7
on walls, since it can cause vibrations and noise. But, if it is t e
only place available, follow t ese suggestions:
- You must ave an iron or steel reinforced structure, Frenc
and type or loafer, duly measured for your appliance, similar
dimensions to t ose for wall installation.
- Avoid all contact of t e appliance wit t e glass panes,
supporting it wit rubber cradles to avoid vibrations and noise.
ELECTRICAL INSTALLATION
1. All t e wiring will ave to comply wit t e local and national codes of electricity and
it will ave to be installed by qualified personnel.
2. T ere must be available an individual derived circuit wit a proper outlet for t e
exclusive operation of t is air conditioning appliance. Consult following table wit information
on t e capacity suggested for t e cables for t e derived circuit.
3. It is essential t at t e outlet plug t at you select matc es t e inlet plug of t e
appliance and it is wit in reac ing distance of t e installed appliance.
NOTE: The inlet cord is 39 inches (991 mm) long and it is at-
tached to the lower part of the command checkerboard. DO NOT
SE a plug adapter nor an extension cord. Check Table 2 for in-
formation on types of plugs and fuses.
4. Comply wit t e fuse type (Table 2) indicated in t e data plate of t e appliance,
located above t e air disc arge.
5. IMPORTANT : T e wires in t e principal cable are arranged according to t e following
colour code:
Green and Yellow: Eart Blue: Neutral Brown: P ase
Since t e colors of t e wires in t e principal cable of t is equipment could not
correspond to t e terminals identifying colours in t e plug, proceed in t e following way:
t e green and yellow wire must be connected to t e terminal in t e plug t at it is labeled
wit t e letter E (Eart ) or by t e eart symbol or coloured green and yellow.
t e blue wire must be connected to t e terminal t at it is labeled wit t e letter N or black
coloured.
