Safety during Installation.
•Make sure there are no loose elements near the ventilator, as they
could run the risk or being sucked up by it. If it is going to be
Installed in a duct, check that it is clean of any element that could
be sucked up by the ventilator.
•When installing an apparatus, make sure that all the fittings are in
place and that the structure which supports it is resistant enough to
bear its weight at full functioning power.
•Before manipulating the apparatus, make sure the mains supply is
disconnected, even if the machine is switched off.
•Check that the mains supply voltage and frequency values
coincide with the stipulations on the characteristics plate.
•The electrical installation must include a double pole switch with a
contact clearance of at least 3 mm, correctly sized and in
accordance with the electrical standards of the country of
installation.
•Please follow the connections diagram for the electrical
connections.
•If an earth connection is necessary, check that it correctly
connected and that adequate thermal and overloading protection
has been connected and adjusted to the corresponding limits.
•If a ventilator is installed in a duct, the duct must be exclusively for
the ventilation system.
