-8-
Optional Tone Programming
These sirens can be programmed to produce 6 different tones/sounds by activating
its various functions:
Function Default Tone
Wail Wail
Yelp Yelp
Yelp Step Up Phaser
Manual Ramp Up
Horn Air Horn
Auxiliary Air Horn
Each Function listed above can be programmed for a different tone. If you would
like to change the tone for any of the six functions, follow the instructions below.
1. Power the unit up.
2. Activate the function you wish to change.
• For Wail and Yelp functions, flip the Wail/Yelp switch into the
corresponding position.
• For the Manual, Horn, or AUX functions, press and hold the Manual
button, Horn button, or steering wheel horn, respectively.
• For the Yelp Step Up function, flip the Wail/Yelp switch into the Yelp
position, then press and release the Manual button.
The tone that is currently programmed for that function will sound.
. Press and release the Program button on the
rear of the siren to cycle through the list of
optional tones. Review the chart below for a list
of optional tones.
Program Button
1 WAIL (Wail default) §, *, †
2 YELP (Yelp default) §, *
PHASER (Yelp Step p default)
4 TWO TONE
5 MECHANICAL WAIL
(FIRE ENGINE)
†
7 HOOT
8 RAPID HOOT
9 AIR HORN & YELP
10 GHOST
11 RAPID GHOST
12 SINGLE AIR HORN
1 SINGLE QUICK
14 DOUBLE POST POP AIR HORN
15 TWO TONE AIR HORN
16 STANDARD AIR HORN
Tones For Wail, Yelp, and
Yelp Step-Up Function
§ = SAE approved
* = California Title 13 approved
† = See below
6 MAX YELP §, *
Tones For Manual Button
and AUX terminal
1 STANDARD AIR HORN (A X default)
2 LOW FREQUENCY AIR HORN
RAPID AIR HORN
4 AIR HORN II
5 DOUBLE POST POP AIR HORN
6 SINGLE AIR HORN
7 SINGLE QUICK AIR HORN
8 TWO TONE AIR HORN
9 MANUAL (MN default) *, †
10 MECHANICAL MANUAL
(FIRE ENGINE)
†
Tones for Horn Button
1 STANDARD AIR HORN (default)
2 LOW FREQUENCY AIR HORN
RAPID AIR HORN
4 AIR HORN II
5 DOUBLE POST POP AIR HORN
6 SINGLE AIR HORN
7 SINGLE QUICK AIR HORN
8 TWO TONE AIR HORN
►►►►
System Reset
◄◄◄◄
If you would like to reset all of the siren programming
options to their defaults, activate any tone and press the
Program button for six (6) seconds. The LED will flash
once, then twice, then all siren tones will stop.
Wind Down or Hard Stop Option
By default, the Wail and Manual tones indicated by the “†” above will “wind down”
when they are de-activated. If you prefer to have them immediately stop (i.e. hard
stop), hold the Program Button for seconds (until the LED flashes once). This will
change them to a hard stop. Repeat to change back to the wind down option.
