Sony SA-VE702 Manuel utilisateur

Micro Satellite

System

3-867-384-12(1)

SA-VE705

SA-VE702

Operating Instructions

Mode d’emploi

Owner’s Record

The model and serial numbers are located on the rear of the unit. Record the serial

number in the space provided below. Refer to them whenever you call upon your

Sony dealer regarding this product.

Model No. SA-VE705/VE702 Serial No.

2GB

WARNING

To prevent fire or shock hazard, do not

expose the unit to rain or moisture.

To avoid electrical shock, do not open the cabinet.

Refer servicing to qualified personnel only.

Do not install the appliance in a confined space,

such as a bookcase or built-in cabinet.

NOTICE FOR THE CUSTOMERS IN THE

USA

This symbol is intended to alert the

user to the presence of uninsulated

“dangerous voltage” within the

product’s enclosure that may be of

sufficient magnitude to constitute a

risk of electric shock to persons.

This symbol is intended to alert the

user to the presence of important

operating and maintenance

(servicing) instructions in the

literature accompanying the

appliance.

CAUTION

You are cautioned that any changes or modification

not expressly approved in this manual could void

your authority to operate this equipment.

Note to CATV system installer:

This reminder is provided to call CATV system

installer’s attention to Article 820-40 of the NEC that

provides guidelines for proper grounding and, in

particular, specifies that the cable ground shall be

connected to the grounding system of the building,

as close to the point of cable entry as practical.

NOTICE FOR THE CUSTOMERS IN

CANADA

CAUTION

TO PREVENT ELECTRIC SHOCK, DO NOT USE

THIS POLARIZED AC PLUG WITH AN

EXTENSION CORD, RECEPTACLE OR OTHER

OUTLET UNLESS THE BLADES CAN BE FULLY

INSERTED TO PREVENT BLADE EXPOSURE.

3GB

About this manual

The instructions in this manual are for SA-VE705 and SA-VE702, Sony Micro Satellite Systems.

Differences between the systems

•SA-VE705

The SA-VE705 is 5.1 channel speaker system consisting of two front speakers,

two rear speakers, one center speaker, and one subwoofer. It supports Sony Digital

Cinema Sound, Dolby* Pro Logic, and Dolby Digital (AC-3), and is thus geared

towards the enjoyment of movies.

•SA-VE702

Consisting of two front speakers and one subwoofer, the SA-VE702 is suited for the enjoyment

of music.

* Manufactured under license from Dolby Laboratories Licensing Corporation. DOLBY, the double-D symbol

;, “PRO LOGIC” and “Dolby Digital (AC-3)” are trademarks of Dolby Laboratories Licensing Corporation.

Any difference in operation is clearly indicated in the text, for example, “SA-VE705 only.”

Table of Contents

Hooking up the system ......................... 4

Positioning the speakers........................ 7

Listening to the sound ........................... 9

Adjusting the sound ............................ 10

Precautions ............................................ 11

Troubleshooting ................................... 12

Specifications ........................................ 12

4GB

Hooking up the system

Connect the speaker system to the speaker output terminals of an amplifier.

Make sure power to all components (included the subwoofer) is turned off before starting the

hook-up.

Hookup A (SA-VE705 only)

This configuration is used when the amplifier is connected to a DVD player, LD player, VCR or

other video devices.

eE Ee

Ee Ee

LINE IN

WOOFER OUT

FRONT

CENTER REAR

Attach the satellite speakers (front, rear, and center speakers) to the supplied speaker stands for positioning.

For details, see “Positioning the front (and rear) speakers” on page 7 and “Positioning the center speaker

(SA-VE705 only)” on page 8.

Terminal (jack) connections

Amplifier

Front (Right) Subwoofer Center Front (Left)

Rear (Left)Rear (Right)

loosen

tighten

5GB

Hookup B (SA-VE705 only)

Try this configuration instead of “Hookup A” in the following situations:

— When there are no jacks on the amplifier for a subwoofer.

— When you want stronger bass sound from the subwoofer.

Ee Ee

SPEAKER

IN SPEAKER

OUT

eE Ee

FRONT

CENTER REAR

Ee Ee

Attach the satellite speakers (front, rear, and center speakers) to the supplied speaker stands for positioning.

For details, see “Positioning the front (and rear) speakers” on page 7 and “Positioning the center speaker

(SA-VE705 only)” on page 8.

Terminal connections

continued

Front (Right)

Subwoofer

Center Front (Left)

Rear (Left)Rear (Right)

Amplifier

loosen

tighten

6GB

Hookup C (SA-VE702 only)

This configuration is used when the amplifier is connected to a CD player, MD deck, cassette

deck, or other audio devices.

eE Ee

Ee Ee

FRONT

SPEAKER

IN SPEAKER

OUT

Attach the front speakers to the supplied speaker stands for positioning. For details, see “Positioning the front

(and rear) speakers” on page 7.

