2. INSTALLATION
a) Installing the Light:
Generally the Light is to be installed on a light stand. A light stand with sufficient
sturdiness and an appropriate leg-spread diameter which matches the size and weight of
the particular light model must be used.
Loosen the Sleeve Locking Knob to clear the passage inside the Mounting Sleeve. Insert
the head of the light stand into the Mounting Sleeve. Then, tighten the Sleeve Locking
Knob (see Fig. 1).
b) Putting on the Reflector:
Mount the Reflector on the Body and lock it in place with the Setting Screw Knobs. The
wider side of the Reflector, where the flaps are linked together, is the front side. The
narrower side is to be mounted to the Body. Make sure the flap of the Reflector, which
has the Hole for the Supporting Rod, is the bottom side.
c) Installing the Supporting Rod (see Fig. 2)
i) The lower end of the Supporting Rod takes the form of a clamp. Mount this clamp to
the shaft of a light stand (more or less immediately above the top of the tripod
section) and tighten the Supporting Rod Clamping Screw to lock it in place.
ii) The upper end of the Supporting Rod takes the form of a threaded stud on top of a
plastic disc mounted to a ball joint. Remove the Butterfly Nut first. Then, insert the
stud into the Hole for the Supporting Rod on the bottom flap of the Reflector. Rotate
the shaft of the last section of the rod, if necessary, to adjust the orientation of the
plastic disc such that the disc surface can come into contact squarely with the bottom
flap of the Reflector (if this is not done, the bottom flap of the Reflector can be
deformed when the Butterfly Nut is put back). Finally, put back the Butterfly Nut to
lock everything in place.
