The frame has some grease already in both
races, we recommend adding a small
amount of grease, if possible, to each
bearing. It does not need to be packed full,
just a light coating. (XTR - step not
necessary)
Figure 7 Pre-installed grease
Take the 2nd ball bearing race and install it
into the top bearing race on the frame. (XTR
- step not necessary)
Figure 8 Bearing installed in proper orientation, add more grease if desired
Insert the fork into the frame
Thread on the top adjustable race. This does
not have to be adjusted at this moment,
adjustment will come later. (On XTR models
place the split plastic washer on, with
protrusion facing down toward the frame,
then the aluminum seal with rubber edge)
Figure 9 Headset adjuster installed onto fork, hand tighten
