1.5.5 Battery Life and Monitoring:
1.5.5.1 There is a low battery audible beep/ red LED flash that occurs every thirty (30)
minutes when the battery gets to 15% capacity. At this point, the SM should be
recharged as soon as possible.
1.5.5.2 To recharge the SM, remove the protective rubber plug from the charging port.
Plug the 5.5mm connector of a Stone Mountain approved charger into the charging
port. The SM LED will flash green while charging when the SM is powered on. Full
charge takes between 5 to 6 hours assuming a completely discharged battery.
Replace the protective rubber plug after charging is complete.
1.5.5.3 The SM can also be charged in optional TruDock™single bay, vehicle mount and
gang chargers.
1.5.6 Hard Reset:
1.5.6.1 In the event a Hard Reset is required, press and hold SW2 and SW6 simultaneously
for (4) seconds. The SM will undergo its boot sequence and power down upon
completion. The SM should resume normal function at the next Power On cycle.
1.5.7 Care & Maintenance:
1.5.7.1 Do not use solvents, abrasive, or other cleaning solutions to clean your BluSkye®.
Clean with mild soap and tap water.
1.5.7.2 Do not insert objects into the speaker chamber or the microphone port, as this will
adversely impact the audio quality and subsequent water leakage.
1.5.7.3 Use only Stone Mountain approved chargers to recharge your BluSkye®.
2.0 Adding BluSkye® to Android Devices
2.1 Adding your BluSkye® Button:
2.1.1 Make sure you've paired your SM through Android settings. Refer to 1.3 of the User Manual for
instructions on pairing the SM.
2.1.2 Search for Stone Mountain BluSkye PTT, connect, and press done. The SM will create a two-
tone beep and the LED on the back of the unit will continue to blink blue every 3 seconds. Refer
to images below.
