8 9
SPARE PARTS LIST
Seals & Screws Kit Elite/Trendy Foam
Seals & Screws Kit Green Foam
-Pack Sensor Kit Elite/Trendy Foam
-Pack Sensor Kit Green Foam
Soap Dispenser Pump
Pump+Compressor Kit
6-pack Soap Bottle L
pack L Bottle Support KIt
V Transformer (EU)
V Transformer (UK)
V Transformer (US)
V Transformer (AU)
Remote Control for Foam Dispenser (Optional)
Soap & Water Remote Control (Optional)
SETTINGS ADJUSTMENT wITH A REMOTE CONTROL
If available, the foam dispenser remote control can adjust the dispenser’s settings. To
use the remote control hold it in front of the sensor at a distance of 10-15cm (4-6”).
Attention: The remote control will not operate out of the recommended range (too close
or too far).
The remote control can be used to adjust the following functions:
1-SOAP QUANTITY
Press the + sign on the SOAP button to increase the soap quantity by increasing the
dispensing time. Press the - button to decrease it.
Indication: continuous blinking blue light in the sensor eye.
2-AIR QUANTITY
To improve soap consistency (“foamability) change the amount air to be mixed. Press the
+ sign on the AIR button to increase the air quantity and the - to
decrease it.
Indication: blinks of the blue light in the sensor eye.
3-RES
This function resets the sensor back to its factory settings.
4-TEMPORARY OFF FUNCTION
This function temporary disables the
dispenser. Use this function to preform
maintenance in front of the sensor without
activating the system (for example: cleaning).
The soap dispenser will shut o for one minute
aer this button is pressed once.
To return to normal operation before the
minute is over, press the On/O button again.
5-FILL THE SOAP TANK
Once the soap tank has been lled \ relled,
press the FILL button. The pump will run for
one minute, priming the piping with soap.
Once soap begins dispensing from the spout,
priming is complete. press the FILL button
again to stop the priming before the minute is
over.
Indication: continuous solid blue light in the
sensor eye.
Care and cleaning of chrome and special nishes
DO NOT use steel wool or cleansing agents containing alcohol, acid, abrasives, or their like. Use of
any prohibited cleaning or maintenance products or substances could damage the surface of the soap
dispenser. For surface cleaning use ONLY soap and water, then wipe dry with a clean cloth or towel. When
cleaning bathroom tiles, the soap dispenser should be protected from any splattering of harsh cleansers.
Disassemble of the soap pipe from the pump
The soap pipe can be disconnected from the soap pump by a simple slide & pull action. The sliding ring of
the quick connection xation nipple on the pump should be pulled down. It releases the open end of the
soap pipe which can then be easily pulled out.
Filter cleaning instructions (foam dispenser only)
This soap dispenser is provided with a foam lter. It is recommended to clean the lter every six () months.
If the soap supply has decreased, this may be caused by the clogged lter. The lter can be cleaned as
follows:
. Use a wrench to unscrew the quick connection tting from the foam compressor and pull out the
lter housing.
. Remove the lter from the housing.
. Replace the lter (recommended) or wash it under running water for a temporary x.
. Reassemble the parts.
Clean the soap tank
Clean out the tank prior to rell by flushing warm water through the hoses and pump until clean water is
released from the spout. TIP: Keeping a spare tank will enable this process to be completed in a speedy and
hygienic manner with minimal downtime.
MAINTENANCE
