Spireon LoJack ATS200 Manuel utilisateur

Table des matières

Autres manuels Spireon GPS

Spireon

Spireon FleetLocate FL12 Manuel utilisateur

Spireon

Spireon FL18 Manuel utilisateur

Spireon

Spireon GoldStar ATS200 Manuel utilisateur

Spireon

Spireon SkyLink Talon Manuel utilisateur

Spireon

Spireon JG-LS Manuel utilisateur

Spireon

Spireon Flex2PL Manuel utilisateur

Spireon

Spireon FL4 Manuel utilisateur

Spireon

Spireon FL4 Manuel utilisateur

Spireon

Spireon FleetLocate FL1 Manuel utilisateur

Spireon

Spireon JKS3 Manuel utilisateur

Spireon

Spireon Flex2-L Manuel utilisateur

Spireon

Spireon GoldStar ATS300 Manuel utilisateur

Spireon

Spireon FleetLocate FL18 Manuel utilisateur

Spireon

Spireon VehiclePath AT312 TT Manuel utilisateur

Manuels GPS populaires d'autres marques

Raven

Raven Cruizer II Manuel

Hama

Hama 53118 Manuel utilisateur

Garmin

Garmin SOUNDER 125 Manuel utilisateur

Garmin

Garmin DEZL 580 Manuel utilisateur

Jigabot

Jigabot EX Manuel utilisateur

Pointer

Pointer Cellocator CelloTrack XT LTE Guide d'installation

Queclink

Queclink GV55LITE Manuel utilisateur

Voxson

Voxson Voxtrack GPS500 Manuel d'instructions

Garmin

Garmin ECHOMAP PLUS Manuel utilisateur

Starcom Systems

Starcom Systems Kylos Compact Manuel utilisateur

Garmin

Garmin 15 H Series Manuel utilisateur

Cobra

Cobra Marine MC 600Ci Manuel utilisateur

Cellocator

Cellocator CelloTrack T Manuel utilisateur

Enfora

Enfora Mini-MT GSM2228UG001 Manuel utilisateur

Magellan

Magellan eXplorist 100 Manuel utilisateur

LTE

LTE G50B Manuel utilisateur

Garmin

Garmin DEZL OTR500 Manuel utilisateur

SkyGolf

SkyGolf SkyCaddie SG1 Manuel utilisateur

042821

Toll Free Support Phone: 1-877-563-0032

Email: customer_support@spireon.com

GPS DEVICE

INSTALLATION GUIDE

LOJACK ATS200

Powering up the device:

• Locate the physical button located on the top side of the device

• Press and hold the button for 3 to 5 seconds until both Green and Blue LEDs are

• blinking.

LEDs

The ATS200 has two LED indicators

Green LED: indicates cellular connection status

• Blinking: after power up, 1-secont blink to indicate registering on the network

• Blinking: transitioning to 2-secont blink and wait for GPS lock

• O: LED will be turned o after initial event is being sent out

• Blinking: after power up, 1-secont blink to indicate registering on the network

Blue LED: indicates GPS status

• Blinking: after power up, 1-secont blink to indicate acquiring GPS data

• O: LED will be turned o after GPS data is acquired

Diagram / Orientation

Please contact customer service at: Spireon.com

Phone: 877-563-0032 | Email: LoJackDealer@spireon.com ©2021 Spireon, Inc. All rights reserved.

Install Recommendations

ATS200

GPS Device

Install Recommendations

ATS200

GPS Device

Mounting Locations

• The device should be mounted where the front face is facing upwards and locate as high as possible for optimum signal

• The best orientation is the top lid facing upwards

• Some examples:

Behind the knee bolster

Behind the glove box

Under the rear deck above the metal support structure

Mounting Options

• Use the supplied mounting bracket and thread the zip ties through the holes (Shown above) and secure

• into position.

• Use the supplied mounting bracket and ﬁrm mount the device using screws.

• The device should be mounted in a vertical position as high as possible for optimum signal.

• Ensure the device is not mounted below any metal obstructions.

• The device should be mounted away from any moving parts (steering shaft, tilt column, pedals).

Please contact customer service at: Spireon.com

Phone: 877-563-0032 | Email: LoJackDealer@spireon.com ©2021 Spireon, Inc. All rights reserved.