EA-P3-200 High Frequency RFID Access
Controller Operating Instructions
J-EA-P3-200-M_revB Page 2 of 5
PRN: P2017-2297 (RJH/KAM)
seconds, and again after approximately 10
seconds. This will indicate that the operation has
been completed. Release SW1.
4. Hold down SW1 for 2 seconds. The unit will beep
once. Release SW1.
5. Present a card to be made the “supervisor” card
within 3 seconds.
a. Note: Any card can be promoted to
supervisor by repeating steps 4 and 5.
b. Note: Only one supervisor card may be
active at a time.
c. Note: Supervisor cards cannot be used
to activate the relay.
6. Remove the supervisor card from the reader.
User Card Setup
7. Present the supervisor card to the reader.
8. The green LED will flash, indicating that a “user”
card may be enrolled.
9. After the user card is presented to the reader, the
green LED will go out.
a. Note: No cards may be deleted, other
than by using Step 3.
b. Up to 64 user cards may be enrolled by
repeating steps 7 and 8, after which
performing Step 7 will result in three
short beeps, indicating that no more
cards may be enrolled.
c. Note: Only a user card can be used to
activate the relay.
Timed Mode Use
1. Set the desired relay active time using VR1 (see
illustration below).
a. To access VR1, remove the cover from
the unit using a flathead screwdriver to
pry the cover off.
b. Use a Phillips screwdriver to turn the
dial on VR1 to adjust the relay active
time: clockwise to lengthen the time,
counter-clockwise to shorten the time.
2. When a user card is presented to the reader, the
relay will activate for the time set on VR1, then de-
activate automatically. The unit will beep once
when the relay activates.
1. VR1
CAUTION: The High Frequency RFID Access
Controller PCA is an ESD-sensitive device. Observe ESD
best practices when accessing the PCA to avoid damage to
the PCA.
Latched Mode Use
When a user card is presented to the reader, the relay will
switch state from inactive to active, until a user card is again
presented to the reader. The unit will beep once each time.
Unauthorized Card Use
When an unenrolled card is presented to the unit, the unit
will beep twice, indicating that the card is unenrolled.
