Seaich Corporation, LLC. All rights reserved. www.seaich.com |Spacerails, LLC. www.spacerails.com Page 3
1PREPARE ARMS
Attach one Arm Holder B on each side
of the Arm Sheath.
Attach one Arm Holder B on each side
of the Arm Sheath. When assembling
shafts F, BC, and BD, slide one
ArmHolder B on shaft and insert one
ArmClip and add the Arm Lock.
BARM B QTY: 56
ARM D QTY: 3
AARM A QTY: 107
Slide Arm Holder B onto
shaft. Insert Arm Lock
through ArmHolder B and
Rail Clip. Turn the Arm Lock
counter-clockwise to secure
the Rail Clip in place. These will
be assembled during the shaft
assembly step to shafts D, E, F,
G, BC and BD.
ARM C QTY: 36
Step 1: Attach one Arm Holder A and one
Arm Holder B with one Arm Sheath. Insert
one Arm Clip into Arm Holder A.
Step 3: Turn the Arm Lock
counter-clockwise to secure
the Arm Clip in place.
Step 2: Insert Arm Lock through
Arm Holder A and Arm Clip.
To avoid damaging parts, do not move or adjust the Rail Clip while locked in the arm. To move the Rail Clip, release
Arm Lock by turning clockwise, position Rail Clip as desired, then secure Arm Lock again.
C
D
Cut two 7.5 cm lengths of rail and insert
into See-Saw as shown using a Rail Clip
to support the ends of the rail.
Attach Arm Holder B to the square receiver side of Arm Sheath
to create the arm. Attach the arm to the shaft and the shaft
to the base prior to attaching the round receiver side of the
ArmSheath to the See-Saw Arm.
SEE-SAW ARM QTY: 1 LEFT & 1 RIGHT
