
1-800-348-5004
PREPARING THE TOOL BEFORE DRIVING
CAUTION:
1. After reading and unders tanding this entire manual, connect tool to
air supply.
Keep tool pointed away from yourself and others at all
times.
Always conne ct tool to air supply before loading fasteners.
Do not load fasteners w ith trigger or safety depressed.
Always we ar Z87 approved safety glas ses, and he aring protection
when preparing or operating the tool.
Never use a tool that leaks air or needs repair.
2. Depress HANDLE (See A Fig. 14 ) and open t he LATC H. R otate the
UPPE R NAIL HOUSING to the side of the BODY.
3. The ADJUSTER PLATE can be move d up and down when twisting the
ADJUSTE R NUT(see B Fig.15) . According to the length of nail, the
ADJUSTE R PLATE should be adjusted correctly to t he position
Indicated inside LO WER NAIL HOUSING.
4. Place a coil of nails over the LOWER NAIL HOUSING . Uncoil enough
nails to reach the F EED HO OK and place the second nail betwee n the
teeth on the FE ED HOOK. (see Fig. 16).
5. Close the UPPER NAIL HOUSING and depress the LATCH (see Fig.
17).
6. Adjust directional EXHAUST deflector (s ee F ig. 18), so that the
exhaust air blast will be directed aw ay from the operator. Grasp the
deflector and rotate it to the desired position for the current application.
CAUT ION : All line co mponents (ho ses, co nnectors, filters,
regulators, etc.) must meet 150% of the maximum system pressure.
Please try to useahose of ID 3/8”connectingnailer with compressor.
Do not connect this tool to a system with maximum potential. Only
disconnect quick connector being connected with the connector of
the body tail portion air inlet, no compressed air can be guaranteed
Disconnect tool from air supply before performing maintenance,
clearingajammed fastener, leaving work area, moving tool to
when disconne cting .
ano ther location, or handing the tool to another person.