StarTech.com UNIDUPDOCK Manuel utilisateur

Manual Revision: 03/29/2011

DE: Bedienungsanleitung - de.startech.com

FR: Guide de l'utilisateur - fr.startech.com

ES: Guía del usuario - es.startech.com

IT: Guida per l'uso - it.startech.com

NL: Gebruiksaanwijzing - nl.startech.com

PT: Guia do usuário - pt.startech.com

For the most up-to-date information, please visit: www.startech.com

UNIDUPDOCK

USB to IDE SATA Standalone Hard Drive Duplicator Dock

FCC Compliance Statement

This equipment has been tested and found to comply with the limits for a Class B digital device,

pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection

against harmful interference in a residential installation. This equipment generates, uses and can

radiate radio frequency energy and, if not installed and used in accordance with the instructions,

may cause harmful interference to radio communications. However, there is no guarantee that

interference will not occur in a particular installation. If this equipment does cause harmful

interference to radio or television reception, which can be determined by turning the equipment

o and on, the user is encouraged to try to correct the interference by one or more of the

following measures:

Reorient or relocate the receiving antenna.

Increase the separation between the equipment and receiver.

Connect the equipment into an outlet on a circuit dierent from that to which the receiver is

connected.

Consult the dealer or an experienced radio/TV technician for help.

Use of Trademarks, Registered Trademarks, and other Protected Names and Symbols

This manual may make reference to trademarks, registered trademarks, and other protected

names and/or symbols of third-party companies not related in any way to StarTech.com.

Where they occur these references are for illustrative purposes only and do not represent an

endorsement of a product or service by StarTech.com, or an endorsement of the product(s) to

which this manual applies by the third-party company in question. Regardless of any direct

acknowledgement elsewhere in the body of this document, StarTech.com hereby acknowledges

that all trademarks, registered trademarks, service marks, and other protected names and/or

symbols contained in this manual and related documents are the property of their respective

holders.

Instruction Manual i

Table of Contents

Introduction........................................................................................................................................................1

Packaging Contents ................................................................................................................................1

System Requirements ............................................................................................................................1

Product View................................................................................................................................................2

Conguration Buttons ...........................................................................................................................2

Installation............................................................................................................................................................3

Hardware Installation..............................................................................................................................3

Driver Installation......................................................................................................................................4

How to Use..........................................................................................................................................................5

Menu Options.............................................................................................................................................5

Advanced Menu Options.....................................................................................................................7

Duplicator (Copy) Mode.......................................................................................................................8

RAID Mode....................................................................................................................................................8

Available RAID Modes............................................................................................................................9

RAID 1 Rebuild............................................................................................................................................9

Specications.....................................................................................................................................................10

Technical Support...........................................................................................................................................11

Warranty Information....................................................................................................................................11

Instruction Manual 1

Introduction

The StarTech.com UNIDUPDOCK functions as both a convenient hard drive copying/imaging

solution and an external USB to SATA/IDE HDD docking station for 2.5”(up to 500Gb) or 3.5”hard

drives (up to 2 TB).

Packaging Contents

• 1 x UNIDUPDOCK duplicator dock

• 1 x USB cable

• 2 x 40-pin IDE ribbon cable (female/female)

• 2 x LP4 molex adapter cable

• 2 x 40 to 44-pin IDE adapter

• 1 x Universal Power Adapter

• 3 x Power Cords (NA/UK/EU)

• 1 x Instruction Manual

System Requirements

2.5” and/or 3.5” SATA and/or IDE hard drive(s)

USB operation: Microsoft®Windows®2000/XP/Vista/7 (32/64-bit),

or Apple® Mac OS®X, or Linux®

Instruction Manual 2

Power connector

ON/OFF switch

USB connector

7+15 SATA

connector

40-pin IDE

connector

LP4 molex

connector

Built-in LCD screen

Conguration buttons

Conguration Buttons

Button Function

Navigate Up

Navigate Down

ENT Enter

ESC Cancel

RESET Reset duplicator dock (soft)

MUTE Mute buzzer sounds

Product View

Instruction Manual 3

Installation

WARNING: Hard drives require careful handling, especially when being transported. If you are

not careful with your hard disk, lost data may result. Always handle your hard drive and storage

device with caution.

Hardware Installation

1. Plug the universal power adapter into a wall power outlet and into the DC In connector on

the duplicator dock.

2. If using a SATA hard drive as the source disk, gently slide the hard drive into the 7+15 SATA

connector labeled Source-1 on the duplicator dock. Skip to step 6.

3. If using an

IDE hard drive as the source disk, connect the IDE ribbon cable (included) to the 40-pin

connector labeled Source-2. The connector is keyed to t only one way.

4. Connect the LP4 molex cable (included) into the 4-pin connector next to the 40-pin IDE

connector. The connector is keyed to t only one way.

5. The jumper settings on IDE hard drives must be set to either ‘master’ or ‘cable select’. Refer

to hard drive manufacture if unsure how to set.

6. Connect the IDE hard drive to the ribbon cable and LP4 molex connector. If connecting a

2.5” IDE hard drive, attach the 40 to 44-pin adapter to the end of the ribbon cable and LP4

cable, then connect the hard drive to the adapter.

NOTE: Only one Source disk and one Destination disk can be installed at a time. Only

connect a SATA or an IDE hard drive, not both.

Instruction Manual 4

7. Follow the same procedure for either a SATA or IDE hard drive for the Destination side of

the duplicator dock.

NOTE: SATA and IDE hard drives can be mixed, so one side can be SATA while the other

is IDE.