Terminal connections

Notes

• Make sure the plus (+) and the minus (–) terminals on the speakers are matched to the corresponding the plus

(+) and the minus (–) terminals on the amplifier.

• Be sure to tighten the screws of the speaker terminals securely since loose screws may become a source of

noise.

• Make sure all connections are firm. Contact between bare speaker wires at the speaker terminals may cause a

short-circuit.

• Do not connect the subwoofer to the amplifier’s CENTER output terminal (which is for Dolby Pro Logic or

Dolby Digital (AC-3)). No bass will output from the subwoofer if you do.

• For details regarding the connections on the amplifier side, refer to the manual that was provided with your

amplifier.

Tip

It is convenient to remember that all striped wires are minus (–) in polarity and should be connected to the

minus (–) speaker terminals.

Hooking up the system (continued)

Front (Right)

Subwoofer

Front (Left)

Amplifier

loosen

tighten

7GB

Positioning the

speakers

Location of each

speaker

*SA-VE705 only

Each speaker should face the listening

position. Better surround effect will result if

all speakers are set at the same distance from

the listening position.

Place the front speakers at a suitable distance

to the left and right of the television.

Place the subwoofer on either side of the

television.

Place the center speaker on the top-center of

the TV set.

The placement of rear speakers greatly

depends on the configuration of the room.

The rear speakers may be placed on both

sides of the listening position Aor behind

the listening position B.

Tips

• Movies are best enjoyed in a room that produces

no echoes (as in one with surrounding curtains).

• Music (especially classical music) is best enjoyed

in a room that produces some echo.

• Adjust the height of the front speakers so that it

corresponds with the center of the TV screen, as

illustrated below.

Positioning the front

(and rear) speakers

Attach the front (and rear) speakers to

supplied speaker stands and place them at

their optimum locations.

For details on the location of the front (and

rear) speakers, see “Location of each speaker”

on this page.

1Detach the plate from the stand.

2Pass the speaker cord into the hole

on the back of the stand and out

from the hole at the center of the

stand.

Center*

Subwoofer

Front

(Right)

Rear*

(Right)

Rear*

(Left)

Front

(Left)

continued

8GB

3Separate the speaker cord, then

secure the cord to the speaker stand

with the plate.

4Connect the speaker cord to the

speaker terminal.

The cord should be pressed into the

groove in the stand.

5Using the supplied hex wrench, two

screws, and washers, secure the

speaker to the stand.

Notes

• Do not remove the supplied speaker grille from

the speaker while attaching the speaker to the

speaker stand.

• Do not touch or press tweeter’s cover on the center

of the speaker.

Positioning the speakers

(continued) Positioning the center

speaker

(SA-VE705 only)

Attach the center speaker to the supplied

speaker stand and place it on a top of the TV

set.

For optimum listening enjoyment, the

speaker should face directly towards the

listener. Adjust the angle of the speaker

stand for that purpose.

1Pass the speaker cord into the hole

on the back of the stand and out

from the hole at the center of the

stand.

2Connect the speaker cord to the

speaker terminal.

9GB

3Using the supplied hex wrench, two

screws, and washers, secure the

speaker to the stand.

Notes

• Do not remove the supplied speaker grille from

the speaker while attaching the speaker to the

speaker stand.

• Do not touch or press tweeter’s cover on the center

of the speaker.

4Adjust the angle of the speaker

stand.

Loosen the two screws under the base to

adjust the angle. Then tighten them

again afterwards.

15º

25º

The optional speaker

stands

For greater flexibility in the positioning of the

speakers, use the optional WS-FV10 (floor

stand), WS-TV10 (TV stand), or WS-WV10

(wall mount bracket) speaker stand (available

only in certain countries).

Listening to the sound

Operation panel on the subwoofer

LEVEL MODE

MIN

ON/

STANDBY

MAX

MOVIE MUSIC

First, turn down the volume on the amplifier.

The volume should be set to minimum before

you begin playing the program source.

1Turn on the amplifier and select the

program source.

2Press !on the subwoofer.

The ON/STANDBY indicator on the

subwoofer lights up green.

3Play the program source.

Power turns on and off

automatically — Auto power on/off function

When the subwoofer is on (i.e, the

ON/STANDBY indicator lights up green)

and there is no signal input for a few minutes,

the ON/STANDBY indicator changes to red

and the subwoofer enters power saving

mode. While in this mode a signal is input to

the subwoofer, the subwoofer automatically

turns on (auto power on/off function).

To turn this feature off, slide the POWER

SAVE switch on the rear panel to OFF.

AUTO

OFF

POWER

SAVE

Note

If you turn down the volume level of the subwoofer

too low, the auto power on/off function may

activate, causing the subwoofer to enter power

saving mode.

