squarebear tiny plane Manuel utilisateur
tiny plane
PLAY DESK | Assembly Instructions
Thank you for purchasing the TINY PLANE PLAY DESK!
Please take a few minutes to read the instruction sheets carefully. This
will help you to assemble and use the desk properly.
! WARNING: ADULT ASSEMBLY AND SUPERVISION REQUIRED.
Prior to assembly, please read the Important Safety Information section
on the last page.
PATENT-PENDING
WOODEN PARTS
HARDWARE
A
CD
E
FG
H
I
B
22 22 HEX KEY
ASSEMBLY STEPS
STEP 2
INSERT LARGE WASHER
INTO POCKET ON PART A.
STEP 3
INSERT SCREW INTO WASHER
AND TIGHTEN WITH HEX KEY.
ASSEMBLY STEPS
STEP 1
CAREFULLY SLIDE PART A
INTO PART B AS SHOWN.
B
A
ASSEMBLY TIPS
1. WHEN INSTALLING SCREWS WITH HEX KEY, DO NOT
OVER-TIGHTEN. TURN THE SCREW UNTIL JUST SNUG, OTHERWISE
RISK DAMAGING THE PART.
2. IF SCREW RESISTS TIGHTENING, DO NOT FORCE. RATHER, TRY
LOOSENING THE SCREW AND THEN BEGIN TIGHTENING AGAIN.
REPEAT UNTIL THE SCREW EASILY THREADS INTO THE INSERT.
ASSEMBLY STEPS (CONTINUED)
STEP 4
FLIP OVER THE SUB-ASSEMBLY.
WITH TWO SETS OF SCREWS
AND WASHERS, COMPLETE
ATTACHING PART A TO
PART B AS SHOWN.
STEP 5
JOIN PART C TO THE
SUB-ASSEMBLY AS SHOWN.
USING HEX KEY, FASTEN
TOGETHER WITH 2 WASHERS
AND 2 SCREWS.
STEP 6
JOIN PART D TO THE
SUB-ASSEMBLY AS SHOWN.
USING HEX KEY, FASTEN
TOGETHER WITH 2 WASHERS
AND 2 SCREWS.
C
D
ASSEMBLY STEPS (CONTINUED)
STEP 7
JOIN PART I TO THE
SUB-ASSEMBLY AS SHOWN.
USING HEX KEY, FASTEN
TOGETHER WITH 2 WASHERS
AND 2 SCREWS.
STEP 8
JOIN PART H TO THE
SUB-ASSEMBLY AS SHOWN.
USING HEX KEY, FASTEN
TOGETHER WITH 2 WASHERS
AND 2 SCREWS.
STEP 9
JOIN PART E TO THE
SUB-ASSEMBLY AS SHOWN.
USING HEX KEY, FASTEN
TOGETHER WITH 3 WASHERS
AND 3 SCREWS.
H
I
E
ASSEMBLY STEPS (CONTINUED)
STEP 10
COMPLETE ASSEMBLY BY
JOINING PART F AND PART G
TO THE SUB-ASSEMBLY AS SHOWN.
USING HEX KEY, FASTEN
TOGETHER EACH PART WITH 4
WASHERS AND 4 SCREWS.
PLEASE NOTE THAT PART F AND
PART G ARE NOT THE SAME PART.
IMPORTANT SAFETY INFORMATION
WARNING: CHOKING HAZARD DUE TO SMALL PARTS
(ADULT ASSEMBLY REQUIRED)
• THIS PRODUCT IS NOT SUITABLE FOR CHILDREN UNDER 3 YEARS OF AGE.
• UNPACK, ASSEMBLY AND SET UP DESK CAREFULLY.
• NEVER LEAVE UNASSEMBLED PARTS/SCREWS/WASHERS/HEX KEY UNATTENDED
DUE TO POTENTIAL HAZARDS.
• THIS PRODUCT IS DESIGNED FOR CHILDREN 3 TO 8 YEARS OF AGE
AND INTENDED TO BE USED AS A CHILDREN’S DESK.
• THE DESK IS NOT INTENDED TO BE STOOD UPON. SERIOUS INJURY COULD
RESULT FROM STANDING ON THE DESK.
G
F
• NEVER USE THE DESK UNLESS IT IS PROPERLY ASSEMBLED.
• IT IS IMPORTANT TO FREQUENTLY INSPECT THE DESK AND RE-TIGHTEN ANY
LOOSE SCREWS.
MATERIALS IN THIS PRODUCT WERE TESTED FOR LEAD AT A CPSC
APPROVED LABORATORY. TEST RESULTS COMPLY WITH CPSC
PRODUCT SAFETY REGULATIONS: 16 C.F.R. 1303 requirements for lead
and CPSIA Section 101 requirements for lead.
CLEANING AND CARE
•THE DESK IS INTENDED TO BE USED IN INDOORS ONLY.
•USE A DAMP CLOTH OR SPONGE TO SURFACE CLEAN.
•DO NOT SUBMERGE THE WATER.
RETAIN PACKAGING AND THESE INSTRUCTIONS FOR FUTURE REFERENCE.
©SQUARE BEAR KIDS, LLC.
621 23RD AVENUE
TWO HARBORS, MN 55616
www.squarebearkids.com
Small Parts
Choking Hazard
Not recommend for
children under 3 years.
Table des matières
Autres manuels squarebear Mobilier d'intérieur