8. Slide the power ON/OFF switch on the side of the unit to the ON position, to power up

the unit.

9. Once the unit has booted up, use the conguration buttons and built-in LCD display to

congure and operate the duplicator dock.

10. If using as an external hard drive dock, connect the USB cable from the duplicator dock to

the computer’s USB port.

Instruction Manual 5

Driver Installation

No driver installation is required for any supported operating system, as this hard drive dock is

natively supported, so the drivers are already installed.

How to Use

Menu Options

Copy HDD

• Perform a 1:1 sector clone from the Source disk to the Destination disk. Each disk

sector on the Source disk will be copied, regardless if it contains data or not. If using

a Destination disk larger than the Source, any extra space will be untouched and left

unallocated.

Instruction Manual 6

Compare HDD

• Compares the sectors on the Source disk to the Destination disk. Used to ensure that the

Copy operation was successful.

Pre-scan

• Scans the Source disk for bad sectors/blocks and reports the errors.

Rescan Bus

• Rescans the hard drive connectors on the duplicator dock to detect new/swapped drives.

Source Size

• Displays the total storage capacity of the Source disk.

Setup

System information and settings

• DMA Mode

• Switch between dierent DMA modes, for better compatibility across dierent drives. Will

aect maximum data transfer rates.

Copy Size

• Specify the percentage of the source drive that should be copied.

Startup Menu

• Sets the rst item that should be selected from the main menu on startup.

Auto Compare

• Automatically runs the Compare HDD function after copying. OFF by default.

Copy with Detect

• Automatically rescans the bus before beginning Copy operation. OFF by default.

Button Sound

• Turn audio feedback (beeping) ON/OFF.

Device Info

• Lists disk information about the Source/Destination disks.

System Info

• Lists information about the duplicator, such as rmware version.

USB RAID Mode

• Set the RAID mode for the attached drives when connected to a computer via USB.

Switch between USB and Duplicator modes.

Instruction Manual 7

Advanced Menu Options

The Advanced Menu can be access from the main menu by pressing and holding the <ESC>

button for several seconds.

Rescan Bus Delay

• Sets the time interval delay before starting “Rescan Bus” from the main menu.

Read Error Skip

• Ignore any read errors (sector or block) detected during the copying process. Normally,

read errors result in cancellation of the copying process. OFF by default.

Quick Erase HDD

• Quickly erase all the data on the Source hard drive.

H/W Diagnostic

• Runs though a suite of self diagnostic tests and displays the results.

Load Default

• Resets all settings to factory defaults.

Link Option

• Enable/disable the “USB RAID Mode”option from appearing in the Main Menu.

USB Auto-Link

• Automatically enter USB mode on startup. OFF by default.

Copy HPA

• Copy the Source drive’s Host Protected Area during duplication. OFF by default.

Autres manuels pour UNIDUPDOCK

Table des matières

Autres manuels StarTech.com duplicateur de disques

StarTech.com

StarTech.com 8STUSBDUP15 Manuel utilisateur

StarTech.com

StarTech.com SATDOCK2REU3 Manuel utilisateur

StarTech.com

StarTech.com USBDUP12 Manuel utilisateur

StarTech.com

StarTech.com SATDUP13 Manuel utilisateur

StarTech.com

StarTech.com SATDOCK2REU3 Manuel utilisateur

StarTech.com

StarTech.com SDOCK2U313R Manuel utilisateur

StarTech.com

StarTech.com SATDUPUE Manuel utilisateur

StarTech.com

StarTech.com SATDUP11IMG Manuel utilisateur

StarTech.com

StarTech.com SATDOCK5U3ER Manuel utilisateur

StarTech.com

StarTech.com SU2DUPERA11 Manuel utilisateur

StarTech.com

StarTech.com SM2DUPE11 Manuel utilisateur

StarTech.com

StarTech.com 8STSATDUP11 Manuel utilisateur

StarTech.com

StarTech.com USBDUPE115 Manuel utilisateur

StarTech.com

StarTech.com SATDUP11 Manuel utilisateur

StarTech.com

StarTech.com SATDUP11 Manuel utilisateur

StarTech.com

StarTech.com SATDUP11IMG Manuel utilisateur

Manuels duplicateur de disques populaires d'autres marques

Riso

Riso CV Series Manuel

MicroBoards Technology

MicroBoards Technology GX-2 Manuel utilisateur

Addonics Technologies

Addonics Technologies HDUS325DX Manuel utilisateur

Carry

Carry Pro118 Manuel utilisateur

CopyPro

CopyPro PowerPro II Manuel utilisateur

Primera

Primera Max Manuel utilisateur

Logicube

Logicube EchoPlus-NG Manuel utilisateur

Silca

Silca Delta 2000 SA Manuel utilisateur

Reflex7

Reflex7 Daisy Chain Series Manuel utilisateur

Vinpower Digital

Vinpower Digital SharkCopier DC Manuel utilisateur

Codonics

Codonics Virtua E Manuel utilisateur

Octave

Octave Copy Master II Manuel utilisateur

Kanguru

Kanguru U2-DVDDUPE-S Manuel utilisateur

DUPLO SEIKO CORPORATION

DUPLO SEIKO CORPORATION Duprinter DP-460 Manuel utilisateur

Addonics Technologies

Addonics Technologies UDFH7 Manuel utilisateur

Vinpower Digital

Vinpower Digital MiniLoader VDX-1 Manuel utilisateur

Addonics Technologies

Addonics Technologies CFASTD5 Manuel utilisateur

MicroBoards Technology

MicroBoards Technology Quic Disc QD-2 Manuel utilisateur