out. Refer to
the illustration below.
2To reinstall, raise the front of drawer and place onto the
slides. Align the back of the drawer with hooks on the
slide, then align the white pegs at the front of the slide
with holes at the front of the drawer.
IMPORTANT NOTE: For drawer models, the upper drawer
has a control cable that must be disconnected before
removing the drawer. Refer to the illustration below.
Storage Drawers
CRISPER COVER
The crisper cover in the upper storage drawer can be slid
closed, left open, or removed.
To remove the crisper cover:
1Pull the upper storage drawer all the way out.
2Raise the front edge of the crisper cover and pull it
forward and out of the drawer. Refer to the illustration
below.
DRAWER DIVIDERS
To reposition a drawer divider:
1To remove a short divider, ex the long divider slightly,
then pull upward. Refer to the illustration below.
2To remove a long divider, all short dividers must be
removed. Pull the long divider up until it stops, rotate
counterclockwise, then pull upward.
3To reinstall a long divider, align the grooves with the
drawer tabs, rotate clockwise, then slide down.
4To reinstall a short divider, position as desired, then slide
down.
Crisper cover
Drawer dividers
Drawer removal
Control cable (drawers)
STORAGE
10 | Sub-Zero Customer Care 800.222.7820
STORAGE
Freezer Storage
FREEZER BASKETS
To remove a freezer basket:
1Pull the basket open until it stops.
2Pull the two plastic tabs located behind the bottom two
corners of the basket forward, then lift up and out. Refer
to the illustrations below.
If the door opening is limited to 90°, the top basket must be
removed before removing the middle or lower basket.
Column freezer basket
Column combination freezer
basket
To reinstall a freezer basket (column model):
1Push the basket slides in.
2Align the basket with the slides and push back until it
stops.
3Press down on the front of the basket to engage the
slides.
To reinstall a freezer basket (column combination model):
1Fully extend the basket slides.
2Align the basket with the slides and push back until the
rear of the basket contacts the slide tabs.
3Push back and down on the front of the basket to
engage the tabs.
Ce manuel convient aux modèles suivants
9
Table des matières
Langues :
Autres manuels Sub-Zero Congélateur
Sub-Zero
Sub-Zero IC-27FI Manuel utilisateur
Sub-Zero
Sub-Zero Sub-Zero 700BF Manuel utilisateur
Sub-Zero
Sub-Zero 500 Series Manuel utilisateur
Sub-Zero
Sub-Zero BI-36F Manuel utilisateur
Sub-Zero
Sub-Zero 700TFI Manuel utilisateur
Sub-Zero
Sub-Zero BI-36U Mode d’emploi
Sub-Zero
Sub-Zero IC36FI Manuel utilisateur
Sub-Zero
Sub-Zero ID-24FI Manuel utilisateur
Sub-Zero
Sub-Zero BI-36F Manuel utilisateur
Sub-Zero
Sub-Zero Sub-Zero 700BF Manuel utilisateur
Sub-Zero
Sub-Zero IT36CILH Manuel utilisateur
Sub-Zero
Sub-Zero 700 Series Mode d’emploi
Sub-Zero
Sub-Zero IC36FI Mode d’emploi
Sub-Zero
Sub-Zero 700TCI Instructions de montage
Sub-Zero
Sub-Zero Integrated all Freezer IC-18FI Feuille d'instructions
Sub-Zero
Sub-Zero 600-2 Series Manuel utilisateur
Sub-Zero
Sub-Zero 700TF Manuel utilisateur
Sub-Zero
Sub-Zero 249FF Manuel utilisateur
Sub-Zero
Sub-Zero 700TF Manuel utilisateur
Sub-Zero
Sub-Zero IC-27FI Instructions de montage
