Safety Information
Please follow the safety instructions below before installation and when using the appliance:
Installation
•The appliance must be installed by a qualified electrician in accordance with relevant local building
and fire safety regulations.
•When installing the heater, ensure that the lower edge of the unit is at least 180 cm from the ground
and the safety clearances from the wall and ceiling set out in this manual are maintained. Always
maintain a distance from the heating surface of tof at least 150 cm from textiles, cloth and other easy
inflammable soft materials.
•The heater must be properly fixed using the supplied brackets with permanent wall plugs and/or
screws.
•The heater must always be earthed.
•If the heater is installed without a plug, or with other means for disconnection from the supply, a
double pole isolator should be used.
•When installed in a bathroom/jacuzzi area, the heater, switches, and other controls must be
positioned out of reach of anyone in the bath/jacuzzi.
•The heater should be installed only on cement, steel, or concrete surfaces and proper insulation must
be ensured if installing on a wooden surface.
•
Usage
•The unit must only be used with an approved isolating system, which must be built in the existing
electrical installation acc. to the facility regulations. The heater comes as standard with a separate
open-ended cable for connection purposes.
•WARNING: This unit is not equipped with an application to regulate the room temperature. The
heater must not be used in small rooms inhabited by people who cannot leave the room unaided,
unless constant supervision is ensured.
•CAUTION: Some parts of the unit get very hot and may cause burns! high cautiousness is imperative,
if children or persons with reduced physical, sensory or mental abilities or lack of experience and/or
knowledge. are present in the room.
•The cable must not be crushed, squeezed or damaged. If damaged, it must be replaced by the
manufacturer, its service agent, or similarly qualified persons to avoid any hazards.
•Do not cover either part of the front or the entire front of the radiant heater. Do not touch any part of
the heater during operation and up to 30 minutes after switching it off.
•Ensure that cables, furniture, flammable materials or other objects do not come into contact with the
surface of the radiant heater and never cover the unit. Under no circumstances should the unit be
covered or enclosed with insulating or similar materials. Adequate ventilation sur- rounding the
heater must be ensured at any time. Ledgers, beams and rafters must not be cut into or grooved to
install the infrared heater.
•Disconnect the heater from the power supply before cleaning it, adjusting the angle or removing it
from the wall/ceiling. Wait until the heating elements are not glowing any more and the housing is
noticeably cooled down.
•The Quartz Halogen or Carbon elements must never be touched, as this may cause premature
element failure. If the elements are touched, refer to the paragraph titled “Cleaning the heater” on
page 8 and follow the instructions carefully before switching on the heater.
•Remove the foam that protects the lamp during transit before operating the heater.
•Always remember to switch off the unit after use.
