Speco O4B7 Manuel utilisateur

Quick Start Guide

4MP Fixed Lens Bullet IP Camera

O4B7

Version 1.2.0

Welcome

Thank you for purchasing this network camera!

This owner’s manual is designed to be a reference tool for your system.

Please read this manual carefully before operating the unit and retain it for future reference.

Should you require any technical assistance, please contact Speco Technologies Technical Support.

Important Safeguards and Warnings

1．Electrical safety

All installation and operation here should conform to local electrical safety codes.

Use a certified/listed 12VDC Class 2 power supply only.

Please note: Do not connect two power supplying sources to the device at the same time; it may

result in device damage! The product must be grounded to reduce the risk of electric shock.

Improper handling and/or installation could run the risk of fire or electrical shock.

2．Environment

Heavy stress, violent vibration or exposure to water is not allowed during transportation, storage

and installation.

This product should be installed in a cool, dry place away from direct sunlight and heat sources.

Do not install the product in extreme temperature conditions.

Do not expose the camera to electromagnetic radiation. Otherwise it may result in CMOS sensor

failure.

Do not block any ventilation openings.

Do not allow water and liquid intrusion into the camera.

3. Operation and Daily Maintenance

Please shut down the device and then unplug the power cable before you begin any maintenance

work.

Do not touch the CMOS sensor optic component. You can use a blower to clean the dust on the

lens surface.

Always use the dry soft cloth to clean the device. If there is too much dust, use a cloth dampened

with a small quantity of neutral detergent. Finally use the dry cloth to clean the device.

Please use a professional optical cleaning method to clean the enclosure. Improper enclosure

cleaning (such as using cloth) may result in poor IR functionality and/or IR reflection.

The grounding holes of the product are recommended to be grounded to further enhance the

reliability of the camera.

iii

Warning

This camera should be installed by qualified personnel only.

All the examination and repair work should be done by qualified personnel.

Any unauthorized changes or modifications could void the warranty.

Statement

This guide is for reference only.

Product, manuals and specifications may be modified without prior notice. Speco Technologies

reserves the right to modify these without notice and without incurring any obligation.

Speco Technologies is not liable for any loss caused by improper operation.

Note:

Before installation, check the package and make sure that all components are included.

Contact your rep or Speco customer service department immediately if something is broken or

missing in the package.

Accessory Name

Amount

Network Camera Unit

Quick Start Guide

Installation Accessories Bag

Table of Contents

1Physical Specifications .........................................................................................................1

1.1 Device External Cable ......................................................................................................................... 1

1.2 Dimensions......................................................................................................................................... 1

2Device Installation ...............................................................................................................2

3IP Scanner ...........................................................................................................................4

3.1 Operation ........................................................................................................................................... 4

4Web Operation....................................................................................................................5

4.1 Login and Main Interface .................................................................................................................... 5

1Physical Specifications

1.1 Device External Cable

You can refer to the following figure for cable information. See Figure 1-1.

Figure 1-1

Please refer to the following table for detailed information.

No.

Port name

Function description

Ethernet port

Network data in/out and PoE

DC power

jack

Connect to DC 12V power

1.2 Dimensions

Please refer to Figure 1-2 for device dimension.

Figure 1-2

2Device Installation

Note:

Before installation, please make sure the installation surface can support a minimum of

3 times the weight of the camera

Figure 2-1

Please see Figure 2-1 and Figure 2-2.

Step 1

Dig holes on the installation surface (wall or ceiling).

Step 2

Take out the expansion bolts from the accessories bag and insert them into the holes.

Step 3

Take out the installation screws. Tighten the screws to fix the device on the surface. Adjust

the sunshield and tighten the screw.

Step 4

Plug external wiring of the device properly.

Figure 2-2

Step 5

Use the screwdriver (in accessories bag) to loosen adjusting screw.

Step 6

Adjust the device in all possible directions, and set its monitoring direction according to the

requirements.

Step 7

Use the screwdriver to tighten the adjusting screws.

3IP Scanner

IP Scanner can search for the device on the local network.

Please note that only devices that are on the same subnet can be discovered.

3.1 Operation

Open up IP Scanner.

Figure 3-1

In the device list, you can view the IP address, model number, and MAC address of each

device. Select the applicable device and double click to open up the web viewer.

Figure 3-1

4Web Operation

This device supports viewing and management via a web browser on a PC.

4.1 Login and Main Interface

Open the browser and input network camera address in the address bar or double click the

device in IP Scanner. See Figure 4- 1.

Figure 4- 1 IP address

The login interface is shown as below. See Figure 4- 2.

Please input your user name and password.

Default user name is admin and password is 1234.

Note: For security purposes, please change the password after initial login.

Figure 4- 2 Web login

After logging in, follow directions to install applicable plugins.

Input your IP

address here

Table des matières

Autres manuels Speco Caméra de sécurité

Speco

Speco O2VB1 Manuel utilisateur

Speco

Speco ONSIP OPTZ36XO Manuel utilisateur

Speco

Speco O2iD5M Manuel utilisateur

Speco

Speco O8D2M Manuel utilisateur

Speco

Speco HTB11FFi Manuel utilisateur

Speco

Speco RC-650 Manuel du propriétaire

Speco

Speco O8VLB3 Manuel utilisateur

Speco

Speco VLEDT2HG Manuel utilisateur

Speco

Speco O2VLD6 Manuel utilisateur

Speco

Speco CVC-637EX Manuel utilisateur

Speco

Speco ProVideo CVC-724EXTP Manuel utilisateur

Speco

Speco VLEDB2HW Manuel utilisateur

Speco

Speco O8FBMS1 Manuel utilisateur

Speco

Speco HTD10XH Manuel utilisateur

Speco

Speco Intensifier Series Manuel utilisateur

Speco

Speco VL-62 Manuel utilisateur

Speco

Speco O4FB1 Manuel utilisateur

Speco

Speco VL-67 Series Manuel utilisateur

Speco

Speco TC-24/2.9 Manuel utilisateur

Speco

Speco Intensifier IP O2iMD1 Manuel utilisateur

Speco

Speco O8FT1W Manuel utilisateur

Speco

Speco SIPB1 Manuel utilisateur

Speco

Speco O2iMT61 Manuel utilisateur

Speco

Speco ProVideo CVC-7WMTD Manuel utilisateur

Manuels Caméra de sécurité populaires d'autres marques

Okina USA

Okina USA SIR36-870VF650LP Manuel utilisateur

Divio

Divio NDR155PA Manuel utilisateur

Canon

Canon VB-C500D Manuel utilisateur

Easy Access

Easy Access EasyGuard Manuel utilisateur

Vivotek

Vivotek FD9389-EHV-v2 Manuel utilisateur

TUYA

TUYA COSMO W2 Manuel utilisateur

Eusso

Eusso UNC7500-IR Guide de configuration

urmet domus

urmet domus 1096/204 Manuel utilisateur

VC VC20 series Manuel utilisateur

Axis

Axis Q1614 Manuel utilisateur

ieGeek

ieGeek DD201 Manuel utilisateur

VADDIO

VADDIO ClearVIEW HD-USB PTZ 999-6990-000 Manuel utilisateur

Vicon

Vicon V662-D-1 Mode d'emploi

Grundig

Grundig GCH-K0274P Manuel utilisateur

Lorex

Lorex VANTAGE LBC7032 Manuel utilisateur

4xem

4xem WPT Manuel utilisateur

Samsung

Samsung SCV-3082 Manuel utilisateur

Vitek

Vitek VTC-C544 Manuel utilisateur