ON/STANDBY

indicator

WS-FV10 WS-TV10 WS-WV10

Screws

10GB

Adjusting the sound

Slight adjustments to the system can enhance

your sound enjoyment.

Adjusting the

subwoofer

Operation panel on the subwoofer

LEVEL MODE

MIN

ON/

STANDBY

MAX

MOVIE MUSIC

1Set MODE according to the program

source as follows:

Source MODE

DVD, LD, video cassette MOVIE

or other video source

MD, CD, cassette tape MUSIC

or other audio source

2Rotate LEVEL to adjust the volume.

Set the volume level to suit the program

source.

Notes

• Some amplifier functions for enhancing the sound

may cause distortion in the subwoofer. If such

distortion occurs, turn off those functions.

• To enjoy high-quality sound, do not turn the

subwoofer volume too high.

• To increase the bass sound from the subwoofer,

connect the system using “Hookup B” (see

page 5).

Setting your amplifier

to enjoy movies

(SA-VE705 only)

For the Dolby Digital (AC-3)

If your amplifier is connected internally or

externally with a Dolby Digital (AC-3)

processor, you should use the some setup

menus in the amplifier to specify the

parameters of your speaker system.

See the table below for the proper settings.

For details on the setting procedure, refer to

the manual that was provided with your

amplifier.

When “Hookup A” is used

(Speaker setup menu)

For Set to

Front speakers SMALL

Center speaker SMALL

Rear speakers SMALL

Subwoofer ON (or YES)

(Other setup menu)

Menu Set to

LFE* MIX –10 dB

BASS BOOST** ON

* Low Frequency Effect

**A function that reinforces the bass sound

When “Hookup B” is used

(Speaker setup menu)

For Set to

Front speakers LARGE

Center speaker SMALL

Rear speakers SMALL

Subwoofer OFF (or NO)

(Other setup menu)

Menu Set to

LFE MIX –10 dB

BASS BOOST ON

Autres manuels pour SA-VE702

Ce manuel convient aux modèles suivants

Table des matières

Langues :

Autres manuels Sony Système stéréo

Sony

Sony CDP-XA20ES Manuel utilisateur

Sony

Sony MHC-F150 - Mini Hi Fi System Manuel utilisateur

Sony

Sony SRS-X2 Manuel utilisateur

Sony

Sony CMT-M333NT Manuel utilisateur

Sony

Sony WHG-SLK1i - Audio System Component Guide de configuration

Sony

Sony ZS-PS30CP Manuel utilisateur

Sony

Sony CMT-CP11 Manuel utilisateur

Sony

Sony RDP-X200iPN Manuel utilisateur

Sony

Sony MHC-GX470 - Mini Hi Fi Stereo System Manuel utilisateur

Sony

Sony MHC-C70 Manuel utilisateur

Sony

Sony LBT-V8900S Manuel utilisateur

Sony

Sony SRS-XB2 Manuel utilisateur

Sony

Sony MHC-RG55 Manuel utilisateur

Sony

Sony SRS-XB2 Manuel utilisateur

Sony

Sony ZS-D5 Manuel utilisateur

Sony

Sony ALT-SA32PC Marketing Manuel utilisateur

Sony

Sony MHC-EC55 Manuel utilisateur

Sony

Sony HCD-LV100AV Manuel utilisateur

Sony

Sony HCD-XGV6 Manuel utilisateur

Sony

Sony CDP-X3000 Manuel utilisateur

Sony

Sony HCD-H331 Manuel utilisateur

Sony

Sony MHC-V71D Manuel utilisateur

Sony

Sony MHC-V77W Guide de référence

Sony

Sony MHC-RG270 Manuel utilisateur

Manuels Système stéréo populaires d'autres marques

LG CM3330B Manuel utilisateur

Cetacea Sound

Cetacea Sound CVS-II Manuel utilisateur

Aiwa

Aiwa XR-H66MD Manuel utilisateur

Denon

Denon UCD-250 Manuel utilisateur

Sanyo

Sanyo DC-MX41i Manuel utilisateur

Sharp

Sharp CD-ES600V Manuel utilisateur

Exibel

Exibel BDX600-UK Manuel utilisateur

Sanyo

Sanyo DC-F320 Manuel utilisateur

Philips

Philips FWM583X Manuel utilisateur

Sharp

Sharp CD-C462 Manuel utilisateur

Onkyo

Onkyo CBX 300 - CD / MP3 Clock Radio Manuel utilisateur

Aiwa

Aiwa XR-EM70 Manuel utilisateur

Cyrus

Cyrus Lyric Manuel utilisateur

Philips

Philips MCM159/98 Manuel utilisateur

Philips/Magnavox

Philips/Magnavox Magnavox FW 62C Manuel utilisateur

RCA

RCA RS3965SB Manuel utilisateur

Sharp

Sharp XL-UH240 Manuel utilisateur

Philips

Philips FW 690 Manuel utilisateur