ERROR CODES
As described above, the software is designed to make two (2) attempts to complete each function, WATER
FILL, MAKE ICE and DEFROST before shutting down and displaying a fault number. If on the second
attempt the same fault is detected, the machine will shut down and display one of the following fault numbers:
3Did not fill with water in time
4Did not make ice in time
5Did not defrost in time
NOTE!
If an error 3 occurs, the machine will attempt to fill every hour until the water supply is
restored.Therefore, if the water supply is interupted after hours, the machine may be functioning
normally the next morning and the only evidence of a problem may be a shortage of ice in the bin. If
this becomes a regular occurrance, then the cause of the interuption should be rectified.
For more detailed information on the operation of the machine, refer to the OPERATIONAL FLOW
CHARTS on pages 9 to 12.
SERVICE MODE
After 3000 hours of ice making time there will be 10 beeps and number will flash 10 times indicating
that the machine requires servicing. This will occur every hour until the machine has been put through a clean
cycle. Once the clean cycle has been carried out the machine starts counting the hours again.
Note: Ice making time does not include bin full time.
CLEAN CYCLE
Cleaning of the icemaker is recommended on a regular basis, at least three times a year.
1. Turn off water and fit new water filter and purge water supply line.
2. Empty the remaining ice in storage bin into a clean hygienic sealed receptacle and seal to prevent
contamination. (Always dispose the bottom 20% of ice in bin as it will most likely be dust
contaminated).
3. Remove front, top and right side panels, visually check all components are in satisfactory condition and
do not require replacement due to mechanical or electrical breakdown.
4. With the machine in No. 2 press & hold the clean button until the machine goes into clean mode No. 6,
wait for the water trough to fill and the fill light goes off then remove the drain cap from the trough and
allow all the water to drain away and replace the drain cap.
5. Mix the specified quantity of cleaning medium as per manufacturers specifications in a separate
container and pour into water trough and allow to circulate for 25 minutes maximum or until plate is
clean. Then drain the water trough and replace drain cap.
6. Mix up sanitizer in a container as per manufacturers specification and pour into water trough and allow
to circulate for 5 minutes. Remove drain cap and drain water trough then replace drain cap.
7. Press the fill button until the water overflows the trough, remove the drain cap and allow all the water to
drain away, replace cap, press fill button again, when full let circulate for 5 minutes before draining
trough.
8. Replace drain cap and PRESS RESET. When display returns to No. 2 switch off power.
9. Vacuum or blow out condenser ensuring dust does not contaminate the surrounding area.
10. Wipe out Compressor section removing dust and grime around fan motor. Spin fan and check for noisy
bearings.
5
6
8 8
